How do I remove old masking tape?
10 years ago
Featured Answer
Sort by:Oldest
Comments (16)
Related Discussions
How do I remove wheel from old Troy-Bilt Tiller?
Comments (11)bagsprc - I think the HH60 is the engine serial number, not the tiller number. But, no matter. Try this: Lift up the flat-tire side of the tiller and set a concrete block under it, so that the flat tire is held off the ground. Take one of those load-securing straps that has a ratchet mechanism to tighten it down, and place the strap around the tire; tighten the hell out of it, so that the bead of the tire is squished out against the wheel. (If you don't have such a strap, try a rope as farmerboybill suggested - however, it's hard to pull the rope tight enough.) Using a compressor or a portable air tank, put air into the tire; the object here is for air pressure to force the tire beads against the wheel tight enough to seal. Sometimes it helps to remove the core from the valve stem, in which case you have to put a simple nozzle on your air hose - if you do it this way, you'll lose some air while you reinsert the core, but the beads should hold. If you are able to seat the beads and the tire holds air, then you're good to go. If you seat the beads but the tire looses air, then try putting Slime into it, rotate the tire a number of times, and air it up again. HOWEVER, if you can't get the beads to seat, you've got 3 options; turn the tiller over on its side and see if you can insert a tube with the wheel still on the tiller, or remove the wheel and install a tube OR load the tiller up and take it to a tire repair shop. At this point, I personally would head for the tire shop. Good luck removing the wheel - it's probably going to be quite a job. Punch the pin out, and the wheel is ready to slip off the axle - but it won't. It's probably rusted in place. Try P-Blaster, tap on the wheel with a hammer, spray it again, let it soak overnight, tap it some more - work it, work it, work it. If you've got a torch, try heat. Good luck. If you do ever get it off, put anti-seize on the axle before you reinstall it. If you get the wheel off, put a tube in the tire....See MoreHow do I remove duct tape goo from wood floors?
Comments (5)I've used the product listed below to remove old silicone caulk from shower doors. It works! If the duct tape adhesive has already reacted with the finish on the floor there may not be any way to prevent damage to the finish. Spray the tape with the cleaner, let it soak overnight and then use a plastic spatula or credit card to gently pry the tape off. You may have to do more than one treatment. I believe you can find the cleaner at Home Depot or Ace stores. Here is a link that might be useful: cleaner...See MoreSolution for blue masking tape peeling off paint problem
Comments (2)Well....sorry to burst your bubble....but it IS the paint AND primer. More specifically: It's ANY paint and primers' issue! * Modern-day Primers and paints "skin over" quickly at the tape edge. This bond is stronger than the primer-to-paint/wall-bond....for many days. * Primers and paints curing TO THE WALL takes a while...meaning daaays. FULL CURE of a paint/primer film can be a month....or more. * For taping use, the paint "forms a tough skin" in minutes...BUT NOT TO THE WALL yet. * This "skin" will EASILY get pulled-into by tape with paint on it, because... >>> The paint and/or primer HASN'T EVEN REMOTELY DRIED/CURED to the wall yet....but it IS dried to itself somewhat. I purposely wait 'till the NEXT DAY, score the tape/paint edge with a sharp snap-knife, and pull the tape. LASER-STRAIGHT edge-lines are the result, with ZERO pulling into the paint film. I've been giving this advice to our clients for years, and no complaints yet. * .....and we sell LOTS of paint. * That 3M Blue is our best seller, and my fave too. (to the tune of several-hundred rolls/yr.) Faron...See MoreRemoving old tape...
Comments (2)Thank you, iowascrapper... I've never heard of the adhesive eraser and will give it a try. Again, many thanks!...See More- 10 years ago
- 10 years agolast modified: 10 years ago
- 10 years ago
- 10 years ago
- 10 years ago
- 10 years ago
Related Stories

DECORATING GUIDESLose It: CDs, DVDs, Cassettes and VHS tapes
Still have piles of old cassettes, jewel boxes and videos piled in your garage? Learn how to get rid of them the eco-friendly way
Full Story
DECORATING GUIDESTape, the Multipurpose Decorating Wonder
See how clever hands turn humble tape into quick and easy decor — and even fine art for the home
Full Story
DECORATING GUIDESQuick Fix: Multipurpose Painter's Tape
Five creative uses beyond a paint job for those favorite blue rolls
Full Story
HOUSEKEEPINGHow to Remove Water Rings From Wood Tables
You may be surprised by some of these ideas for removing cloudy white water marks from wood surfaces
Full Story
BATHROOM DESIGNOut With the Old Tile: 8 Steps to Prep for Demolition
This isn't a light DIY project: You'll need heavy-duty tools and plenty of protection for your home and yourself
Full Story
BUDGET DECORATINGBudget Decorator: 8 Ways to Make Old Furniture Look Brand New
Learn stripping, staining, painting and reupholstering basics to make bargain-basement furniture worthy of center stage at home
Full Story
SALVAGEReinvent It: Make a Cheery Planter From an Old Eyesore
Don't ignore that yucky old grill growing rust in your yard — turn it into a lighthearted planter that's a joy to see
Full Story
BARN HOMESHouzz Tour: An Old Dairy Gets a Contemporary Twist
Soothing neutrals and a mix of old and new transform a dilapidated Suffolk dairy into an elegant home
Full Story
DIY PROJECTSDining Set Makeover: Paint and Tea-Tinted Fabric Make Old Chairs New
Reclaim dated dining chairs for far less than buying new, using spray paint, modern fabric and a handful of tea bags
Full Story
MODERN HOMESHouzz Tour: 800-Year-Old Walls, Modern Interiors in Provence
Old architecture and new additions mix beautifully in a luxurious renovated vacation home
Full Story
rhizo_1 (North AL) zone 7