I wouldnt bother, I have never seen pavers damaged by salt. If you have a dog or something that gets in and out of the pool in one place alot, then just hose off the pavers in that area occasionally, so the salt doesnt build up. Once you seal, you have to continue to seal, creates a mess.

For other Houzz users, should they stumble upon this post, here is what my pool contractor had to say on the topic: "We have not noticed a difference in a saltwater pool over a traditionally chlorinated pool when it comes to tile selection. All tiles rated for pool use are tested to stand up against chemicals, saltwater, and freezing. We have seen that the of quality pool rated tiles, whether matte finish or glossy, are affected about the same when it comes to salt water. Put another way, we have never had any homeowners or any of our pool servicemen, notice or point out a difference. All tile will develop a light scaling right at the waterline over time. Salts and calcium in the pool water are always in solution, or in other words, suspended in the pool water. But when the water touches the tile, then some calcium and salt deposits can cling and dry leaving behind the a very slight film. This is usually very slight but can build up over time. Were talking usually several years. When this happens, there are a few things that can be done to remove that light scaling. Another reason we get scaling on the tile over time is because, it is right at the surface of the water where a lot of the chemicals in the water come into contact with the air, causing a slight chemical reaction. This reaction can create a light scaling. Also keep in mind, a saltwater pool and a liquid chlorine treated pool both have a good amount of salt in the water. We sometimes see a whitish light film develop on pool decks where pool water splashes onto the deck over time and evaporates, leaving behind a light film. What often is more of a problem than scaling, is the presence of oils that mix with dirt to create a dirty film that adheres to the waterline tile. This is caused by natural body oils but is more of a problem when suntan lotions and other applied body oils. This is pretty easily removed with a light brushing using liquid detergent. Adding some available enzymes to the water also helps a lot. The whole reason that tile is installed on any pool is because these conditions are anticipated, and so when scaly deposits or oily film deposits develop, these expected issues can be addressed easily, as tile is easy to clean. Having said all of that, I don’t think it would make a noticeable difference whether you choose matte finish-which I like better, and a glossy finish. The only thing I would recommend is that you stay with a lighter color, as scaling is typically lighter in color and shows upon more against darker colors. And if you go with a more natural stone like look, then any discoloration should also be less noticeable. The only place that we typically see the light scaling and filming on a pool like yours sooner rater than later is, at the spillway between the pool and spa. Thus, this tiled area will be subject to more oxidizing effects. This is normal. Bottom line- I don’t think it matters either way, matte finish or glossy finish as long as you choose lighter colors."

Here are some ideas using a variety of hardy gingers:

I currently have a casement window in my shower, and yes, it has a screen, and we do use it to vent after a shower. It is a vinyl casement and we trimmed it out (inside and out) with exterior composite trim material. My husband is a building contractor, and always mindful of issues. We towel down the trim EVERYTIME we shower, not so much for water rot worries, but for soap scum and water stains. Soap residue will show on any surface, whether or not the water air dries. It's great to have natural light in the shower, not to mention fresh air. Enjoy your shower window.