Masonite might have something you're looking for... would have to special order from a Home Depot... Only catch is I don't think anyone makes them with 4 panels at that size, the bigger the size the more panels so you're looking at a 10, 12 or 15 lite door. Look under "Sizes": Other option is custom which will cost you a lot.

Just wondering if you can do a pair of doors similar to those on an armoire I have. The solid doors are hinged top and bottom to close over the opening, then can slide back along the inside of the armoire along plastic 'guides'. Another idea: We have a woven-wood product instead of drapes at our Maui condo. They are attached at the top to run along a rail like draperies.. They stack to nothing. The have magnetic closures where the pair meet. (You could do one-way.) I remember seeing a similar product used as a closet doors in motels in the 1950's. These are easily vacuumed and can be wiped clean.

kudzu, there are no jambs. The pivot base is screwed right into the top and bottom of the door opening on the problem door; thus into the wood under the drywall at the top, and into the wood floor at the bottom. I just went and checked it. The base is secure top and bottom. It's the metal pivot going into the door that is wobbling. The door starts tilting at the top, where it starts hitting the side of the door opening at the top. When the people installing the doors installed them, I guess they didn't know that a solid door needed more. I ordered the doors custom made so I could stain them to match my kitchen, and they did say they'd never seen anything like them. Last time he replaced them, my husband just went to Menard's and bought them, so I don't know if they were labeled for load capacity. Said if these failed, we were out of options. That's got to be it. Thank you so much for telling me about this! These are just too flimsy for the load of the solid wood oak door we bought. The door is tilting again. What kind of load capacity should I be looking for? Should I just weigh the door when we take it off? Can you get a variety of ones with different loads at a common home improvement store, or is this something I will need to order?

It's not an answer to your question, but I'm ;just why you're painting anything in your apartment. You shouldn't have to do that. It should be your landlord's responsibility. I own rental properties. Not only do I not expect my tenants to paint, I don't WANT them to, and specifically don't allow it. I did at one time, but had too many bad experiences. Same with repairs and upgrades.