I know I probably went overboard, but I have been searching Houzz for shower/tub combos for myself if I decide to go in that direction. Most of these pictures have Master Bath titles - they tend to be small houses or apartments in large cities where space is an issue. They all have a generous sized tub. A few have extra shower bling and even a separate tub filler. All of them have material choices and the level of tile work that you see in a master bathroom. I'm sure that if I searched Houzz I could find just as many, or even more, remodels of small master baths where they have just built a walk in shower. I think the decision to do a shower/tub may be a personal choice because they want a soaking tub - since they are titled Master I'm assuming the bath is not the only bath in the house and they could easily just go with a shower. [[(https://www.houzz.com/photos/lakewood-bathroom-contemporary-bathroom-denver-phvw-vp~564696) [Contemporary Bathroom[(https://www.houzz.com/photos/contemporary-bathroom-ideas-phbr1-bp~t_712~s_2103) by Aurora General Contractors Heritage Home Improvement [[(https://www.houzz.com/photos/tamara-mack-design-interiors-traditional-bathroom-san-francisco-phvw-vp~1860108) [Transitional Bathroom[(https://www.houzz.com/photos/transitional-bathroom-ideas-phbr1-bp~t_712~s_2112) by San Francisco Interior Designers & Decorators Tamara Mack Design [[(https://www.houzz.com/photos/jackson-hole-residence-rustic-bathroom-portland-phvw-vp~1116073) [Rustic Bathroom[(https://www.houzz.com/photos/rustic-bathroom-ideas-phbr1-bp~t_712~s_2111) by Portland Architects & Designers Howells Architecture + Design, LLC [[(https://www.houzz.com/photos/bath-traditional-bathroom-charlotte-phvw-vp~1153799) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by Charlotte Architects & Designers Don Duffy Architecture [[(https://www.houzz.com/photos/tile-showers-traditional-bathroom-houston-phvw-vp~1597876) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by Lake Jackson Kitchen & Bath Remodelers JC Remodeling & Restoration, LLC [[(https://www.houzz.com/photos/icon-development-tofino-job-contemporary-bathroom-vancouver-phvw-vp~2443799) [Contemporary Bathroom[(https://www.houzz.com/photos/contemporary-bathroom-ideas-phbr1-bp~t_712~s_2103) by Nanaimo Tile, Stone & Countertops City Tile [[(https://www.houzz.com/photos/riverside-drive-super-groovy-masterpiece-contemporary-bathroom-new-york-phvw-vp~2456534) [Contemporary Bathroom[(https://www.houzz.com/photos/contemporary-bathroom-ideas-phbr1-bp~t_712~s_2103) by New York General Contractors Rusk Renovation [[(https://www.houzz.com/photos/burns-park-addition-and-remodeling-2000-and-2006-traditional-bathroom-detroit-phvw-vp~374078) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by Canton Architects & Designers Studio Z Architecture [[(https://www.houzz.com/photos/erica-islas-silverlake-contemporary-bathroom-los-angeles-phvw-vp~190979) [Contemporary Bathroom[(https://www.houzz.com/photos/contemporary-bathroom-ideas-phbr1-bp~t_712~s_2103) by Culver City Interior Designers & Decorators Erica Islas / EMI Interior Design, Inc. [[(https://www.houzz.com/photos/hall-bathroom-traditional-bathroom-new-york-phvw-vp~678390) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by New York Interior Designers & Decorators Nathan Cuttle Design [[(https://www.houzz.com/photos/master-bathroom-highrise-new-york-city-contemporary-bathroom-new-york-phvw-vp~89484) [Contemporary Bathroom[(https://www.houzz.com/photos/contemporary-bathroom-ideas-phbr1-bp~t_712~s_2103) by New York Photographers Vanni Archive/Architectural Photography [[(https://www.houzz.com/photos/carnegie-hill-residence-traditional-bathroom-new-york-phvw-vp~204853) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by New York Architects & Designers Incorporated[[(https://www.houzz.com/photos/upper-west-side-nyc-apartment-renovation-transitional-bathroom-new-york-phvw-vp~6968329) [Transitional Bathroom[(https://www.houzz.com/photos/transitional-bathroom-ideas-phbr1-bp~t_712~s_2112) by New York Architects & Designers John M Reimnitz Architect PC div> [[(https://www.houzz.com/photos/mediterranean-bathroom-mediterranean-bathroom-san-francisco-phvw-vp~1042841) [Mediterranean Bathroom[(https://www.houzz.com/photos/mediterranean-bathroom-ideas-phbr1-bp~t_712~s_2109) [[(https://www.houzz.com/photos/nyc-bathrooms-traditional-bathroom-phvw-vp~7215764) [Traditional Bathroom[(https://www.houzz.com/photos/traditional-bathroom-ideas-phbr1-bp~t_712~s_2107) by New York Design-Build Firms DELUXE Design & Construction [[(https://www.houzz.com/photos/cat-mountain-greenbelt-homes-austin-tx-transitional-bathroom-austin-phvw-vp~834553) [Eclectic Bathroom[(https://www.houzz.com/photos/eclectic-bathroom-ideas-phbr1-bp~t_712~s_2104) by Austin General Contractors Greenbelt Construction This post was edited by Anna_in_TX on Tue, Feb 11, 14 at 6:40

