I had to respond because reading the op, brought tear to my eyes. I had a German shepherd that lived to be about 14. She was with me from when my brother died when I was 10 to when I was 22. She was already a couple/few years old, but she was with me through the hardest parts of my life. From when I lost my brother, to when I was an akward teenager, to when I hated the world. She loved me no matter what. When the time came to put her down, I cried and cried and cried. I guess when she passed, it was like my brother was passing all over again. I was living at a place I knew I wasn't going to be at forever, and barely had a place to stay. I didn't want to bury her there, and I didn't think to get her ashes. I was too upset. It took me hours to make a 30 minute drive. Anyways, sounds like Asher is well loved. She was lucky to have found a wonderful family. After my pup passed, I almost immediately got another pup. No to replace moonlight, but to give another pup a home. Oh and it sounds like if Asher is buried deep enough, the chamomile should be ok. I have an avocado planted above the previous owner of the houses dog, buddy. Should be fine.

I always plant a bit shallow in my heavy clay but i mulch a lot never had many issues that i could point to be planted to high a lot of times i plant the plants on little hills so i can slowly fill the beds in with mulch to make them level just like with these trees but on a smaller scale see how high the trees look now i have a nice raised bed - were they planted to high? Yep but now they are just right - I do pretty much the same thing with hostas

You've gotten some good info. I'm not sure if you want the hand held in place of the fixed wall shower head, or in addition to it. So I'll try to describe both. Part One, you just want the handheld on a sliding bar: If you just want the hand held and don't want the shower head that came with the D500058, then you need the Danze D469058 wall outlet. You'll use a short brass nipple to attach the wall outlet to the copper fitting inside the wall. The same type of copper fitting that a typical shower arm would get threaded on to. The nipples are only $1-$2 at any box store. You can buy several of differing lengths (1-1/2" to 2" generally), use the one that fits, and return the others. The length needed depends on how deep the drop-ear fitting is buried in the wall plus how thick your tile backer board and tile are. Brass nipple: 1/2" Drop-ear fitting: Your copper tubing get soldered into the "smooth" opening, the shower arm of the shower head or your brass nipple for the wall outlet get threaded into the threaded end. Use teflon tape of teflon pipe dope on all threaded joints. When you plumb it, have one port from your supply valve go to the tub spout, the other port that would normally feed the shower head will instead be plumbed to the Danze wall outlet. Screw one end of the handheld hose to the wall outlet. Attach the other end of the hose to the handheld. Mount the wall bar on the wall. Attach the handheld to the wall bar. Part two, you want the handheld in addition to the fixed shower head on the wall: You'll still need the Danze D469058 wall outlet. You'll also need a diverter valve. I took a quick look at Danze's offering and only see a 4-port diverter valve. All you actually need is a 3-port valve, but a 4-port can still work and allows you to stay in the Danze family. The Danze 4-port is actually designed to have one if its ports capped if you don't need all three outlet ports, the cap is even supplied with the valve, so they make it easy. If you want to go with a 3-port diverter, pick anything you like. I'll stick with Danze for the description: You'll need the Danze D130000BT diverter valve and the Danze D560858T Parma trim kit to go with it. The installation instructions that come with the diverter valve are pretty self explanatory. However... Your hot and cold water supplies will feed the valve that came with the 500058 kit. That valve has two outlet port. One will go to the tub spout, the other now goes to the inlet of the diverter valve. You'll use the supplied cap to cap one of the three outlet ports on the diverter. One of the uncapped ports will go to the fixed shower head. The other port will go to the Danze wall outlet which in turn will feed the handheld. The Danze 4-port diverter affords you the opportunity to feed just the handheld, just the fixed shower head, or both simultaneously.

when thinking of a multiple thousand dollar new septic drain field.. i surely wouldnt take long for me to cut a 10 dollar plant flush to the ground.. and walk away ... what is your base soil type??? besides the fact.. that you seem to have planted a monoculture.. and when the next juniper plague comes along.. you have the potential to lose them all ... get rid of them.. i know it.. you know it.. there really isnt any real drama involved ... if you plant on coming back often ... add your location on your member's page ... btw.. if you are in snow load area.. sooner or later.. these can run across a bad winter ... and they can splay ... ken https://duckduckgo.com/?q=Blue+Point+Juniper&t=ffcm&ia=web look closely and see how big some of them are https://duckduckgo.com/?q=Blue+Point+Juniper&t=ffcm&iax=1&ia=images