Lucie, my sink is an older model of yours. The colanders and cutting boards have been used once or twice and are now in the garage. I love the deep sink for washing large pans. I have only had 2 bowl sinks before this, and I will never go back to 2 bowls. However, with our garbage disposal sitting underneath the sink drain, that leaves just 5-6" to get around it to fix any plumbing. My husband can't get inside the sink cabinet to replace washers or repair faucets. Make sure your sink cabinet doesn't have the divider piece between the two doors. (Stylus? I don't remember what it's called.) I think because your drain is off to one side, you will not have the garbage disposal problem. We raised our countertops 4-5 inches, and we still have problems. Even without a garbage disposal, you will have to reach around the deep sink in the back, then up to the underside of the countertops to repair or replace anything. We have to hire people to do anything because my husband's back won't let him bend like that to lay inside the cabinet. Plus, you can't see what you are doing. 19" reaching back, then 10" reaching up to the underside of the countertop to unscrew the faucet, air switch, or soap dispenser connections is not easy unless you are young and bendable with long arms. Your sink is 19" front to back, but only 14.5" in the interior. Make sure your largest hand wash item will fit. My Ruvati center drain sink did not drain well. They had the channels/bends like yours, but the angle was not enough to fully drain like the slope on a cast iron sink. They could have changed that problem though. Cleaning: the square corners, edges, and angles are a pain to clean. I use an old toothbrush. Bleach will leave black spots on the sink if it splashes and you don't rinse it off. It is hard to notice that you splashed bleach until it is too late. Faucets: search Houzz for pull out vs pull down faucets since your sink is narrow front to back and deep. Our arched, pull down sprayer/faucet splashes everywhere unless we pull it down and let it hang 4-6" down hoping it will splash inside the sink. I am constantly drying the faucets, countertops, soap dispenser, and backsplash because other people don't pull the faucet down. It is a long way from the faucet to the item you are rinsing in the sink. With your narrow sink you will have to be careful that your faucet doesn't stick out too far which is why we chose an arched faucet that splashes. Doing it again: I would probably choose a sink without the square edges and corners to clean. I would choose more rounded edges and I would get a better slope in the drain. I would never go back to 2 bowl and would always have a deep sink. It is tough to find a perfect sink though with all of your requirements.

I hear good things about Ruvati sinks. However the configuration you show has a bowl that is so small to be almost useless. I only like 2-bowl sinks when you can have a 36” width. Smaller than that, you will have one of the bowls, and sometimes both bowls, too small to be useful. In that case l‘d get a single bowl sink. It’s both a more current look, and you will enjoy it more than banging up against a divider. If you must have a double-bowl sink, I’ll link to a more roomy sink that is in the same 33” size as in your OP. I am also linking a single bowl sink that would be a good option. Kraus is very popular on this forum with a lot of good feedback on them. https://www.amazon.com/Kraus-Standart-Undermount-Stainless-KHU103-33/dp/B0032C411C/ref=mp_s_a_1_3?ie=UTF8&qid=1548954063&sr=8-3&pi=AC_SX236_SY340_QL65&keywords=kraus+khu103-33&dpPl=1&dpID=51fVm80FjFL&ref=plSrch https://www.amazon.com/Kraus-Standart-Undermount-Stainless-KHU100-32/dp/B0032C5YGI/ref=mp_s_a_1_3?ie=UTF8&qid=1548954214&sr=8-3&pi=AC_SX236_SY340_QL65&keywords=kraus+khu100-32&dpPl=1&dpID=51oOF%2BW8OPL&ref=plSrch

This is a great thread. We have a smallish kitchen we are now remodeling and I am looking at the Kraus and Franke undercount sinks. I like that the Kraus single bowl comes with accessories such as the dish dryer and cutting board. The Franke single bowl stainless I am considering has the grate insert that can be moved from side to side. For my small to mid size kitchen would the 28 inch Franke sink be sufficient? Or the 31 inch better? We need to conserve counter space that is for certain! Any other opinions on these brands and accessories?

After getting the sink installed I'm regretting not purchasing a self-trimming apron front sink instead. When the contractors cut the cabinet, it left a small gap around the sink edges (and a few chips too). The contractor says they'll cover it with scribe molding so you won't see it, and hopefully that will resolve the issue. Wonder if other folks here with this sink or similar ones have had the same issue? Video showing the gaps around the sink here: https://1drv.ms/v/s!AmD8KjGtqRzxjohVhtoxF_BKmAksdQ?e=N315sO