When I had the shower door guy out to measure, he made a point of checking how high the shower head was. Ours is on a sliding bar, so it can go up pretty high. We have a 6" curb and a 6' shower wall/door height, and it is fine with our standard 8' ceiling. Our "gap" is 18". Remember also that this "gap" benefits the air circulation in your shower to help dry it out so that you don't get moldy grout. Unless you have a very high shower head (very tall shower user) you should be fine.

http://www.showerdoorseal.org/newimages/shower%20door%20sweep%20009%20app.jpg Try a deflector. Your door might be to close to the curb. Even a curb that is sloped the right way will leak in both directions if the water beads off the curb and the door's bottom. Deflectors work great.

Phylhl, your shower is beautiful! Kmcg, very true cost is a factor:) Our contractor hired a sub to install a frameless enclosure & one of the only things we requested in the design was that they cut around our marble chair rail that runs through bath & shower - well, apparently they didnt listen and upon install they not only cut our tile on the wall but they cut a notch in our marble tub surround that also juts into the shower. The notch was not something that was discussed when we discussed the design. Needless to say we are very unhappy with the installation. There are multiple other problems as well - door appears warped, leaking at clip, door leaks(no space for sweep left under door), mitered corner leaks, chip in top of door, VERY sloppy silicone....the list goes on. These are the things we have found & the installer admits there are more problems we havent noticed. Also admits to lack of communication before & during install. We are going to ask that they take down glass, have tile replaced as well as the marble notch be filled in & reinstall new enclosure with cuts around tile & marble. My faith in the company is not that great now but I think the right thing to do is allow them to try & fix it. UGH! To make matters worse our contractor isnt being very supportive - glass people long time family friends. Cant believe our complaints! Good thing we are almost finished & he will not get final payment until we are satisified. Curious to see if we are expecting too much from the installer/owner.

I have a framless shower door with steam. I had a chanel carved into the stone frame around the door. I bet you won't pass inspection. This doesn't sound kosher. Did you discuss ahead of time how this was to be done? What material is around the glass? What's to keep the glass from moving if someone leans on it, silicone? I'll bet the contractor tries to tell you that it just fine. If you find out if it's against building codes, then you could have an inteligent argument with him. Ill tell you some of the problems that I had with my installation. The stone I used is "Rosa Verona". It's a particularly soft stone. The company that installled the stone said that it broke during delvery 2 times before they were able to install it. It finally worked out ok. I went with a glass company in the area that is the oldest and has the highest prices in the area. They came to measure when I had the three sides up (the groved stone). The tile setter purposly left the top, untiled. They inisted that all sides be done before they measure. My tile setter scrached his head, but they were very experienced and wouldn't be questioned. When they came back after the top was tiled, they realized that they had no way of getting the glass in. I finaly had to have someone carve out the tile on the top in order to insert the glass. It would have been SO much easier to just tile up to the glass on the top after it was slipped into the groves on the sides.