We looked at sinks for a couple of months. Some of the companies don't site what size sink base to use for a particular sink. We chose American Standard's SS Culinaire 2 basin sink, one large basin, one small. I called the company and they did not know what size sink base to use. I chose 36" based on the width of both bowls, the divider in the middle and about an inch on either side for clips. Get the installation specs. and you can read what size the sink's basins are. KM has, if I remember, 3/4" thick sides on their cabinets so you would have a 28 1/2" space for the sink's bowls, divider and clips, if a top mount, to fit in. I called both Kohler and American Standard for information and the youngsters don't know much. The Supervisor at AS didn't know what size sink base either. How can they sell their products without all the necessary information is a mystery to me. I pray our sink fits! The woman at the plumbing store didn't have that information either. She called AS for us, got her person, and he didn't know either! Best to ask many people the size SB question.

It depends. If this is an undermount AND you know the interior dimensions of the sink base(a) AND you can find a drawing of the silgranit sink showing the outer dimensions of the BOWL (b) - or ask if someone can measure it for you AND if (a) > (b) then it most likely can fit - possibly with a little trimming of the top of the sink base - so the lip around the bowl is flush with the top of the cabinet. You might also check front to back inside the cabinet and the position of your faucet, subtracting for any obstacles -like a window sill - that project from the wall and the thickness of backsplash material. Sometimes, both the sink and the faucet can't fit and sometimes the sink and faucet can fit, but you can't use the handles.

It is more than possible. It happens, and not infrequently, for contract productions of just about everything. In a country with little to no worker protection, consumer protection, or enforceable quality control standards,what someone says that they produce is not always what they are actually producing. It is not xenophobic or racist to urge major caution based on those numerous past instances of fraud, deceptive labeling, and downright unsafe to the end user products being produced. Yes, there are better quality import products, but those are usually produced in company owned and quality controlled plants. The bottom line is always going to be, if something is too good to be true, then it IS too good to be true. There is a hidden cost somewhere. That cost might be using recycled radioactive steel scrap for your stainless sink. Or high lead based glazing on pottery or sinks. Or a corrosive binder for gypsum board. Or a toxic paint. Or a formaldehyde content testing forged. Or thinner materials, or an incorrect alloy. All of that has happened. And how you can ensure that it does not happen to you is that you do not take the chance on a marketing created American, British, or German sounding named entity that contracts everything out to the lowest foreign bidder factory that can be found. If you are going to buy import, at least buy a real American company's products that have real warranties and quality control over their own factories in foreign lands. All of those Chinese companies should take a lesson from Haier. Bottom of the barrel quality Chinese government owned company does a virtual 180 by destroying poor quality produced goods, buys a major Aussie appliance manufacturer (Fisher and Paykell) and now has bought out GE. Those are foreign created products that pass independent quality control testing, and consumer real world use. Don't hide the fact that the products are import sourced. Be like Japan did after the war when it was the butt of all of the poor quality joke goods flooding the US market. They created modern factory quality control standards, and now have one of the highest reputations for quality in the world. Just because something is a Chinese import doesn't automatically make it bad. It does automatically make it suspect though. Especially at a too good to be true low price.

Thank you . Here is a drawing of the shape and dimensions. Also what do I do with the section of granite that tapers down to 20 then 14” deep? Appreciate any help to make this granite work.