SHOP PRODUCTS
Houzz Logo Print
archangel2003

Keeping the tredal cabinet, swapping the machine (does not fit)

archangel2003
9 years ago

We have an Eldredge treadle machine and it's rusty but not too bad.
The problem is that my daughter prefers her shuttle bobbin machine and it does not fit the hole the machine sits in, and the pins (too large) are also too close together.
I was going to pull off the top piece that pivots down and make a replacement to fit the other sewing machine.
The only issue is that other than tearing the whole thing apart, I can not see how the hinge comes off.
If I could remove the raised top, I could get to the screws on the side, but I can't see how that is attached either.

I'd rather not tear it all the way down, and would rather save the original pivot board.
The one pictured looks just like hers only nicer looking.

Anyone tear a treadal machine apart to refinish it?

Comments (3)

Sponsored
Davidson Builders
Average rating: 5 out of 5 stars1 Review
Franklin County's Full-Scale General Contractor