I haven't but I'd be interested in the feedback that you get. I'm currently sourcing out 1 more solid wood door for the last closet upstairs. I keep combing Craigs List which is where I got the last solid wood 6 panel door but 36x80 solid wood panel doors are few and far between on CL here. This wek I started checking out stores for the last door. What is Nicks Building Supplies?

Painting can be much more difficult than staining. It depends on who the craftsman is. Painting a 6 panel door must be done according to the manual or it will look terrible. If you choose to paint them, email me and I'll send you the "how to paint a 6 panel door" instructions. Staining it requires knowledge too. The pine should be pre-treated (conditioned) prior to staining since it's a porous wood that absorbs stain unevenly. All paint stores sell the conditioner. After staining, apply at least two coats of varnish or ceramathane with the door is in a horizontal position to prevent runs. If you spot a run after a minute or so, trying to tip off those products creates more of a mess. If you decide to paint, the first coat should be a quality underbody primer. Please.....don't skip the primer. That seals the door and sets it up for the final two coats of paint. An ordinary latex paint will look clumsy on a door. You should learn how to paint with the Waterborne finishes (Muralo Ultra) (BM Impervo) (SW Pro Classic) or a urethane product like Cabinet Coat trim enamel.. Those will provide a hard, porcelain-like finish, which is what performs best on a door. You will also need a high quality brush. A 2" angle sash is best for most hands. Or, you can do like me and use an angle sash to paint the panels, then switch over to a 2 1/2" flat sash brush for the stiles and rails. I wish I had the picture of Moonshadow's doors. She did a magnificent job with Cabinet Coat on hers. My doors are done in Pro Classic and unless you've had some practice with it, it can be very, very difficult to get a professional finish. Michael Here is a link that might be useful: I found Moonshadow's doors

Try Craig's list. $200-$300.

"What do you recommend for installation?" A true rift and quartered solid 5 1/4" only needs to be nailed (I don't like staples) providing you have the relative humidity in check in all areas of the dwelling. No need for gluing. That reference comes from plain sawn (regular) hardwoods. "Not a professional, but much of the "engineered" hate seems to stem from the past." Thanks sprinkles. There are still a good number of 'old schoolers' out there too that only want the real thing. Take your time and understand the differences. There can be a lot to know.