Question about little photo stick
7 years ago
Featured Answer
Sort by:Oldest
Comments (10)
- 7 years ago
- 7 years ago
Related Discussions
Question about potting little ones together...
Comments (7)I've done things like that several times. Usually, for expediency, convenience or a more full appearance.;~) It's sort of like hilling in a tree for dealing with later. Different types used different methods. I had a large group of Stans that I just spread out through a large shallow plastic bin and filled with NZ sphagnum. I also, did a s/h with sphagnum for three young Stans of the same type and they've done well. That was to have a larger looking plant from the start. I haven't decided, yet, whether I'll separate the whole later. I also had a large number of Catts that I put all together in a group semi-hydro planting. This is the only photo I have of the Catt group. It's from this past winter and they're in the bottom right corner. Several are even in bud, now much later. I took two plastic storage containers and stacked them. The top one was carefully drilled with many small holes. (Like a collander!) I filled it with clay pellets and added the plants with tags attached for later ID. The bottom one is the water resevoir, plus, it adds additional strength. They were all intended to be temporary, but...!;~)...See MoreQuestion about little gem magnolias
Comments (13)Thanks for your responses, and njoasis, I will go outside and try to get a good pic of the leaves. hoseman.....I'd say on the tree that looks the worst, about 30 to 40% of the tree is affected. On the other, about 10 to 20%. There is a VERY large pile of leaves on the ground today after the bad storms we had yesterday. It is definitely a much larger amount than in years past, and I don't recall seeing the black spots in previous years. These tress had a rough start. We bought them while living in Atlanta, and paid $200 a piece for them. They were growing on a lattice. I know there is a name for that, but can"t think of it at the moment. Our intention was to keep them pruned and growing on the lattice, because it was so pretty. Shortly after planting them, (abut 6 mos) we were transfered to Birmingham. We asked the new owners of our home if they would mind if we planted something of there choice in their place, as we would like to take them with us. They were not plant people, and wanted no plants or trees in the back yard, so they were more than happy for us to take them. We also took all of my rose bushes, which are also doing great. We carefully followed the advise of someone on these forums, dug the trees up, put in a huge pot and moved them. Our house was being built so we left them at my Mom's form April until October. We re-planted them in our new house, and prayed. That was 4 years ago this October, and they were flourishing and absolutely gorgeous, even though the advice was it was risky to dig up nd move them. We eventually removed them from the lattice, because they were growing so fast it was becoming increasingly hard to keep them pruned on the lattice. They grew into lovely trees, about about 13 feet tall now. After all the work, and TLC these tress have received, I would be heartbroken to lose them now. I will post pics as soon as I can....See MoreQuestion about induction cooking-- big pans and non-stick pans
Comments (19)I have had induction almost 2 years now. LOVE IT! I found my large, non-stick skillet at Bed, Bath, & Beyond. It is a Farberware. It works great and is holding up great after 2 years of use. My small non-stick skillet I got at TJMaxx - a Tivoli - also holding up well. Both were well under $50 each. Also, I believe you will find that some induction cooktops largest burner is larger on some units than others, and the placement of the largest burner is different depending on the manufacturer. The size and placement of the largest burner was the deciding factor in my purchasing decision. At the time I shopped (there are lots more choices on the market now) I found the 30" GE Profile to have the best for me - one of the largest burners, and placed to the front of the unit (I'm short and don't like to reach over other pans if using my large fry pan). So, that's what I went with and it's been great! I have not found the 30" to be crowded at all - but, again, I think it's because of the way the burners are layed out. Hope these insights help as you shop around. Good Luck!...See MorePeel & Stick - little hand holding, please? :-)
Comments (6)the glues cure time depends on the relative humidity of the area, so drying time varies. Dry set adhesives have to be completely dry to the touch before tile is installed. Probably between 1 and 3 hours. Please use recommended trowel notches for the adhesive you use and dont let any puddles on the floor. Rake it down. Blowing fans on the spread adhesive helps to facillitate drying. You want a dry-set vct adhesive. I have no idea if home depot carries them or not. I have no idea what you mean by, "how long do you have to peel-n-stick" once the glue is set. If you mean how long will it take you to peel the bakcing off the tile and stick the tile to the floor, then again, that depends on your speed, and if it is a full field tile or a cut tile. A few hours probably. It can be walked on immediately. In fact, its best to walk over the whole area after installation to help set the tiles firmly in the glue ... rolling the floor with a 75-100 pound roller is best but walking will suffice. You should also be formly pressing each tile into the dried adhesive as well as you are installing it. Applicances can be placed back immediately, but please protect the new floor with thin masonite or plywood. Dont roll appliances on the new floor without protection. 1 or 2 pieces of cheap luan underlayment plywood cut into managable 4'x4' pieces should suffice and you can get them at home depot. They will even cut them for you. Move the applicance onto a piece, set another piece in front of it, roll the applicance on it, then pick up the previous piece and place that one in front, repeat until the appliance is positioned where you need it ... all without the applicance touching your brand new floor. here is home depots website for traffic master tile ... everything you need to know from a to z. read up and follow instructions to the letter. traffic master tile...See More- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
Related Stories

EXTERIORSCurb Appeal Feeling a Little Off? Some Questions to Consider
Color, scale, proportion, trim ... 14 things to think about if your exterior is bugging you
Full Story
ORGANIZING4 Questions to Help You Organize Your Favorite Photos
Organize your keeper photos with a system that's just right for you, whether it's in the cloud or you can hold it in your hand
Full Story
ARCHITECTURE10 Things to Know About Prefab Homes
Are prefab homes less costly, faster to build and greener than homes constructed onsite? Here are answers to those questions and more
Full Story
LIFEHow to Be More Intentional About Sentimental Clutter
These 7 questions can help you decide whether to keep, store or let go of those once-meaningful objects in your life
Full Story
GARDENING GUIDESNo-Regret Plants: 5 Questions Smart Shoppers Ask
Quit wasting money and time at the garden center. This checklist will ensure that the plants you're eyeing will stick around in your yard
Full Story
ORGANIZINGPre-Storage Checklist: 10 Questions to Ask Yourself Before You Store
Wait, stop. Do you really need to keep that item you’re about to put into storage?
Full Story
REMODELING GUIDESConsidering a Fixer-Upper? 15 Questions to Ask First
Learn about the hidden costs and treasures of older homes to avoid budget surprises and accidentally tossing valuable features
Full Story
GREEN BUILDINGConsidering Concrete Floors? 3 Green-Minded Questions to Ask
Learn what’s in your concrete and about sustainability to make a healthy choice for your home and the earth
Full Story
HOUZZ CALLTell Us: What Puzzles You About Holiday Lights?
Share your questions about and strategies for holiday lights with the Houzz community
Full Story
WORKING WITH PROS8 Questions to Ask Yourself Before Meeting With Your Designer
Thinking in advance about how you use your space will get your first design consultation off to its best start
Full Story
colleenoz