Kim,,,it's very solid. just make sure the glue is spread to completely cover the plank. I have a few spots (like under the kitchen sink) where they missed the corner and it squeaks. They've held up great. I don't have dogs, but I have cats and have heard their nails burning rubber across the floor they go off on their tangents. I've spilled water, cleaned up their barf, spilled food, whatever, it all cleans up very well. as for dents, only if you drop something very heavy. but any wood floor will dent. I vacuum w/a Dyson, and then I use Bona wood floor cleaner on a mop. in the kitchen, i'll often take the scrubby brush and watered down Dawn to clean up spills or oil stains. no problem. no, I don't baby them. I don't wear shoes in my house though. I love my floors. just make sure on install they clean up all the glue residue. my guys were messy and lazy. had to call them back w/special glue remover and rag and go over the entire floor.

I'm not sure what LVT is. :) I have an appointment with the flooring person for Saturday to test out samples. Cherie, we hate forced hot air because it bothers my and the kids' asthma and allergies so I am actually very happy about these baseboard radiators as radiant heat is much easier on the lungs since it's not blowing hot air all over the place. There is central air for the summer months. We live in Northern NH... it gets cold here for sure. I am going to keep the tile in the kitchen for now and the rest will be new flooring *all going in the same direction* ! We are ripping out the red carpeting, which is in all four bedrooms as well as on the stairs. We want to replace that with flooring and we don't want yet another type of flooring in the house so it makes sense to do the living and dining room as well. When we reconfigure the kitchen, we'll have to match it up and remove the tile at that time.

I don't think the hardwood from today is nearly as good as the hardwood from even a few decades ago. I have small dogs - both less than 20 pounds. But they're young, like to play, and they've left some pretty amazing scratches and skitter marks in the hardwood - in 2 different homes. Yes I keep their nails trimmed, they get a quick dremel every week. The old floors were site finished oak hardwoods. And there were spots where the scratches were getting pretty bad. The one house in question is in a beach town, so between the dogs and the sand, the floors were very scratched up. I deliberately chose a wood look LVP and it's held up incredibly well, but no one will mistake it for site finished hardwood either. I have engineered wood in my primary home - and while they've scratched that up too, it's somewhat less noticeable because it's a matte finish, and it's pre-finished engineered, which I've heard may be somewhat harder.

They did all the appropriate floor prep. Old glue was removed, cement slab was grinder smooth. They checked for level and said my floor was the most flat and level they had ever seen! (A tile installer in another room said the same thing). They didn’t need to add any self leveler compound anywhere, which they said they sometimes do. I believe they did a moisture test, no moisture barrier is installed because where I am engineered wood is glued straight to the slab. Not sure the type of glue but they said it’s the best (yellow stuff), not sure about changing the trowels. Good to know about changing them. But, I have hollow spots in the first rows they laid. They are telling me a possible reason is because these were thicker and wider boards which make it harder to make good contact…I am considering contacting the manufacturer, but don’t want to make a mess of my floors if there will be no benefit for me (compensation, redoing my floors, etc) but not sure they would do anything for my benefit…