The only way I know of to have both the fan and light to come on together would be to wire them together to one switch or timer. I find it very easy with the stacked switch to hit both buttons when I enter the bathroom; I turn off the light when I'm done in the shower, and the fan turns itself off after an hour (or whatever time you set it to). If you wired them together to a single switch, then you wouldn't run the fan after the shower, which is good for drawing moisture out of the room. If you wired them together to a single timer, then they'd both be on for an hour until the timer shuts them off, wasting power on the light for an hour every day. (Depending who's using the bathroom, you might also have someone turn off the light, not realizing it's also turning off the fan.) I'm sure someone with an electronics background could build a box you could stash where the wires run in the attic with a relay that turns the light on when the fan goes on (or visa versa), but doesn't turn both off when the switch goes off for either one. But I'm not aware of a readily-available commercial switch that does this. -- Eric

I'm not sure I'd want to buy from a company that doesn't understand the meaning of the word "regressed." :)

We went for function, and installed a a fan Motion and Humidity Sensor with light in the shower. The cats set off the motion sensor all the time, but the fan dries out the shower completely and no mildew!! I updated most of the 6" can lights in the master bath with LED retrofits like these Can light replacements, and installed a semi flush pendant using a Can light converter kit in the center of the room.

I would look for any fixture that is preferably UL "wet" rated and doesn't hang down too much.