Has anyone turned on their furnace already?
7 years ago
last modified: 7 years ago
Featured Answer
Sort by:Oldest
Comments (51)
- 7 years ago
- 7 years ago
Related Discussions
Potting a bulb that has already sprouted
Comments (23)I have never used chamomile tea as an anti-fungal, so I don't know what to tell you on that... I do know that cinnamon is a good anti-fungal, however it does tend to retard root growth. I've switched to using Captan as my main anti-fungal when treating bulbs for any rot issues. I also use a bit of rooting hormone powder when re-potting bulbs that have rotted roots or have had surgery. Maybe I'm wrong, but it sounds like your watering habits could be part of your problem... hippeastrum bulbs prefer to dry out a bit in between waterings, and they hate "wet feet". They require a medium that drains very well and doesn't hold moisture for too long a time. When you're checking your pots to see if they need watering, don't be afraid to stick your finger down into the soil as far it will go! When the soil feels just about dry at root level, it's time to water. The soil ball will remain moist under the bulb, at root level, longer than the surface inch or so. Careful watering is the key to healthy containerized bulbs! If you feel your fingers are too large to stick down into the soil, you can use a wooden skewer to gauge moisture at the root level. I do this with my orchids... I insert the pointed end of a bamboo skewer down into the medium and I leave it there... I take it out every once in a while and press it to my cheek... if it feels damp, I hold off on watering. When it comes out feeling dry, I water. The skewers are available at any grocery store at about a dollar a package, or so. Bottom heat can sometimes help reluctant bulbs resume growth... a heat mat is a good investment for indoor gardeners. Large commercial greenhouses use them to stimulate root growth on cuttings or for seed germination. I place my pots of bulbs on the mat when they need a little help re-growing roots, or are reluctant to grow. And of course, the bulbs require decent light for optimum growth and bloom. I keep my favorite bulbs in my east window, which provides them the morning sun they seem to like so well. I would prefer to keep them in a southern window, but there's too much shade at the only one I have available. I hope this gives you something to think about... perhaps there's something needing change that you're not aware of... on the other hand, some bulbs are simply reluctant growers and any disturbance seems to throw off their blooming....See MoreYork Furnace - blower motor only sometimes turning on
Comments (6)because fan runs in fan on(according to him) . ran just fine in a/c according to him the only common thing that doesn't run is low speed fan for heat. low speed fan is turned on by different relay on control board than high speed fan (which works according to poster). can't be cap because cap doesn't work sometimes and not others. can be low on capacitance and overheating motor but it still would not run ok some of the time as stated. best i could do with info given....See Moreturning the furnace on
Comments (69)What makes indoor air drier in wintertime is the low relative humidity of cold outdoor air that, when warmed, has an even lower relative humidity. The source of the heat shouldn't matter. Forced air heat can be more, not less, comfortable because many in cold weather places are regularly fitted with humidifiers. What IS true is that radiator or other radiant (like in-floor) heat is more comfortable insofar as it is more gradual and steady than a periodic blast of hot air. Along with radiant heat being gradual is the negative that warm-up from a setback can be very slow, much more so than forced air. Every approach has benefits and weaknesses....See MoreFurnace turns on BUT no air
Comments (37)Hard ducts (usually made of galvanized steel) don't often need to be replaced but over time, the many seams where pieces fit together get loose and develop gaps. Sometimes the seam points are inadequately sealed from Day 1. Also, gaps can be common in plenum junctions. The best sealing is done with mastic, a rubber like compound that's painted on and dries. The cheaper and lower quality approach is to use tape but mastic tape, not so-called retail "duct tape". "Flexible ducting" is made of plastic that will deteriorate over time and can need replacement. Flex ducts can also develop crimped points (like a crimped cheap garden hose) from suspension points and holes from animal activity. And can also wiggle loose at connection points. Holes in ducts cost big bucks if not fixed because the heated or cooled air isn't being delivered to where it's supposed to go. Additionally, if the leaks are outside the interior, as in an attic or crawl space, outside air gets sucked in to replace what's blown out the leak. Cold air in winter, hot air in summer, gets sucked into the house. In my state, duct leak testing (done by a third party, not the HVAC contractor) is required whenever equipment is replaced or installed and a permit is pulled (as it should be). If the ducts fail the test, repair of all visible/accessible junctions is needed until the max leak standard is achieved or until all that can be accessed has been fixed. No walls need to be opened up. Edit to add: Sorry, probably too lengthy a comment. I wanted to share what I've learned....See More- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
- 7 years agolast modified: 7 years ago
- 7 years ago
- 7 years ago
- 7 years ago
Related Stories

CLOSETSThe Cure for Houzz Envy: Closet Touches Anyone Can Do
These easy and inexpensive moves for more space and better organization are right in fashion
Full Story
MUDROOMSThe Cure for Houzz Envy: Mudroom Touches Anyone Can Do
Make a utilitarian mudroom snazzier and better organized with these cheap and easy ideas
Full Story
KITCHEN DESIGNThe Cure for Houzz Envy: Kitchen Touches Anyone Can Do
Take your kitchen up a notch even if it will never reach top-of-the-line, with these cheap and easy decorating ideas
Full Story
HOUZZ TVHouzz TV: This Dream Midcentury Home in a Forest Even Has Its Own Train
Original wood ceilings, a cool layout and, yes, a quarter-scale train persuaded these homeowners to take a chance on a run-down property
Full Story
SHOWERSTurn Your Shower Niche Into a Design Star
Clear glass surrounds have raised the design bar for details such as shampoo and soap shelves. Here are 4 standouts
Full Story
HOME TECHComing Soon: Turn Your Kitchen Counter Into a Touch Screen
Discover how touch projection technology might turn your tables and countertops into iPad-like devices — and sooner than you think
Full Story
DECORATING GUIDESThe Cure for Houzz Envy: Dining Room Touches Anyone Can Do
Get a decorator-style dining room on the cheap with inexpensive artwork, secondhand furniture and thoughtful accessories
Full Story
MOST POPULARYou Can Turn That Into a Bathroom Vanity?
Find inspiration in 13 unconventional bathroom vanities that are as functional as the real deal
Full Story
GREAT HOME PROJECTSTurn That Spare Room Into a Walk-in Closet
New project for a new year: Get the closet you’ve always wanted, starting with all the info here
Full Story
HOUZZ TOURSMy Houzz: Turning a Netherlands Barn Into a Country Home
Once a place for chilling milk, this Dutch home now lets the owners chill out in easygoing comfort
Full Story
marilyn_c