It would be perfect for my brug collection. I bet though I would run out of room. LOL That is a good price fro someone wanting a gh.....

I picked up a 5 gallon Garnet from Costco for $20 - nothing could be wrong for that price. You are right, many of them including Bloodgood and Coral Bark do not look like they should, but this is not worse than those big boxes.

goodguy2k2k: You might get more and better responses to your questions if you start a separate thread. Your questions are so far down this long thread that they may get missed, especially since you are asking about 30" stoves and this is a thread about 36" stoves.. But, here's what I think I know in answer to your questions. I know next to nothing nothing about Verona stovesexcept that they are very nice looking stoves that can be had in colors and use dual stacked burners on the cooktop. There have been practically no threads here even mentioning this line of stoves, let alone any giving an in-depth discussion of the stove or support. That would give me pause. I personally would not not consider buying a stove that is built by a very low-volume manufacturer that relies on European electronics which may be hard to fix or replace in this country. I also would be reluctant to consider buy on-line which may leave me a 1000 miles form the vendor who may be my only service and support. Also, the Veronas (which I think used be sold under the DeLonghi brand) have small and really shallow ovens (common for Eurpean stoves). BTW, isn't the 36" Verona dual fuel actually $3499 not $2499 (exclusive of any sales tax)?. The 30" DF is, think, about $3k, which is still the most expensive stove in your line-up... The Costco US price for the NXR is still listed as $1999, but maybe your state sales tax would take it to $2199? . If you want the center-grate, you have to order that eleswhere (Dvorson's, Austek, AJ Madison, etc.) which will add about $110. If you need to convert to LP, you likewise would have to order a kit from anohter vendor (the bLue Star comes with the LP conversion kit). Those additions would narrow the price gap with the Canadian Blue Star by about $200 to $250. Both stoves can be had with Island trim if you needed that, but you would have to order that separately for both stoves. From recent postings here, the US price for Blue Star RCS.models seems to be around $3500. Sometimes you find them for less on sites like Craigslist.. Biggest differences between the Blue Star and NXR? Open versus sealed burners; cast iron multi-piece cooktop versus stainless steel cooktop; Depending on what and how you cook and what you cook with, the star-shaped open burners on the Blue Star may give you more even heating than the NXR's sealed burners and the difference may or may not matter to you. The Blue Star has a bigger oven cavity.: Some people think the NXR stainless stovetop and fancy oven coating will be easier to clean than the RCS's stove's cast iron top and standard-grade oven coating. I'll expound and give others something to argue about. :>) NXR has 4 sealed 15k-btu hr. "dual stacked" burners in deep wells on a stainless stovestop. The depth of the wells means spills don't often bake on, so cleaning is often just pulling the grates, sptrizing and wiping with a microfiber cloth..For me, the NXR does a great job with moderate to large size pans on any heat setting and is okay with 5" diameter pans. It does not work well for high-heat on tiny pans (e.g.,4" saucepans, tiny fry pans for searing 3 shrimp, Bialetti "Mokka" pots.) On really low settings, you apparently can slowly melt chocolate on a paper plate. I can tell you that I've never needed a double boiler on my NXR. Blue Star has has three burners at 15k-btu-hr. (which apparently simmer very nicely) and one dedicated "simmer" burner. Apparently, you can do the same paper plate chocolate-melting trick on the simmer burner. Or, if you buy the parts (extra $), you can diy-upgrade it to a full range burner. The star burners mean you can heat the beejesus out of really tiny pans if that is something you need to do.. The star burners also make it easier to use a traditional round bottomed wok. (That said, there are plenty of postings here at GW saying that 15k-btu-hr. is nowhere near enough heat and that you really need to upgrade to at least a 22k burner). he top is a black cast iron. Reactions to the appearance are varied: some like the black top, some do not. The burner bowls and grate dissassemble for cleaning in a dishwasher. Some folks think stove top cleaning is easy, some think it onerous, and some think the matte black never can looks clean once you've had the stove for any length of time. In other Bluestar threads here you can find links to Trevor Lawson's video demonstration on