From this angle 3&4. Can you move them to the left?

That's a schluter edge. Nice they did that...but they sure did a messy job. Same thing happened with my back splash. They tried to "clean it up" which helped some, but still doesn't look professional. I would have the gc look at it. Ask him "does this look like the kind of work you expect to see in a (whatever price) custom home? If I review you on Houzz you want me to post these pictures?" That should get you some kind of answer... Good luck!

lmao. what Jan said! Although, I had to help out my guys who did my herringbone wood floor. it's the starting point where everyone gets messed up. after that, it's simple. Look up how to properly start a herringbone layout and read it. you need to use a speed square at the end of your tile in order to get the proper middle starting point. much easier to illustrate than trying to write it out here. This is how I showed my guys how to start it. see the blue tape w/the two lines? you have to start on the middle after you mark your corner. that's the only way you will get perfect even cuts on both ends. this is how most do it, and it's not correct IF you want perfectly symmetrical left/right borders. All he's done is set the corner of the tile on the line. doing it like this will leave you w/one side smaller than the other: see how the sides of the window don't match? this is what you don't want. your tile guy should be doing a dry layout in order to determine where he starts so he doesn't get this look or these tiny triangles. Again,,,see how the ends don't match below? the right has longer tiles than the left edge. that's because of the way he started his first tile. And don't do these vertical tiles for your edging. get proper bullnose tiles, pencil liner or a Schluter edge. This is a layout board of my herringbone for my shower. took a few hours in order to get this almost perfect. since this was an odd size, and the tiles were even at 3x12, it couldn't be perfect. the right bottom corner triangle is the only portion that doesn't match. luckily, it's not readily visible! Even the subway tiles are perfectly matched. this layout took hours to get exact, even around the niche. 2x6your 3x9 will be 1/3 larger. 3x9 is a good size for a backsplash. this is a regular 3x6. again, a 3x9 will give you 1/3 longer.

Our kitchen backsplash is a 4 by 12 with a thickness of 3/8" ceramic white glossy tile. We are going with a white grout called avalanch. Our struggle now is with what material, size and color of schluter would work well. Attached are what we are considering.