Thank you all so very much. No, nothing is looking up. Have to be honest about that. I did move out of that horrible trailer. I don't even want to remember, that's how bad it was. I stopped posting about it because I kind of took a beating from some members here. Like I needed THAT along with everything else. My pets and I are in the Motel 6. I have enough money to stay about ten days and that's it. Panic attacks like you would not believe. Thank you all, so very much. Hugs !

So many regulars have left.

Hi Everyone! And thank you all for being available and alive. Much joy in my day today, and you all are part of it! Thank you for your link to the Agg potting mixes, Al! MUCH more reasonably priced ingredients than repotme, though I am impressed, still, by the quality of stuff at repotme. I am guiding my essential purchase of potting mix by choosing one that yields aeration (large size without small piece congestion), durability of structure, and uniformity of partical size . The Agg site gives me more control of uniformity than repotme does . I am back to the drawing board! Also, thanks for the info about when to repot houseplants. I was set to start this month but will wait until the week before the summer solstice when my Dracenas spring into serious growth! They are so happy, and grew some during winter. It would kill me to have them take a dive after repotting. I am seriously considering a mix from Agg so I can control particulate size and uniformity. But the quality at repotme is breathtaking. I want what's best for Thing One and Thing Two even if I have to shell out some serious money to do so. I thank you for your time and interest!🌱☀🌈😊

Presumably the panel you have on it is the same as the original. Keybuttons to access diagnostics functions are different on the various panels. -- Machine turned off. Press/hold Auto Dry Down, then press Power at the same time. Release both when the panel activates. Press Power to exit diagnostics. Or disconnect the power cord for several seconds. There are several levels of diagnostics. Most of them are for engineering development and factory testing, not useful for operational troubleshooting. Auto Dry Up and Down buttons switch between levels. Initial is level 0. -- Last Fault is level 3. Press Auto Dry Up three times. Fault code is displayed in binary via the Drying Progress LEDs. There are 22 fault codes so I'll list them in following reply. -- Sensor bars test is level 5. Press Auto Dry Up two more times. Or exit Diagnostics, start over, and press it five times. Touch a damp cloth or your fingers across the sensor bars, the pattern of LEDs on the panel should change as moisture is registered and then dissipates when the bars are not touched. There is a Data Download mode for use with an optical reader tool. I imagine you don't have one ... but it's accessed by entering diagnostic mode and pressing the Regular cycle button. The reader is placed at the red Auto Sensing LED. There is a Showroom Mode, which flashes the panel LEDs randomly to attract attention in a store display. Cycles can presumably be set but the machine won't start. Disconnect the power cord or toggle the breakers off to exit Showroom Mode.