No need to take an XL12 apart to replace a fuel line, it is not attached to the inside of the tank. Fish the tank filter out and remove it, pull the line out of the tank and carb box. Here's an online source for Homey IPLs, you'll need your UT #. If your UT is gone look at UT-10080. Here is a link that might be useful: Homelite Parts Lists

Same as other thread you posted on . Chainsawr Site is you best bet.

Rock: While your at it get the diaphram kit , it is not much of a $$ adder. A weak diaphram can cause poor performance also . Older saws with a little dirt or varnish along with a weak diaophram will cause a lot of headaches. Ensure to check all your fuel lines for tightness a small air leak can cause serious damage long term. Also as previously suggested , ensure your fuel filter has no restriction you should be able to blow through it . If all is good then just a jet orifice cleaning with a concentrated fuel cleaner should get you going :)

Where can i get good info. about repairing my xl 12 chainsaw?? My good neighbor gave me a a homelite xl 12 chainsaw. It appears the saw hasn't been used much. When it was given to me, the starter rope could not be pulled. The flywheel would hang on something. Finally saw a bolt has worked loose and was catching the flywheel. Popped the flywheel off and tightened the bolt. The compression is very good. I do need to replace the gas line for sure. I'm not getting any fire to the spark plug. NOt sure if its the coil or points and condensor. Any advice on this???? Plus, how do i get to the points. sorry, just couldn't figure it out. Thanks, glen