Thanks for posting this. We just re-worked our family room orientation and positioning of our patio door and some windows on our house plans. Your photos helped me visualize what we are trying to achieve. We're looking at adding a window on each side of our patio door that will be in our dining area. I like the looks of yours. Do you mind sharing the dimensions of the windows on each side of your door and those on each side of the fireplace? Thanks!

Gary - no, the 700 series didn't doesn't have "gills" at all. It's systems are down in the bottom of the unit and are completely covered by cabinetry toekick and / or the bottom drawer panel. It was the first unit to be TOTALLY concealed ( no trim, no fins, no gaskets showing ) and is for the most part unchanged since it's rollout in the LATE 90's !!!! - which is its biggest drawback today.

Thanks Patricia for taking the time to read my post! I agree with the built-in banquette seating. My finance is pretty convinced that it's a great idea for big family dinners (which is funny since most meals we eat out OR eat in front of the TV since we live in a condo and it's only the 3 of us). As for the pictures, I took these with a wide angle lens, which unfortunately distorts the edges of the pictures (ie like a fisheye lens, but less severe). I took them like this to fit more of the room into a single snap shot. While the drawing isn't 100% to scale, it, for the most part it shows the correct scaling of the walls, nooks and crannies. We're mostly hoping to have general furniture layout suggestions to keep the room looking not awkward, with clean sight lines from walking up the stairs, out the patio and from the kitchen (far screen left in the diagram; it's cut off, but will be a full kitchen that has a pony-wall overlooking the stairs).

sageviews... short answer is I have no idea. Longer answer: I'm not familiar with Kitchenaid built-in models, so I can't say for sure, but... It's not so much the depth with a built-in, or the space you allow beside it, as it is the hinges on the refrigerator door. While you could leave a 1/2" clearance all the way around (and please don't let anyone tell you that looks bad, many current refrigerators require that space, and lots of people have them and it sure doesn't bother them) - your doors may still jut out a bit. Depending where you live and your personal tastes, this might be perfectly fine, or it might not suit you. Sub Zero realized a while back that integrated (flush with cabinetry) was becoming popular, so their built-ins, which are not true integrated, had hinges that operated in such a way that the door does not need to extend beyond the cabinetry beside it to open completely. Thus, if someone had the depth and space, they could install the SZ built-ins very similar to an integrated... flush with the cabinetry. I don't think Kitchenaid did this with their built-in hinges. You'd really have to go look at them, and inquire. The easiest way to tell is to take a piece of flat wood (a 1 x 8 or a small piece of plywood - or even a stiff notepad), hold it just beside the door - flush, and open the door the way. Does it hit the wood? If yes, you can't flush install. Is that horrible? If one really wants panels but can't find integrated or it's beyond the remodel budget, no, I don't think so. Just my opinion. It's kind of hard for me to explain the difference in hinges, but the SZ's allow the door to open in place, it does not need side-room. I can't tell by looking at Kitchenaide's site, but I'm pretty sure they require a non-flush install. Basically, the difference is this: SZ built in flush inset: kitchenaide built in flush inset: Hope whatever you decide, you are happy with it : )