47 7/8" is awfully darn close to 48", a standard size. 59 7/8" is awfully darn close to 30" x 2, a standard size. Why not just buy the standards and shave off 1/8" with a table saw? On the 41 7/8" one, can you either widen or narrow the opening by 6" to get it to a standard size? Of course, for that cost, you could probably just buy custom doors. Another thought: take your existing louvered doors, cut out the louvers, then add an 1/8" plywood panel on the back side, turning it into a recessed panel door.

Palimpsest, I contacted Trustile, well I sent them an e-mail and they called me back. I gave the size of the door 36 x 80 and they quoted 3500.00 for a sojgi style door in a paintable wood. She said the Sojgi glass was very expensive and to just use a frosted glass would be 1300.00 I think. Both are way over my budget but thought I would post some prices for others.

kudzu, there are no jambs. The pivot base is screwed right into the top and bottom of the door opening on the problem door; thus into the wood under the drywall at the top, and into the wood floor at the bottom. I just went and checked it. The base is secure top and bottom. It's the metal pivot going into the door that is wobbling. The door starts tilting at the top, where it starts hitting the side of the door opening at the top. When the people installing the doors installed them, I guess they didn't know that a solid door needed more. I ordered the doors custom made so I could stain them to match my kitchen, and they did say they'd never seen anything like them. Last time he replaced them, my husband just went to Menard's and bought them, so I don't know if they were labeled for load capacity. Said if these failed, we were out of options. That's got to be it. Thank you so much for telling me about this! These are just too flimsy for the load of the solid wood oak door we bought. The door is tilting again. What kind of load capacity should I be looking for? Should I just weigh the door when we take it off? Can you get a variety of ones with different loads at a common home improvement store, or is this something I will need to order?

Actually it would open inward flush with shelving in the closet, so it won't cut into closet space. My main concern is losing space in the bedroom when it is open!