the plants on the left look like they may be peppers, not sure of the one on the right.

Update: Before the install, I did wind up modifying the track in the air handler for the 1-inch air filter. I used 2 pieces of steel banding, 2 inches wide, cut to length, and placed them over the manufacturer's track using a few dabs of automobile body putty (Bondo) to keep it secure. It is now a smooth track for the filter to slide on. Goodman used the track as part of the frame of the air handler so it had some crimpings in it and the filter would not easily slide in. I also trimmed away some foil faced insulation that prevented the filter from seating properly. A 20"x24" filter now fits perfectly. I am glad that I did these minor mods as I would have been fighting this monthly when I change filters. The unit was installed Friday, 6/22, after I had it for about 5 weeks waiting on the installers. It took two guys 8 hours. I fed them both breakfast and lunch (I treat my installers well). The old supply air plenum and the plenum after the air handler had to be replaced to match the new unit. The old 5/16" liquid line had to be replaced with a new 3/8" line. 3 holes were cut into the finished ceiling and 1 in the wall so that the new line could be run. I'll repair the holes when I get a chance - no big deal. The TXV sticks out about 8 inches from the air handler. Looks funky and I have to be careful not to hit it while moving things around in that area. The old outside unit had sunk about 4 inches into the ground. I filled the hole with soil that I was saving, packed it down, put a plastic condensor mounting pad on the dirt, and used 3" thick brick to elevate the outside unit (which is huge in size compared to the old 7 SEER unit; 14 SEER = more coils = larger unit). The outside unit is much more quiet as expected but the new mult-speed air handler is also a little more quiet than the old one. The fan is set on low speed and I'm not sure of the setting of the old unit as the lables on the motor had worn away after 21 years. The sheet metal in the new air handler is flimsy and the track for the air filter can be improved by Mr Goodman. The outside unit looks decent. These comments were also noted by the installers. I plan on taking the outside and inside coils to a local scrap facility and sell the copper. Maybe I can get a few $$ for a couple cases cases of my favorite beer. I can now start saving 40% on the cooling and heating part of my energy bill and use this to combat the 65% increase in electric rates in the State of Maryland. All in all, I thought that I got a good value for the money spent (only time will tell if I made the right choice with Goodman). I got a 14 SEER system with Copeland scroll compressor, thermo-expansion valve on the air handler, hard start capacitor, 15 kw heat strip kit, bypass humidifier, and 10 year parts warranty for $2477 from a local HVAC supply shop. I paid $1200 for a pro install (needed the pro install for the warranty). Total cost was $2k less than...

Possibly Redgold? Redgold at Helpmefind.com

@AFritzler - thanks so much for replying I ended doing a 1/2 bullnose edge as did not want any chipping issue. My fabricator mentioned that an eased edge was most popular today- maybe because of the contemporary look with quartz. But I was ok with the 1/2 bullnose as my kitchen is transitional and not contemporary/modern . 1/2 bullnose also shows granite thickness and my pattern seems to flow over the top edge. An eased may have been a more solid look though. Sink - I did a 3/8 rounded edge with a very, very slight positive reveal (thanks to advice from houzz). Corner radius my fabricator matched to the sink. I am happy with the outcome, but it took a lot of researching what to do- lol Thanks again for replying