Yeah one finished room. (Of course still full of dust) They finished our bedroom yesterday. Still have to enventually come back and do the closet, but for now have moved on to the great room. camlan..Their doing the same thing here. Running the wood with no seams from room to room. I hope ours eventually "glow" right now they just glow of dust, but it still is looking nice. judydel. I like to buy rugs at TJ Max HomeGoods. Patty Cakes.. Oh no. The stairs is what inspired us to do this hardwood job. We just finished painting the stairs yesterday. The carpet that was on the stairs was old, dirty and ugly. It had to come up. My kids are teenagers, so hopefully safety wont be an issue. We'll see if they become too loud, etc., we can always eventually add a runner to them. beth..Your floors, rugs and house are beautiful. Thanks for sharing the photos and experience. work.. Thanks for the advice. I'll remember this for the near future. Id love a sweeper I could run on the floor and not have to worry about damage.

Definitely choose wood. Vinyls are great, however, for resale value, wood is the absolute best ROI especially for the main living areas. You can choose an engineered or solid- whichever makes most sense. We are able to provide engineered HW that can be sanded and refinished just as many times as solid. If the wear and tear is something you are worried about, consider choose a floor that has a reclaimed look with a strong grain pattern and saw markings that can hide many of the scratches and discrepancies that will happen over time. If that specific design isn't your style, consider a light color floor. Oiled floors are a decent choice because fixing superficial scratches are relatively easy. Oaks are good because of their graining and if kept a light color- will be able to disguise many of the scratches. You can ALWAYS sand and refinish your floors a few years down the line if needed. Plus, when you go to sell and the floors have been lived on- they can be sanded and finished for the new buyer. A vinyl floor will need to be replaced. Hardwood is more expensive at the moment, but they actually end up paying for themselves years down the line with the proper care and maintenance. Or you can choose wood in the dining and great room and a tile in the kitchen. SJ McCarthy has a good recommendation for hickory and oak. Another option is Character Maple(make sure it is hard maple). If you really want to be bold- go for Brazilian Pecan. :)

I too cannot see the savings of remove+replace. A sand/refinish averages $5/sf. It is minimally disruptive (ie. it does NOT involve demolition) and it will cure in 10 days (assuming you are using a high-end water based finish). Now an engineered hardwood is SUPPOSED to be more expensive than solid. Yah. I said it. Engineered (same cut, width, thickness, installation method) should be more expensive than solid. Hmmmmmm. My spidy senses are tingling. Now on to the cost of hardwood upstairs. Carpet removal/disposal = $1.50 - $2/sf (depends on where you live). Repair and prepare the wooden subfloors (usually 'bad' underneath carpet...carpet hides the WORST subfloors) $2-$4/sf. Yep. Just ASSUME you will be spending $3/sf for the subfloor prep upstairs. Now for the cost of solid hardwood (regular 3" width) = $5/sf. Installation + finishing = $3-$4/sf. Right. A regular solid hardwood (nothing special) with install = $8 - $10/sf. Now compare that to a 'sand and refinish' of $5/sf. Wow. It is CHEAPER to do the sand and refinish. Hmmmm. Now imagine the COST of demolition for the HARDWOOD....yep. You can add MORE to that cost. And again the subfloors have to be looked at. More costs. Now imagine the cost of a MORE EXPENSIVE engineered hardwood....$8 - $12/sf for material only. Installation is extra ($3-$4/sf for factory finished hardwood). I tell ya. The $5/sf sand/refinish is looking REALLY GOOD right now. Ignore the width of the planks. They are classic and are probably appropriate for the age of the home. It is your money and your home. If you believe an engineered hardwood is CHEAPER than $5/sf sand and refinish (including install and subfloor preparation) then you are welcome to find out the reality of the situation. We are going to tell you the 'cheap' wide plank engineered hardwood is not going to give you the 'life expectancy' that a 'regular' 3" wide solid hardwood ($5/sf material). It just won't.

If the smell is unbearable after pulling one plank then I will hazard a guess the stain is either rather NEW or it has obtained LONG TERM multiple soaks. Either way, the former homeowner KNOWINGLY covered it up. Here's my issue. The homeowner knew of the damage and, depending on how long ago your purchased the home, could be legally and financially responsible for the 'fix'. I don't know your state nor how long ago you purchased....but talking with your Realtor will help you understand what type of recourse you have. The 'fix' = rip out all the current hardwood to expose the layer underneath. Then you will need to investigate (ie. rip out a few planks in the worst places) to see how much the subfloor is damaged. The possibility of ripping out the old hardwood AND the subfloor is high. And that gets expensive. That's why you want to find out what your recourse is with the purchase and who is responsible for paying for the damage.