Would love some help/advice about re-painting/re-staining a fence & deck. Pictures attached. I plan to take these pictures along to the local paint store - where the professional painters go. I made the mistake of trying to "paint" the deck floor with a colored stain before - went to Fleet Farm - so I deserve the advice I was given. I think that maybe I used a latex paint over a surface that had originally used oil. It peeled up pretty quickly. I'm looking to replace the deck and fence in 3 years, when I pay off my car and could take a loan out for the new deck/fence. The deck and fence were original to the house when I bought it 11 years ago, and I would guess that means they are from 1983. I used Googone (didn't have nail polish remover in the house) to "test" the painted areas. Googone dissolved the paint on the deck floor - must have been the latex I used a few years ago in my first attempt. But Googone didn't pull any color from the deck fence, so I wonder if that is oil-based. What do I need to know about tackling this job on my own? This is all of the photos that I can upload for now. Having issues with tinypics website at the moment. Thanks for your help.

Thanks, I will try to sand a scrap to see if it will take. The ipe is going to be 116 and the cedar 103 assuming it takes the stain, it makes a nice contrast with the color of bamboo. It might just have to go au naturelle for a while. It will look similar to this when finished, except the panel is bamboo, the frame is ipe, and the cap railing and posts are PO cedar. http://www.eichlerforsale.com/xsites/Agents/eichlerforsale/content/uploadedFiles/Fence_Wood_Eichler.JPG

In my opinion one of the best ways to preserve a treated pine fence (especially posts that are buried) is with sump oil. Or you can use linseed oil. The people on one side of me did not want me to soak their posts in sump oil in order for it to soak into the timber. In fact they called me a nutcase for sugesting it would extend the life of them. For the record the posts are (hardwood) Australian redgum. Pailings are 13mm teated pine and the rails are 50x75mm treated pine. On the other side, where i have native bushland I did soak the base of the post in sump oil for just over 48 hours before putting them in the ground. I then sprayed the fence with sump oil. The untreated (much more wind protected) fence ended up with 4 posts snapped off at groung level they were rotten. There were pailings blown off etc etc. The fence on the other side off my home (which copped the FULL force of the wind is still nice and straight and still in good order. I still can't even wobble ANY post one bit. Both fences were put up together 17 years ago when we built. Another thing sump oil does is prevent termite attack. (If the buried part is soaked for 24-48 hrs before cementing them in). don't think that "treated" pine, or any other 'treated' timber will stop termites the chemicals leach out over time. Now the people next door want me to pay 1/2 for a new fence. I took them over showed them the other fence that was oiled and asked can you see any problem here. The grass is growing, as are all the plants there is no issues there. It's not as if i just poored oil all around the posts so the impact on the enviroment is infenticimal if at all. very little (if any) oil leaches out if they are soaked) the timber holds the oil inside it. If you don't want sump oil on your pailings then liseed oil is the next best thing. It is moisture that rots the timber(creates the enviroment for rottting) oils will repel the water keeping the as dry as posible and thus extending the life. And preventing yet more trees from being chopped down to cut into posts, rails and pailings. In fairness I said to those people next door if you buy all the materials I will help you put it up. But I am not paying 1/2 the cost for a fencing contractor to build another fence simply because you refused to take WELL KNOWN advice and called me a nut case in the process. Why should I fork out $2,864.00 (that's my half) simply because you chose not to listen to good old fashioned and well known advice. When I asked if he was prepared to pay half for the damage to my new garden bed, plants, shrubs and some other things I had stored where the fence fell on it all and brokes new shrubs etc he said "oh that's not my fault" "Can't you claim it on your insurance?" When asked why he isn't claiming his fence repairs on his insurance he said "Oh I don't have insurance". I said what happens if your house burns down how can you afford to pay the mortgage as well as the cost of living elsewhere. "Oh it won't burn down" was the answer I got. GO FIGURE.

White paint will last much longer and with much less maintenance. If a wood has any color at all---as in pressure treated----the white stain will be next to useless. It will look more like washed out white wash. Plus, the sun will fade it in a short time. Shouild you decide to paint the fence, you will need to use a good sealing primer first, such as Bullseye 123 from Zinsser or most oil based primers will work. Oil based primer is a bit more difficult to apply, however, than water based 123. Then use a good exterior latex enamel house paint. Pressure treated wood, when dry, can be painted immediately. It is difficult to get a large number of dry pickets, however. Wet ones---that ooze noisture when a screw head compresses the wood----will need 4 to 6 months to dry. Cedar can be painted on installation, as a rule. But using cedar, which is naturally weather resistant, and painting it is kinda expensive.