I agree, do dare - it's your place to do whatever you wish, RIGHT!!! Neighbors thought I was a nut case when I punched holes in the tops and bottoms of CD's you get in the mail, put two back to back so the shiny side was on the outside and then strung them together with fishing line (leaving about four/five inches in between each CD) and then hung it from my shed roof. The sunlight hitting it created a kalidescope of colors that would swirl around. My cats loved it also as the colors raced across the ground. It was funny to watch them chase the lights.

Yeh because your description makes me want to see it.

spam

Image by: chaos_quilt Blue Bottle Wire Art by chaos_quilt Blue Bottle Wire Art Suncatcher Dangly Thing Another talented Garden Junk forum member shares a project with us Directions for the "Twisty wire, blue bottle, dangley-thingie" by Member chaos_quilt What was used: * Dutch Boy lead-free silver solder wire * Oatey lead-free solder wire * Cobalt Blue Bottles * Piece of bamboo fishing pole cut to desired length * Various skeleton keys * Thin gauge wire * Green and Blue crystals * Blue beads (from thrift store necklaces) * Chain and various other doo-dads How it was done: I only used a pair of needle-nose pliers to twist the tight curls on the tips of each wire...I did wrap the tips of the pliers with tape to keep from scratching the soft solder. I used two different kinds of solder wire...Dutch Boy lead-free silver was the easiest to form curls with, but the Oatey lead-free was cheaper and sturdier, so I used it, too. The solder is very easily bendable with just fingers, and is surprisingly easy to make patterns with. Also, if you mess up your bend, you have a little leeway with the solder to unbend and start again...you just have to straighten it out carefully. Each bottle has it's own hanger -either a loop in the solder, or a silver chain link...I took two long pieces of the Oatey solder, made a loop on one end of each, and inserted the other end into the hollow bamboo rod. Then I took a long piece of solder, attached it to the loop on one end, and spiral twisted it around the bamboo from one end to the other, attaching a bottle or key swirly at the bottom of each twist. Then I hooked it to the loop at the other end and tied on a shoelace to hang it from two tacks on the top of the window frame. They all hang from a length of bamboo fishing pole that I cut short. I think you could just twist the solder around whatever kind of pole you're attaching the bottles to, though, and make a hanging loop at each end, but I wanted the solder to go into the bamboo to give it enough strength to hold all the weight. The skeleton keys are hanging on a thin gauge wire so I could fit lots of green and blue crystals on, plus some blue beads, all from old thrift store necklaces. Hints and Tips: The Dutch Boy solder was found in the plumbing department at $5 a roll. The Oatey, sturdier, was $6 for a longer roll. The bottom picture shows how everything is attached to the bamboo...this works really well to hold everything on, and was so simple to do. When I am unwinding the solder from the roll, I really try to straighten it out...then just twisting and turning it by hand, it seems to curl just right. There is a lot of leeway in redoing the curls if yours don't turn out the first time, as long as you don't kink the solder. The window is just glass with a cling on it. They let lots of light in but give a lot of privacy, and are under $20 each, with lots of beautiful florals and patterns. And ....... "This is the most enjoyable craft I have ever made" (and may I add to that, so far we hope!)