Just an afterthought. concerning leveling, if you are using pedestals.... When the Home Depot guys off loaded the washer and pedestal, they married the two out in the street before bringing it into the house. I watched everything they did (and didn't) do. The two pieces get married with these brackets on the sides that both screw and glue together. They just slapped the two units together, not paying any attention to the leveling legs that were on the bottom of the washer, now resting on the top of the pedestal. Who knows what position they were in, after coming all the way from Asia. What I found out later, was that these leveling legs do influence the vibration coming off the machine. Even if you get the complete unit level, you can still have some vibration problems if the leveling legs on the washer were wacked when they put the two together. Unfortunately, the glue they use for the brackets is fairly permanent, and hard to make changes after the fact. I would probably suggest that the legs on the washer be put all the way in prior to joining the pieces together; or, level the pedestal, put the washer on top, level that, and then put the joining brackets on. I love Home Depot, but they really should get better-than-minimum-wage contractors to do these installs. Good luck.

My bosch dryer will not turn on. Time displays 000. Start/Stop light indicator does not light. Lint trap light flashes. Wringle blcok/finished indicator lights. HELP. I have tried everything in the manual. Unplug for 30 minutes to cool (we had not used it that day so it was not hot) and restart. Vacuum lint trap, cleaned moisture sensor, and exhaust. Any suggestions would be appreciated. Thanks.

It would probably be best to go ahead and get service out to check it. It might be nothing,but to be on the safe side I would go ahead and have it checked before it has a chance to damage something in case there is a defective part.

. . Bosch nexxt gas dryer - error code e-01 ,,,, E-01 saying - clean lint filter ........... our dryer kept buzzing .. no matter what we tried . we over cleaned lint filter in sink with soap and tooth brush and had company come in and clean duct inside wall . nothing worked. * so we took dryer apart and discovered the dryer blower squirrel cage down stream / past the lint trap ..... was completely blocked/clogged from a bad Bosch design in the dryer tub.. itself inside dryer , on the right hand side far right last 2 inches ....when you look inside dryer....... the plastic vent leading to lint filter trap --- allows large amounts of lint to bypass the filter screen itself and this leads to the squirrel cage pulling the wet lint into the impeller blades ... lots of lint... (that should have been caught by filter ) too much lint which clogged blower and the dryer would no longer work correctly . ( blower could not create any air discharge pressure at all ) causing error code ) once we took the entire dryer part and cleaned the blower box and impeller blades . the dryer now works like new again and no more annoying lint error code noisy buzzer .. ...a bad Bosch design allows lint to bypass trap. so it will eventually need to be done again. this amount of lint in the blower motor ... prevents dryer from functioning normally