Greg - Rollouts inside a cabinet is double motion and you have to make sure both cabinet doors are fully open.. a pain in my humble opinion. With drawers, you can have both hands busy stirring, etc. and open them with your toes and look down for what you need! Can't do that with two doors to open and then a pullout. I put drawers on all my lower cabinets, except for two cabinets - one was for vertical storage (cookie sheets, etc.), the other was for my tall appliances like mixer, blenders, etc. And I LOVE them! Would never go back to base cabinets that are not drawers. So much easier to find things.

>>>"My name is Marcia btw not that it matters but with the line is the only way it would take it."And here I thought you were "Marc" from Iowa (IA). :>) Another thought on something thing that affect overbrowning, which is oven cycling. When temp drops below a certain point, the baking burner heats up until the temperature overshoots the set point. Then it shuts off until the temp falls low enough, at which point it comes back on again. On my late former stove, a GE Profile dual fuel, the swings were much wider during preheat. That is, the overshoot on the way up to a full preheat was much higher than after full preheating. On the way to a full preheat, the oven thermometers showed me that that the overshoot might be as much as 30F to 50F above and below the set point while the oven was preheating. However, after thirty or so minutes of preheating, the swing really settled down to around 20F or 30F (so, varying around 350F by going down to 340F or 335F and going up to about 360F). For at least the last decade, stoves have been well insulated so that many ovens hold heat pretty well once they have been fully preheated. On the subject of convection, here's a reason to consider trying out convection baking and roasting with your induction rnage. On my late GE Profile range, the temp settings tended to be very stable in a fully preheated oven when running convection. Assuming I had a relatively clean oven, of course. The third oven heating element (the one the rings the fan) helps maintain a set temp which the air flow distributes around the cavity. So, with the oven set to, say, 350F, and convection running, the oven thermometers showed me that a cookie sheet on the middle rack would stay within a few degrees of 350F. On my former GE Profile, I also found that preheating with convection bake took longer than preheating on standard bake, but the temperature was more stable when the pre-heat signal went off. So, you also might try that and see if makes any difference. This post was edited by JWVideo on Wed, Jun 19, 13 at 15:01

We've had our 36" 5-burner GE Profile induction cooktop for about 2 months now, and I LOVE it for all of the reasons mentioned above. Two things anyone might want to consider when deciding on which induction to buy: 1. SERVICE--DH didn't get around to installing the hood until AFTER the cooktop had been installed. He dropped his hammer on it from a height of 2' and cracked the glass. Yes, I was angry, especially since I knew he was tired and I'd tried to get him to stop before he made any mistakes! But he called GE, the repair guy called us immediately, and ordered any parts he thought might have been damaged (the control panel was right under the glass where the hammer hit). He had them FedEx/UPSed to us, and told us to call him when they arrived. We did, and he came the SAME day and did the repair. The control box had not been damaged, so he returned it. 2. SS RIM--If you've ever had something boil over, having the stainless steel rim instead of only the smooth black surface will keep most things from overflowing onto the counter or floor. I can't count the number of times I've cooked rice and had a considerable amount of water boil over--including yesterday. :o) I'd forgotten I'd put it on power boost (do NOT leave the cooktop while this is on), and walked to the other side of the kitchen to get something. Over it went out of the pot, but it stayed within the boundaries of the cooktop because of the SS rim, although the mess spread over three burners. Easy to fix. Turned it down so it stopped overflowing immediately, picked up the pans on the three burners and wiped them and the cooktop off, and was back in business in a couple of minutes with the rice simmering away at the perfect temperature. No matter what I've cooked, there's been a perfect simmer point. The placement of the different sized burners also works well for me. Soon the real test will come, when DH and DS both stir fry on the two front burners. There's room for the 14" stir fry pan, the 12" extra deep 6 qt saute pan, and the 13" French skillet in the back on Low to keep things warm. I LOVE this cooktop!!! I also love my new pots and pans. Up until we got the induction cooktop, I'd cooked for decades using a few not-so-good ones. While researching pans, I ran across explanations of what each kind of pan can be used for, which were helpful in making choices from the many AllClad options. I ended up getting the Kitchen Aid pans recommended by Consumers Report (partly because I like glass lids), and several larger AllClad pieces from Williams-Sonoma that were a lower price in their catalog as well as some that went on sale in their store after Christmas. I also got some from the AllClad outlet in PA via the internet. Several of the W-S prices were cheaper than the outlet! I'd looked over the pans in the reduced price collections of the various stores, but had determined that most of the ones I wanted were not included in those offers. Although the AllClad is expensive, I especially love cooking with their large pans. Anne

As far as my research showed me, every induction cooktop has a slight hum to them. I personally tried three different ones (Monogram, Miele and Electrolux) and someone else here confirmed a fourth (Thermador). It does get louder the higher (hotter) you turn the hob. However, at the lower (non-boil or non-sear) settings it is really not audible given the sound of a vent hood on low. It also depends greatly on the sensitivity of your own ears. I tried the Miele one at a girlfriend's house and I could hear it but she never had in the 6 months she has had it:) We are getting the 36" Monogram induction cooktop... ordering in two weeks or so. Good luck!