4'x7' is a waste of space when it comes to a closet. It's not big enough for hanging except on one wall and a bit of the small wall. You'll get better storage in less space with a simple reach in closet with organizers. The bath itself also needs to increase in size if you want a soaker tub and a shower. A soaker tub isn't designed to work with a shower. You need a shallower tub with an integral tile flange to work with a tub/shower situation. A deep soaker tub will be a PIA to step into to use as a shower, and you'll have water infiltration issues if you try to use it as a shower as well. Also, most 4 bedroom houses would want to have 3 bathrooms. You may want to rethink your wants and needs and the small size of the space you are working with. One needs to reduce, or the other needs to enlarge. Since you say the budget is small, and this will be an expensive project, I'd suggest reducing some of your wants, and eliminating one of the bedrooms to better utilize the existing space split between the others. A 3/2 is a common configuration, and would give you more space to work with for the design. Remodels like this are costly because of working within the constraints of the old footprint and accessing the major systems. Also, integrating the old and new isn't always successful. It's just easier to do plumbing and electrical and HVAC (all of the expensive stuff) when the walls are completely open and you don't have to fight the old stuff into submission. It's one of the reasons teardowns of older homes in older neighborhoods became popular. It's less money, and you end up with more house that has more modern proportions and amenities.

It's Jeffery Court Tile. http://www.jeffreycourt.com/ I don't know which one, but he has a large internet presence so you might be able to ask .

Dottie - I could not have done this without an educated designer - it's not just about the design choices although I would never have come up with design choices as my brain isn't hardwired in those kinds of visually imaginative ways. I can appreciate things but I don't know how to pull them together and I wouldn't have the ability to figure out where to even start in terms of the sea of vendors. I am good about researching appliances and functions but get lost in the sea of visual possibilities :-) And I can't even imagine dealing with codes and such since Los Angeles is code crazy - I wanted to move some floor electrical outlets up a bit from the floor as I found it difficult to reach them when I had some hip issues so I was thinking about for the future - I was told that if I move a plug, the whole thing has to be rewired back to the panel box. And the darn kitchen sink has to be approved by the UL LOL - who would think a kitchen sink could be dangerous.

I would choose a tile paint that would cover ONLY the red. Find a colour that would work for the bathroom (with floor pattern as-is) and then go ahead and paint JUST the red. But that means you would HAVE to change out the light/plug-in facing to the same colour (or match the wall tile colour). Personally (because I am cheap and lazy) I would look at large throw rugs (no backing...just natural fibres...you have in-floor heat) to cover up most of the floor. By leaving a bit of the red peeping out means you can leave the switch plates alone. If you are moving in 4 years, you can reassess in 3 years. Remember: if you are moving in a short amount of time, you are not the 'owner' you are designing for. You are trying to design for someone else. Someone you do NOT know. That's tough enough on it's own.