Can I use drywall compound over wood lath to patch a plaster wall?
rochesterroseman
7 years ago
Featured Answer
Sort by:Oldest
Comments (13)
Related Discussions
Can I skim coat with success my new bathroom drywall and plaster?
Comments (4)GreenDesigns, thanks for your input. I am not plastering, just skim coating a thin joint compound over the entire drywall surface to even out the contrasting textures between the dry wall paper and the smoother areas of joint compound at the seams and at the screw sites. Maybe "skim coat" is the wrong term, or used loosely in this application. I have read multiple opinions on the use of moisture resistant wall boards. Opinions are very divided. I was miss leading in my OP in that this is a moist room, as this room has never gotten steamy in the 22 years we've lived here and there was no fan. There is no shower, just a tub. But, because this is a bathroom I can assume there is more moister than, say, the living room. What I have read regarding regular drywall is that if it is used in the non wet areas of the bathroom it really is more important to have a proper primer and paint installation to protect the wall system. When my kitchen was done last year the drywallers did skim coat my walls, I just wasn't there to see how they did it. I have watched the USG video and it is straight forward enough. I have attached a link below. Lastly, to provide some context, this room is not our main bath, that is why there is no shower. This bathroom is next to my kitchen. The bathroom is really a combo utility room/bathroom for our farm house. Here is a link that might be useful: US Gypsum video on level 5 finish....See MoreHow to cut through studs on a lathe and plaster wall?
Comments (6)Thanks! I thought about trying to shave the cabinet, but it only has thin plywood sides to start with so was worried about doing damage there. The block is basically just a piece of wood (probably the piece of stud that was cut out) nailed to a horizontal 2x4 that is in turn nailed to the remaining studs. It formed the left edge of the original cabinet. We could also take it out and just move it, but the lathe is nailed to it so that seemed to have the potential to do a lot more plaster damage. (We have a clear inch on both the block and the stud that could be shaved with no impact to lathe, probably because of the way the original cabinet was set in place.) The plywood stabilizer is a great idea, though--thanks!...See MorePatching deep holes in plaster over brick
Comments (11)Hardness in this case does not matter much. Durabond is un-sandable (if you try you will damage the wall around the bulge you are trying to sand away) for all intents and purposes. Just like plaster. Real plaster was NOT sanded for flatness. It was tooled before it finished setting. When partially set water is splashed n the surface (often using an 8 inch paint brush to splatter it on) and then a steel trowel used to put the final surface polish on the plaster. Easysand should be fine for a small patch not subject to damage....See MorePlaster walls in old bungalow—can large holes be patched?
Comments (26)If it were me, I would go low impact. You're not crazy. The charm of an old house is that it doesn't look like a new house. You just have to make your own call as to where the line is between "old house charm" and jankiness. A good floor guy can do magic to patch a floor. We have a large patched area which is invisible in our kitchen. Can you buy reclaimed flooring to match what you have from anywhere locally to use for patching, or can you salvage any flooring from any of the other work you're doing on the house? You might need to do some legwork but in most areas with a lot of old homes, there is someone. Another note...you absolutely do not need to tear out the old plaster to rewire if that is a concern. We just had our entire 1914 bungalow rewired, and in many places brought up to code, as part of a larger project. Basically the only holes to patch are where the old outlets and switches used to be, if we are not reusing them. They dropped in the new wires and left the old ones disconnected but still inside the walls. There are other reasons you might want to open up the walls, like if you want to add insulation inside the wall cavities (because of the need to install a vapor barrier, not bc of the wires), but a good electrician would not suggest it just for wiring. The vast majority of the plastering we had done was from reconfiguring the floor plan and moving our upstairs ceiling up 7". You can see the latter below. The texture of our old horsehair plaster (rough surface) does not quite match the new, but we don't expect that to be an issue once it's prepped and painted. I'm sure the availability and cost of doing blueboard and plaster varies by location, but here in Boston it is fairly standard....See Moredaveho
7 years agorochesterroseman
7 years agoUser
7 years agoBruce in Northern Virginia
7 years agoJoseph Corlett, LLC
7 years agoakamainegrower
7 years agoVith
7 years agoUser
7 years ago
Related Stories
HOUSEKEEPINGQuick Fix: How to Patch a Drywall Hole
Dents and dings disappear, leaving your walls looking brand new, with this fix that even a novice can do
Full StoryMATERIALSRaw Materials Revealed: Drywall Basics
Learn about the different sizes and types of this construction material for walls, plus which kinds work best for which rooms
Full StoryWALL TREATMENTSSurface Smarts: Venetian Plaster
Centuries-old Venetian plaster has made a roaring comeback in modern interiors. Could this old-world wall favorite work in your home?
Full StoryWALL TREATMENTS11 Ways to Roll With Wallpaper All Over the Home
Ditch the misconceptions and latch on to some great ideas for decorating your walls with patterned, textural and colorful wallpaper
Full StoryREMODELING GUIDESCan You Handle That Fixer-Upper?
Learn from homeowners who bought into major renovation projects to see if one is right for you
Full StoryBATHROOM MAKEOVERSMini Bathroom Makeovers You Can Conquer in a Weekend
Perk up your tired-looking bathroom with these simple styling tricks
Full StoryREMODELING GUIDESTongue and Groove Wall Paneling Joins the Comeback Club
Try this smooth architectural move to give your walls a streamlined appearance that conveys quality
Full StoryHOUZZ TOURSHouzz TV: See How Reclaimed Wood Warms a Home With a James Brown Wall
L.A. homeowners craft their interiors with salvaged wood and build a tribute to the Godfather of Soul with cassette tapes
Full StoryPAINTINGKnotty to Nice: Painted Wood Paneling Lightens a Room's Look
Children ran from the scary dark walls in this spare room, but white paint and new flooring put fears and style travesties to rest
Full StoryDECORATING GUIDESDesign Debate: Should You Ever Paint a Wood Ceiling White?
In week 2 of our debate series, designers go head to head over how classic wood ceilings should be handled in modern times
Full Story
hcbm