I have a similar prob -- my clickers dont work -but keypad does - i have new batteries and also bought a new clicker i can program and unprogram the keypad opener but the clickers will not program - any help would be appreciated.

You got the wrong keypad for your opener. Take the model number off the motor unit. It is on the opposite end of where all those white wires go. The keypad must be for that model opener or you will have that problem.

I would make sure all the connections are tight. Check the two connections on the rear of the wall control. If they check out I think you would be ahead to replace that unit.

Don, Thank you for posting. You are correct in that I meant it would not close, my mistake. The remotes did not have good batteries, which I knew and is the reason I could not try them. I am not sure why the unit reset, but I have resolved the issue. Turning the down travel didn't do anything until I turned it clockwise all the way until it was touching the contact. I then turned it counter clockwise 5 turns at a time and then would test it by pressing the button on the wall. Each time I did this, the trolley would travel another 6 or 8 inches. So I just kept doing this cycle of 5 counter clockwise turns until the trolley locked into the place (I had the door manually closed while I was going through this process). I am not sure why the down travel wouldn't respond until I turned it all the way, but I am glad it is resolved. I reprogrammed the universal keypad, put a new battery in one of the remotes, and they both work. The button in my car still worked without needing reprogramming. So all is well now. Again, thank you for responding Don. Reading through the site, I can see you do a great job of helping everyone out.