skip to main content

Shower floor just installed, grout looks soaked/wet all the time?

14 years ago

We just had our master bathroom remodelled with a porcelain tile and the white grout on the shower floor. We used our shower for four days, when there was a crack in one of the grout lines. We stopped using it so that the contractor could come back out. I then noticed that the grout on the shower floor still looked soaked/wet, and four days later it still does. I even tried putting a space heater in there for about 6 hours last night and it didn't help that much.

My contractor says that it's normal? Still looking soaked and wet is normal after four days? Did they not properly seal the grout? Is the shower pan not draining properly?

Any insight would be much appreciated.

Thank you!!

Sort by:Oldest

Comments (5)

bill_vincent
14 years ago
You pan's holding water. I'll guarantee you that's what it is. Let me ask you-- your shower pan-- is it copper under the mortar?
keugenes
Original Author
14 years ago
I don't think it's copper, we had it contracted out. They said there's a pan and weep holes. How long should the grout look wet if built properly? A few hours, a day, etc?
Related Discussions
glass tile on new shower floor looks dark/blotchy when wet
Q
Comments (18)
Thank you very much mongoct. This is very helpful. I took these pictures before you post, borrowing the glass guy's leveler. We didnt know what to look for as far as depth is concerned. It does not look like enough, does it? I believe the shower is 5 ft. long. When he comes back with his leveler, we'll measure the drop. On a side note, the installer had set the valves too low for hot water. He came over to adjust them. In another shower (he did two), the water was pooling at one end. The installer said that wasnt right and that he would fix it. On the above shower, I pointed the sh. head towards the wall, and the water drained some, but not all of it...maybe an 1/8" sat there. I had to push it into the drain. Now I am worried this guy is incompetent. How hard are these things to fix? He was recommended by the architect and does multimillion dollar homes!
...See More
Shower stone tiles & grout remain wet/dark
Q
Comments (3)
Do I understand correctly that to inspect/unplug weepholes, we will have to remove the stone around the drain? Is there any hope of doing that without destroying it? How do we unplug the weepholes? Are there any special tools required? It CAN be done, even as a DIY task. You need to cut the grout joints around the tiles you're going to remove, and then use a hammer and chisel. once you have the tiles out, you need to be very careful not to damage the pan membrane. All it takes is a pin prick, and the whole thing is coming out. Once you clear the weepholes, though, you need to tape them off and water test it before you put it all back together to make sure it's still watertight.
...See More
wet bed floor got 'showered' during installation - is this a prob
Q
Comments (3)
Hi Bill, Thanks for your feedback. However, I think you are under the impression that this happened in a finished bathroom because you mentioned the cracking grout. This is a very shell of a bathroom with only the 2x4 frame up, the plywood floor down, and the wetbed just set. There's no grout or tile in it yet, not even walls for that matter. And does this info affect your advice to "tap the shower floor"? If so, what does it mean to tap the floor? Thanks again, Poodledo
...See More
Grout stays wet hours after shower
Q
Comments (11)
Regardless of the issue of it staying wet, that should be caulk (100% silicone) and not grout as all changes of plane need to be. As Mongo states it could be the last bit os not picthed properly and water sits there. And sealing the grout will not make it waterproof its sole purpose is to slow the possible absortion of stains.
...See More
bill_vincent
14 years ago
20 minutes to half hour, max.

Whoever you asked knew exactly why you were asking about the copper. (most copper pans, in addition to being flat bottomed, don't have weepholes, either)

However, I'd bet those weepholes are clogged, and it's probably a pretty safe bet that the pan membrane isn't sloped either. I'm not talking the finished slope directly under the tile. I'm talking about what's called a "preslope" under the pan membrane. One way or the other, at the very least about 8" to a foot all the way around the drain will have to be removed and the weepholes cleared to fix the problem. Tell your guy this time to put gravel over the weepholes before he muds them back in.
keugenes
Original Author
14 years ago
Here's my latest response from my GC on how the shower was installed and his thoughts on fixing the project.

==========================
The Shower pan was installed with a pre-slope. A positive weep hole protector was used during installation. The waterproofing system is a 30 mil pan liner that extends up the walls 18" on all sides.

I did ask the tile installer about the typical time for a shower pan to dry out, 24 hours is not unreasonable, but 5 days is not typical. If the discoloration is caused by persistent moisture there is something not functioning properly. That being said, he is very confident in the installation of the pan liner and was personally on site while the work was being completed. He feels the discoloration is likely not related to the Pan holding water. However, we will reserve judgment until we have had a chance to inspect the shower together.

"Assuming" we do not have a problem with the pan draining. One Idea our tile installer offered would be to replace the grout in the floor with an epoxy grout. Epoxy grout is going to discolor less with moisture, if we remove all of the existing grout on the floor we should get a more consistent color when we regrout, and epoxy grout will allow less water to penetrate through the finished surface to the pan liner. Of course, first we have to be sure that everything is working as designed.
======================
bill_vincent
14 years ago
Maybe 24 hours for the pan. Even at that, I'm skeptical. But the grout should be dry inside a half hour.

He feels the discoloration is likely not related to the Pan holding water.

Well, we all know I don't know everything (although I like to THINK I do!), but I can't think of another reason the grout would stay wet.

One other thing-- If you're going to carve out that grout and regrout with epoxy, make sure that pan is bone dry first. Otherwise you're going to have problems with the epoxy bonding to the tile and to the mud underneath.

Related Stories

HOUSEKEEPING How to Clean Grout — Stains and All

If your grout is grossing you out, this deep-cleaning method will help it look new again

TILE 3 Key Steps for Grouting That Looks Its Best

By By Any Design Ltd.

Get your grout right to keep your tile beautiful and for an installation that will last

BATHROOM DESIGN Should You Install a Urinal at Home?

By MyFixitUpLife show

Wall-mounted pit stops are handy in more than just man caves — and they can look better than you might think

TILE Epoxy vs. Cement Grout — What's the Difference?

By By Any Design Ltd.

Grout is grout, right? Nope. Cement and epoxy versions have different appearances, durability and rules of installation

BATHROOM DESIGN Convert Your Tub Space Into a Shower — the Tiling and Grouting Phase

By By Any Design Ltd.

Step 3 in swapping your tub for a sleek new shower: Pick the right tile and test it out, then choose your grout color and type

BATHROOM TILE Quick Fix: Repair Cracked Bathroom Grout

Banish an eyesore and safeguard your bathroom from water damage in 30 minutes or less with this DIY repair

REMODELING GUIDES 9 Ways Grout–Yes, Grout–Can Add to Your Design

Choose From a Palette of Grout Colors for a Warm, Unified Look

SHOWERS Get Steamy in the Shower for Spa Time at Home

By By Any Design Ltd.

Learn the components of a steam shower to plan a safe and sturdy installation and a soothing bath experience

BATHTUBS 10 Japanese Soaking Tubs for Bathing Bliss

By Samantha Schoech

Get all of the serenity with none of the chemicals in an original all-natural hot tub

KITCHEN BACKSPLASHES How to Install a Tile Backsplash

If you've got a steady hand, a few easy-to-find supplies and patience, you can install a tile backsplash in a kitchen or bathroom

Sponsored

More Discussions

Any photos of Daltile Valor Gold Quartz

4

why does my perimeter grout in new shower look darker?

5

bathroom remodel fan placement

0

Is it possible to change a color of a granite countertop

2

Any ideas on how to remodel our master bathroom?

5