If you have heaving, then the glass-granite would be a concern. There should be a gap between the two, and that gap should be caulked, not grouted. The bowed wall, if the tile is over drywall, the bump could be a drywall joint compound "speed bump". But it should be gradual and not sudden, and a bump like that shouldn't cause lippage. I have seen installers who simply don't press tiles "flat" into the thinset. Some press more on the top edge of the tile, a few press more on the bottom edge of the tile. Those habits can result in "vertical lippage", but the tiles are usually consistent on the side edges. It's a backsplash and it's decorative. So a little lippage here and there, while not desirable, it's not really going to affect function. But if there are lights that reflect off the splash and it can be viewed at a low raking angle and it looks nasty? Then perhaps a "poor worksmanship" line has been crossed. The kicker though is the lack of a gap between the bottom course of glass tile and the granite. In your photo, is the cut glass tile at the j-box cracked? Might just be reflection/refraction. And for grins, the tile setter should have used a cement-based powdered thinset that is mixed with water to set the glass. Not a premixed mastic.

Posted by budgeteer_s (My Page) on Wed, Dec 31, 08 at 18:18 Thanks for all your suggestions. I wanted so much to follow with ci_lantro's suggestion because then I'm done. I'll gladly let you snatch that paint brush out of my hand. ha ha. But at the same time if a little tiling will tie up the project, then I'm game. jodi_socal: I'm a little disappointed when you said fire and ice won't work. I just LOVE that F&I BS. But then agin, I think I know all along it's a little too much for my kitchen. Caryscott & petra: Thanks for the picture petra, it says a thousand words. Is spectralight glass tiles? Prices are pretty reasonable. What about that milk green color? will it work? maybe with some garnet pieces sparingly mixed in. I will take some pictures and post two HD Behr's paint card to aid in the discussion of color. Thanks again ALL! Correction: My tiles were Alfagres: Gema4x4: different from what caryscott posted: I loved what caryscott linked:

http://www.delphiglass.com/soldering-supplies/flux-finishing-chemicals/mirror-edge-sealant Here is a product, but there are automotive products that do the same thing. Its just a spray, and you could just hit the silver ones. Do you know what type of adhesive your tile person used? In mosaic we use thinset mortar. DRY. not premixed. Premixed thinsets are mastic based, and they WILL fail. especially outdoors. Your environment also matters. If you live in a dryer frost free area, it could be find for a number of years. The reason I ask is because mirror uses a special mirror mastic. I would never use mastic for anything I want to endure However, tile people often have different opinions about that. And I know when mastic is used in my region out of doors because I often pick up the broken tiles that have fallen off to use in my work :) I have obtained some very expensive ceramic that way. At any rate, here is an article for you. Good luck! http://tiletools.com/mastic-vs-thinset-which-should-i-use/

What type of special equipment should be used for glass tile installation? I’m asking so that I can ask my installer if he has what it takes. He says he has experience with installing glass tile but doesn’t seem super confident. I figure if he doesn’t have a few of the important basic tools, I need to ask more questions or switch to a plain subway tile to avoid disappointment. The glass would be stunning but I’m ready to switch to ceramic if needed.