Canadian_Rose, Ballerina is a delightful different rose .. Her prettiest flush is in June. However , she ALWAYS has flowers on her. Even now, in november . She does not seem to have too much of a fragrance .. but in June, she can teach those Hydrangeas to control their pride ...and tell them that she is the queen after all.. I think she is a pretty strong rose.. I had her in the front of my home which is north facing and due to deer problem, she grew but was not super happy-- deer preferred my other roses to her though and she was their last resort.. So, in 2012, I transplanted her in the middle of hot summer to ny backyard which I got fenced and she lost EVERY LEAF.. I thought I Killed her, but she rebounded and is quite happy. She too gets blackspot ,and because her leaves are very small , it shows more on her.. I think next year I will spray her with a fungicide to control it a little.. But again , a delightful rose.

00001001 = Fault Code 9 Phase 1 to 6 - Size Switch Error GW611 is a Phase 6 machine. Phase 6 sets the machine size via software programming. It's a 6kg capacity, correct? With machine powered off, press/hold Wash Temp Up button, then press Power at the same time. Should get 4 beeps and the panel activates. Low water level LED indicates 6kg capacity. If the indicator is wrong, press Water Level Up button to set it, then Power to save the programming. (Temp Up / Cold is 5kg, Spin Up / Hold is 7kg). If the machine won't accept the correct setting then there may be a problem with the motor controller board.

I had to go push a few buttons to answer your question. Yes, my Kenmore OTR MW beeps when you push buttons. I think I like the beeps. It tells me that I actually hit a button, unlike the ATM keypad at the grocery store where I didn't push a button hard enough when entering my pin and then had to figure out why it didn't like my debit transaction. Hope you find an "off button" for yours.

Is it on a dimmer switch? I’ve had this happen to me with LED lights on a dimmer.