Hi Cat-Mom, Yup, we're also renoing Living Room and Master Bedroom at the same time- you? :>) I just faux-painted our entry stair railing to make do until we add on to our front entry. So many balls in the air, hard to juggle it all at one time. kgwlisa, That's what I had thought of so far, basement ceiling has been ripped down, so all the plumbing is fully exposed, and present shower and bath have leaking problems, so things pretty well have to be redone anyways. I was even contemplating 'borrowing' more out of the common wall when we build it, by building in storage behind mirror and perhaps a deeper vanity. I'm assuming this is a fairly basic/common plan, and hopefully others have paved the path... Rae

Maybe I can help. Our house was built in 1962 and, interestingly enough, we are just finishing a master bath with exactly the same dimensions as yours and pretty much the same layout. All that remains to be done is for the shower door to be hung; that's another story. As I said, our bath is 7 feet long and a smidge under 7 1/2 feet wide. We also have a window over the toilet, but our wall with the vanity is on an interior wall, so no window there. The layout for our bathroom is exactly what you have in your plans, with a couple of minor differences. Our shower is 48" long, but only about 32" wide. We put a half wall between the shower and the toilet with a clear shower enclosure on the front of the shower and above the half wall. That provides a little privacy for the toilet area and prevents it being seen from the bedroom while maintaining the open feeling of the clear shower enclosure. We put crown molding all around the bathroom since the shower enclosure doesn't go all the way to the ceiling and so we weren't concerned about the humidity and the wood. The shower enclosure is tiled to the bottom of the crown molding and there is a bullnose decorative tile with a black pencil accent tile right below it that runs through the shower and extends all the way around the bathroom at wainscot height. We used a white subway tile for the shower enclosure and below the bullnose tile around the remainder of the bathroom. The subway tile and decorative tile form the backsplash above the vanity. Our plumbing for the shower is also in the wall between the bathroom and the bedroom. We used a black and white porcelain basketweave tile for the floor, both in the shower and in the remainder of the bathroom. The black accent tile on the walls and the black "dot" in the floor relate well to each other. Since we don't have the issue of the window over the vanity, we put two sinks in ours and there is plenty of room for them. The countertop doesn't feel crowded at all. As far as the grout goes, we used white epoxy grout (I don't know the brand) on the walls, and a dark gray on the floor. I've been using the bathroom, other than the shower, for a couple of months now, and the floor is pristine. While white grout was also recommended for the floor, I was too skeptical for that. The dark gray actually adds some definition to the tile pattern and there is no worry about the grout discoloring. Our vanity is 21" deep which is one reason our shower is narrower. We used standard cabinetry and the cost was relatively reasonable. It was amazing how much this small room cost! Our bathroom door does swing into the bathroom and into the shower. The only place we could find for towel bars was on the back of the door so we had to be really careful that the height of the towel bars kept them from colliding with the handle to the shower door. We also put a stop on the door so that it doesn't swing into the shower. It isn't ideal but the only way it would work for us. I don't yet have pictures; I'll try to post some in the next couple of days. Before the renovation, we had a bathtub and a small linen closet on the wall which now contains the vanity and the vanity was where the shower now is. We, thankfully, didn't need to move the toilet. I hope this has been helpful. While the bathroom is cozy, my husband and I don't generally use it at the same time. But if we did, there really is room for both of us with the double vanity. Good luck!

Lisa just a word of caution. Glass tile in a wet area has many risks. Don't assume your installer is qualified for glass installations. Special setting techniques are needed. Get the installation instructions directly from the manufacturer and make sure it's followed. Most require special mortar while some require mastic which can't be used in a wet area. Some glass can be installed over a impervious waterproof membrane while others no. Some Ok with epoxy grout others not. Be sure the glass can withstand the thermal shock from being cold to being hit with hot water. Research glass tile ghosting. Best of luck with your project.

We're voting for the White Carrara Basketweave which has a more timeless appeal and will work well with your white subway tile walls. That fits your classic vibe requirement. The eclectic vibe can be achieved and further enhanced with the other elements, including vanity, hardware, lighting, faucet, and décor. Would love to see photos of the completed bathroom in the future. Good luck! :)