Our acrylic fiberglass tub was going to have ceramic tile around and under the top lip. This is how we installed the whole unit. We built a 2x frame with a level plywood top that had a cutout to receive the tub. The height of the plywood top allowed for 1" of tile/thinset/backerboard under the top lip and held the bottom of the tub about 1" off the floor (for mortar underneath). We mixed up mortar, dumped it on the floor below the tub and set the tub in place WITH 1" SHIMS UNDER THE TOP LIP. Then we let the mortar set up overnight. The 1" shims were removed, backerboard installed around the tub, and tile installed under the lip of the tub. Hope this helps.

I would tile to the ceiling but was just in a similar situation and did not. The ceiling in my bathroom was not even and I did not want to take a chance on seeing an uneven line next to my last row of tile. I actually have my bull nose piece just above the window. I used bull nose in my window jambs but now would have preferred not to. Steve

For a jetted tub used as a shower, it has to have an integral tile flange. That allows the wall cladding to overhang and any water that hits the wall to not go behind your walls. There aren't that many in that size that are inexpensive. It will need a specialized drain, and, if you want to spend any time in the tub, a supplemental heater so the water doesn't cool off so fast. Since it's a tub/shower, the wall cladding will need to be redone to be waterproof into the tub. It's possible, if the build is recent, and it was done with the proper vapor barrier behind it, that only one row of the tile would need to be pulled in order to replace the tub. But, I wouldn't count on that. I'd count on having to replace all of the wall cladding in the alcove. That can be as cheap as a plastic surround for around $100 or cheap tile with the proper vapor barrier for probably $150 or so. The first is the easiest and the least chance of leaking. The second will read as more upscale, but you have to be sure your contractor understands about the vapor barrier and correct materials to use to tile this (NOT mastic.) And since you have that torn out, it would be foolish to try to keep your current control valves for the bath unless they are also very new. New safety standards are in place for anti scald mechanisms. So, you will need a new shower/bath faucet and valve. Then you will need the electrical line run from the panel to the location for the whirlpool pump and supplemental heater. That location is usually opposite the drain side of the tub. You will need to be able to site an access panel that is removable to be able to get to the electrical innards here. That can be from an adjacent room, or from a hidden panel on the tub itself. All in all, you might be able to get all of the needed materials for 2-3K if you shop the box stores carefully and find some bargains. The danger to that is that if you are inexperienced, you don't know if you're buying quality or crap. They sell both. And that's one reason that it would be simpler to let the pro pick the products after you tell him the features that you want. Then you've got to pay the contractor labor to install all of that. The electrician's price will depend on how difficult it will be to access the panel and run the wire to the location. For that, it's a really good thing you are on a crawlspace! That makes it cheaper for both the electrician and the plumber. On the whole, I'd expect your project to cost between 5-7K, depending on location, and if you have no DIY skills to bring to the table and have to hire professionals for the whole job. And be sure that you hire someone that is licensed and insured to be in your home, and will pull the proper permits to get the job inspected with your code office. Some handyman guy isn't licensed to do electrical of that nature, and while he might be able to do the demo and get the tub in place and glue on the plastic surround, it's unlikely that he'll have the right insurance to deal with a large job like that, and thus probably wont' want to pull permits and be inspected. They are usually limited to smaller jobs like simple fixture replacements like a faucet or light. Which this isn't. Just remember, you are doing a project that combines electricity and water. You really have to know what you're doing here! A small General Contractor should be able to do the complete job, and also carry the needed papers. And he should have no problem with the code guys coming in to inspect his work either. If he does, then he's not the right person for the job.