HELP! Do we need 4 dummy door knobs?
cflaherty
12 years ago
Featured Answer
Sort by:Oldest
Comments (16)
cflaherty
12 years agoredcurls
12 years agoRelated Discussions
Outdoor grill advice needed for dummy with specific cooking needs
Comments (23)Don't know if you have already made your decision, but I would actually describe the burners opposite of idrive65. Front to back to me describes the direction the burners run front to back with them left right and perhaps several in the center. That means that for indirect heat (slow cooking for ribs, brisket, whole poultry and large meats) you can use one or two burners on one end and cook on the opposite end, one on either end and cook in the center, use the center burner(s) and cook on wither side -- gives you options and full use of the front to back grill space. With side to side (not side by side) are burners going across from one side to the other where you have one front back and center. For indirect heat, your options are to use the back only or the front and back and cook in the center. You have the full width of the grill to cook, but less room front to back and the heat may be less indirect for whatever you are cooking. Webber has 3 different types of grates and different stores may carry one or two. Cast iron sears (may give a bit more char flavor) and retains heat well but rusts most easily (they suggest not cleaning after cooking so that the oils from cooking protect the grates until you preheat and burn them off when you cook the next time). Porcelain coated have protection from rusting, but some may feel they don't retain heat and sear as well as cast iron. We've used both and never had any complaint with the porcelain-- the rust factor probably makes it a better choice in our climate). Stainless is an option that comes standard on the higher end Summit grills or as an option or additional purchase for the Genesis. I've cooked on the other ones so long I wasn't sure about the stainless even though the rust proof definitely appealed in our humid climate. We were thinking about it when I realized the charcoal grills I've used all have stainless grates and the Summit ones were heavier and should do even better. So far, they've been working very well. I can cook happily with any of the grates, but the use of space -- having enough, being able to use it efficiently for large of small cooking needs and having it arranged well for what you want to cook would be what I would focus on. The burner direction matters most if you pile charcoal to one side and cook on the other. If you usually place evenly across the bottom, it may not matter to you at all. Have fun looking and hope you find one you enjoy....See Morehelp pls: entry door w adj closet - swing out? dummy sidelite
Comments (18)Thanks Lyfia! All three ideas could work well. The closet wall currently would be between the two transom windows, so it wouldn't block either. Still, I especially like your idea of putting in a nice PAX closet, at least initially. A 59" (or 49") PAX closet, with a bench or plant in front of the left sidelite. I think that could work very well (if DH will be willing to be unconventional. I'm from Europe, so I'm quite used to wardrobes and no closets). I've been wanting to do a closet organizer anyway, so PAX could accomplish that. And, as you'd said, it means we could see what the space really feels like after we move in. This makes me wonder whether the entry door should be 2'8" rather than 3'0" wide. A smaller door might make the space feel larger ... and would leave more of the closet accessible. I'd assumed that 3' was more practical for bringing in fridges, couches, etc. But if 2'8" is a standard, then there must be other ways movers cope with massive furniture. Thanks! Very interesting ideas for me to sleep on. :-) (Yawn)....See MoreHelp with mounting a range hood---do we need to modify the wall?
Comments (6)You can cut a piece of plywood (like 3/4" thick) and mount it on the wall to span the studs, then use that to mount the hood to. It will cause the hood to stick out that much further from the wall, so that might mess with your clearances. About mounting to the lath, depends on what you have. Now it your lath is like what we had upstairs, darn stuff was 3/4" by about 4" wide, with groves milled in to hold the plaster - and firmly attached with larger nails - even with a big pry bar that stuff held firm - and hard - wore out blades trying to cut through it. You could mount just about anything to that. Most of the house had the standard 1/4" thick by 1" wide lath strips - the kind you can break across your leg with minimal effort. Held on by 1" wire nails - very easy to pop off the walls. (they make wonderful fire starter- but mine are also 75+ years old). I saw lots of evidences where previous owners had mounting things to the walls. Sometimes the screw hole would be about 1/8" from the edge and the lath was split, sometimes they used a bit too much force and stripped out the threads that formed in the lath. From what I saw, I'd have no confidence using the lath for support other than to hang small pictures. if you go that route, you need to put in toggle bolts, not screw it to the lath. It could cause flex in the wall, and over time the plaster may crack. If you plan on tiling your backsplash, any flexing will could also pop off the tiles. For me, I'd be cussing, but I'd be finding a way into the wall (either front or back side, which ever is easier. Though with plaster that is a total pain, sheet rock is easy. Otherwise I'd be paranoid the fan it going to end up through my cooktop. We never mounted a fan to the wall, but we did have an OTR range that mounted to the wall and the upper cabinet. BTW - a good way to put in supports is to make a box out of 2x4's and then insert the box in between the studs, and attache the "sides" to the studs. No toe nailing needed, so you won't split the ends of the 2x4's. We had a lot of places we had to frame up using that method as we didn't want to open the wall up any farther than needed (just center line of the studs....See Morereach-in closet door knobs--needed on the inside?
Comments (3)Seriously?! Why? No, that's how the dummy knob got the dummy name. It doesn't DO anything . But it IS a three year old thread, so I think the operative word her might indeed be "dummy" in all regards and yes, I'll include myself: )...See Morekawh707
12 years agocflaherty
12 years agobmorepanic
12 years agocflaherty
12 years agonatal
12 years agocflaherty
12 years agobreezygirl
12 years agoUser
12 years agonatal
12 years agocflaherty
12 years agoUser
12 years agocflaherty
12 years agoJill
3 years ago
Related Stories
KITCHEN DESIGNPopular Cabinet Door Styles for Kitchens of All Kinds
Let our mini guide help you choose the right kitchen door style
Full StoryGREAT HOME PROJECTSNew Hardware Gives Doors a Turn for the Better
New project for a new year: Get a handle on how to find the knobs, levers or pulls that will make your doors memorable
Full StoryUNIVERSAL DESIGNMy Houzz: Universal Design Helps an 8-Year-Old Feel at Home
An innovative sensory room, wide doors and hallways, and other thoughtful design moves make this Canadian home work for the whole family
Full StoryWHITE KITCHENS4 Dreamy White-and-Wood Kitchens to Learn From
White too bright in your kitchen? Introduce wood beams, countertops, furniture and more
Full StoryDOORSDiscover the Ins and Outs of Pocket Doors
Get both sides of the pocket door story to figure out if it's the right space separator for your house
Full StoryKITCHEN DESIGNGet a Grip on Kitchen Cabinets With the Right Knobs and Pulls
Here's how to pair the right style, type and finish of cabinet hardware with your kitchen style
Full StoryDESIGN DETAILSThe Secret to Pocket Doors' Success
Pocket doors can be genius solutions for all kinds of rooms — but it’s the hardware that makes all the difference. See why
Full StoryDOORS5 Questions to Ask Before Installing a Barn Door
Find out whether that barn door you love is the right solution for your space
Full Story4 Easy Ways to Renew Your Bathroom Without Remodeling
Take your bathroom from drab to fab without getting out the sledgehammer or racking up lots of charges
Full StoryMOST POPULAR11 Reasons to Paint Your Interior Doors Black
Brush on some ebony paint and turn a dull doorway into a model of drop-dead sophistication
Full Story
breezygirl