ist thing is not to panic. Just keep drying it out and see if the buckling settles down. If its prefinished it pretty easy to get some boards replaced. If its site finished you'll most likely have to resand the entire area. It can sometimes take several weeks for all the moisture to leave. I don't think the mold issue is of big concern. The main thing is to let area dry out and see what hsppens.

We just had BR-111 brazillian cherry 5/16 installed on a slab. This was the first time this flooring company had installed 5/16 solid wood. The 2nd day after install floors started cupping just as pictured above. Some areas were worse then others. They sent out one of the flooring inspectors and he measured for moisture. Everything seemed fine and he could not figure out any moisture issues. The next day the owner came out. He brought out commercial dehummidifiers. He kept insisting it was moisture although no proof. My husband issisted on a qualified wood flooring inspector. He was to come the next day. The owner of the flooring place left. Less than 2 hours later he called on the phone and said he was sending some guys out to pull up all 1000 square feet of flooring in my whole downstairs. What was the problem??......... They had used the wrong glue. BR-111 rep said they had a new specific glue for this flooring on a slab. Flooring company had just assumed they could use glue that they usually used on all hardwood. The areas that were the worst were the areas that they had done the second day(thay were here 2 days laying floor) on the 2nd day they used a glue that was more like honey consistincy. These areas were really bad the flooring that was layed the first day did not look near as bad. If they had not changed glue the second day We may not have noticed. The other glue would not have shown the problem so drastically right away. it may have taken several weeks for the other areas to start cupping. This is the information that the certified inspector told the owner of the store. Needless to say he had 2 office personel out at my house tearing up 7500 worth of wood floor in there dress shirt, kakis, and dress shoes. They re-installed a couple of days ago with the glue from BR-111 and so far no problems. What a hassel it has been and I am installing a new kitchen.

We are just finishing up a renovation project in the kitchen part of our 4 year old house. The vinyl tile there now was basically destroyed - and must be replaced. The house sits on a concrete slab. My 93 year old mom lives with us - so natural stone or tile flooring is out of the question. I had thought about Duraceramic but am concerned about chipping and cracking. We also are considering Armalock by Armstrong - laminate flooring that looks like stone. It is a floating floor over a cushy layer. What kind of flooring would be best?

Hi @Lynn Morford, I hate to jinx things, but now three months in, I LOVE the floors. I fact, I admire them many times a day (good distraction from current CV craziness). There are about a dozen spots where there were dings or tiny cracks, which freaked me out at first, but I'm pretty sure it was just from the movers. I do take care of them like a newborn child, though--sweep, vacuum, wipe, repeat. Overall, I'm very happy with them! @everdebz, we ended up gluing down. Definitely harder on my body that floating but I've learned to wear slippers or socks and I have yoga mats in most rooms to give my feet a little vacation as I walk through the house, lol. In the end, I trusted @joseph_corlett's comment about letting the contractor make the call on what is best for the situation. Granted, I still pine for the perfect floating feel of my old Junckers flooring, but apparently theirs were unique and most other flooring can't float the same way, so... Anyway, the sad fact is, you can't remove glue-downs without destroying the boards. So fingers crossed you never have to! (I put fake wood in my laundry room and we've already had three floods, so thank god for that decision.)