Hi, Linda - what is meant by "I have added stones so I am thinking the roots not showing is the problem, I scooped out excess dirt, hopefully this is the cure"? Something is amiss, but with more info from you, we can probably figure out what it is. Adding "stones" to the bottom of a pot might or might not be a bad idea. If the grow medium you're using supports a layer of 100% saturated soil that defies gravity by refusing to exit the pot (a perched water column/ table), stones used as ballast can be your plant's best friend, because the stones displace a volume of medium which would otherwise be saturated with water; however, stones used as a drainage layer serve only to elevate the perched water table's position in the pot. These pots are full of grow medium and the shaded part represents a perched water table (PWT). The maximum ht of the PWT in any given medium that supports PW is a constant, no matter the size or shape of the pot. In the case above, the PWT is 3" tall, and you can see it remains so in all 3 pots. In the middle pot, the water "perches" (like a bird on a wire) just above a 2" drainage layer of small stones, making the distance from the pot bottom to the top of the PWT 5" instead of 3". So this would be one of those EUREKA moments when you might be discovering you've shot yourself in the foot. Large stones would be no different than bricks or empty soda bottles (caps on) and would be considered as ballast as opposed to a drainage layer. Remembering that the ht of a PWT is a constant for a given medium, adding stones as ballast does not raise the ht of the PWT. It simply displaces a fraction of the medium equal to the volume of the item used as ballast, reducing the volume of soil capable of holding perched water. With a bit of planning, ballast can eliminate more than 90% of the medium capable of holding PW. It acts passively and only needs to be done once. In figure D below, an over-turned pot is employed as ballast, and my guess is it would eliminate about 80% of the medium capable of holding perched water in this example. But, back to the original issue. How long have you tended the plant? What do you do insofar as a fertilizer program? Have you ever repotted (includes bare-rooting, root pruning, and a change of soil) or potted up (to a slightly larger pot)? I would suggest you ditch the "moisture meter", which isn't very accurate at all, as it measures electrical conductivity, not moisture. Clean the probe and insert it into a cup of distilled water and watch it read "DRY". Using a wooden "tell" to "tell" you when it's time to water does a much better job. Using a 'tell' Over-watering saps vitality and is one of the most common plant assassins, so learning to avoid it is worth the small effort. Plants make and store their own energy source – photosynthate - (sugar/glucose). Functioning roots need energy to drive their metabolic processes, and in order to get it, they use oxygen to burn (oxidize) their food. From this, we can see that terrestrial plants need plenty of air (oxygen) in the soil to drive root function. Many off-the-shelf soils hold too much water and not enough air to support the kind of root health most growers would like to see; and, a healthy root system is a prerequisite to a healthy plant. Watering in small sips leads to avoid over-watering leads to a residual build-up of dissolved solids (salts) in the soil from tapwater and fertilizer solutions, which limits a plant's ability to absorb water – so watering in sips simply moves us to the other horn of a dilemma. It creates another problem that requires resolution. Better, would be to simply adopt a soil that drains well enough to allow watering to beyond the saturation point, so we're flushing the soil of accumulating dissolved solids whenever we water; this, w/o the plant being forced to pay a tax in the form of reduced vitality, due to prolong periods of soil saturation. Sometimes, though, that's not a course we can immediately steer, which makes controlling how often we water a very important factor. In many cases, we can judge whether or not a planting needs watering by hefting the pot. This is especially true if the pot is made from light material, like plastic, but doesn't work (as) well when the pot is made from heavier material, like clay, or when the size/weight of the pot precludes grabbing it with one hand to judge its weight and gauge the need for water. Fingers stuck an inch or two into the soil work ok for shallow pots, but not for deep pots. Deep pots might have 3 or more inches of soil that feels totally dry, while the lower several inches of the soil is 100% saturated. Obviously, the lack of oxygen in the root zone situation can wreak havoc with root health and cause the loss of a very notable measure of your plant's potential. Inexpensive watering meters don't even measure moisture levels, they measure electrical conductivity. Clean the tip and insert it into a cup of distilled water and witness the fact it reads 'DRY'. One of the most reliable methods of checking a planting's need for water is using a 'tell'. You can use a bamboo skewer in a pinch, but a wooden dowel rod of about 5/16” (75-85mm) would work better. They usually come 48” (120cm) long and can usually be cut in half and serve as a pair. Sharpen all 4 ends in a pencil sharpener and slightly blunt the tip so it's about the diameter of the head on a straight pin. Push the wooden tell deep into the soil. Don't worry, it won't harm the root system. If the plant is quite root-bound, you might need to try several places until you find one where you can push it all the way to the pot's bottom. Leave it a few seconds, then withdraw it and inspect the tip for moisture. For most plantings, withhold water until the tell comes out dry or nearly so. If you see signs of wilting, adjust the interval between waterings so drought stress isn't a recurring issue. Al

Mike.... Try using vinegar at every watering along with a weak solution of fertilizer combined . One capful of vinegar per gallon of water. That should do the trick within weeks if not days:-) Mike

could be iron deficiency. but you should use a higher N fertilizer. Here is a link that might be useful: http://edis.ifas.ufl.edu/ch142

don't just water and water . the plastic bag creates the terrarium and misting very hi humidity - the soil should be just slightly moist, not drenched. usually when bagged the plant needs to be watered slightly may be once a week. if large pot, even less. you need to stick a dowel/long skewer/wooden chopstick,smth long inside deep and then check : if wood is damp most of the way, don't water. even if half way damp - dont' need to water. the roots closer to surface will need some moisture though, so if it's 3/4 dry, you can dribble a little water for the top. otherwise could be fine for like 10 days. just keep misting, but not to dripping point. usually even misting is required may be once in 4-5 days. the bagging and hi humidity raises the temp inside. so if at you have 15C in the room the temp in bag will be a few degrees higher. don't worry about them not getting enough light. you'll need to wait another 2 weeks proly. the roots can take anywhere from 4-8 weeks to form. every 5-6 days remove the bag and let it dry for 30 min. when you see new leaf growth - that means the roots are growing. then remove the bag for half a day each day - for like a week to acclimate the plant to lower humidity. and after that you need another week to slowly start giving it more dappled sunlight. and only after that move it in normal light. same slow acclimation will apply when you move plants outside into sunlight. the first week they need to be in shade, totally out of the sun. if it means just half a day - that's fine too. better to start moving them out when it's overcast for sev days - less hassle.