cleaning the stove top. Check it out and make up you own mind..There is another video about the evenness of heating from star burners. Ovens? Both seem to heat evenly, both have potent infra-red broilers, and both use manually-switched convection fans. The NXR switch has an interlock that prevents the fan from operating when the broiler burner is being used. The Blue Star apparently will allow the convection fan to run when the broiler burner is activated but the manual repeatedly tells you not to do this. So, in theory, you may be able to do top-down convection roasting with a Blue Star even though you should not do it. The NXR oven coating is a glossy blue surface --- looks to me that the coating is sourced from the same supplier that Wolf uses. This can be scrubbed or wiped with a sponge and, so far for me, has rarely required resort to anything like Fume free Easy Off. . Blue Star apparently uses a similar coating in the higher end RNB models. However, the RCS models apparently have a coating akin to the standard coatings used by major appliance manufacturers (who can compensate by with a self-cleaning oven function.) There is a recent thread on the subject of the differences between the RCS and RNB oven coatings where there was some discussion of ease of cleaning. Both the Blue Star and NXR ovens will operate at 150F. The NXR can be set lower to maintain an even 135F if that matters to you for dehydrating or sous vide type cooking. Don't know if Blue Stars can do this. The exteriors of both ovens get pretty warm during extended baking and high heat roasting. The Blue star oven is deeper and wider than the NXR oven. The extra depth is an advantage.for large baking projects, say, you wanted to put two half sheet pans side by side on a oven rack. The convection fan housing in the NXR sticks out a little too far to permit you to do this. The other thing that occurs to me is the somewhat intangible and somewhat unclear aspect of service and support. Both companies are small volume operations which means that service and support can sometimes be slow when you have major problems. Prizer-Painter makes its Blue Stars in a Pennsylvania factory, so the company has a theoretical advantage for getting major components to you more quickly. Though, judging from dissappointed posters here, that does not always happen. Also, with domestic manufacturing, you may feel patriotic about buyng American. Duro Corp contracts fabrication of the NXR to a Chinese company, Hyxion, and Duro is newer to the market with a less developed support program. Both stoves are basic and straightforward, mature deisgns. If you are at all handy, you can probably take care of any maintenance yourself (in contrast to the Verona stoves.) Only the structural parts (e.g., oven doors) are proprietary. If you search here on Gardenweb, you will find more complaints about Blue Star than NXR, but that is a reflection of Blue Star having been in the market longer and having a much bigger market share. IIRC, I started seeing discussions of Blue Star stoves here back in 2002. I've only seen NXRs since the latter part of 2009, so far less time for complaints to accumulate on the NXRs... Any production line is going to kick out some lemons. One great thing about buying a stove from Costco is the absolute satsifaction money back no questions asked guarantee. If you wind up with a lemon, you do not have to go through the three-tries-to-fix-each-problem and "we don't know when the parts will arrive" process. Just pack it up and take it back to get a new stove or get your money back and move on to something else. More generally, I'd say that the NXR is very good stove which is worth the $2k price while the Blue Star RCS would be a $3500 stove that is definitely worth the $2400 ($CN) that Costco charges and, according to whole lot of folks here, is worth the $3500 that gets charged on this side of the border. You would be getting it $2700 (an $800 discount). Since you have the budget for it, the question you have to decide is whether the features and trade-offs of the RCS are worth $500 more to you (well, $500 plus the cost of your field trip to Canada and the cost of UPS Store or other drop-off site.) . This post was edited by JWVideo on Sun, Apr 14, 13 at 22:24

We don't have BJs around here, just Sam's for a long time and Costco arrived a few years ago. Is BJs virtually the same in price, products, and policies? I never joined the Sam's because is was not convenient, and just not nice inside, kind of gloomy! The Costco is a nice experience to get to and shop in. Leaving is a pain with their checking your receipt, card, and cart, ugh. Just let me go! Re: the Sam's Club, why does the notice on the door say they will reopen the next day? Weird.