I got mine from myknobs.com. I found the pull I wanted by ordering samples from several different places and then looked for an online source that sold both sizes that I wanted. That's why I ordered from them. Have no complaints. I ended up ordering coat hooks and towel bars from them also. I'm not sure on the faucet issue.

Um... I kinda like 'em low, too. Mostly, I just like your hardware! :) Are you short? Does it make a difference? Think if you have stacked cabinets, for example. If they're lower, could you actually reach them? (You must be TALL!! :) If you're short, that doesn't matter.

I would not want to stand at the sink with the handle pull going into my belly when I lean over or catching my pocket when I move. Go with the finger pull. It's hardly noticeable and more functional.

@Beth Yes, they have it placed at 3” and I was suggesting in my OP to bring it down to 2” - however, based on what you posted it sounds like we could take it even lower/closer to the corner at 1-1/4” up/in, which may be more in line with what we want… clean lines, not making the hardware stand out (except for the pantry, we just like the forged/textured look of that hardware, but that’s an exception)… What do you think of my other suggested changes, per the OP (see below)? - Knobs on upper should be 2” from corner (currently 3”) - Drawer pulls should all be placed towards the top of the drawer, not middle - Lower cabinets should have the pulls placed horrizontal instead of vertical