From January 2011, here is the original text by Bob_71 (not sure where this went to in the FAQs, some of part II is there) --------------------------------------------- Camera settings for butterfly photography One of the finest pieces of marketing, ever, has been the coining of the phrase "Point-and-shoot" camera. In three simple words it promises the ease of operation of an old Kodak Brownie and that you will be able to produce National Geographic quality photographs. Few of us ever produce pictures of such high quality...but we could! The new digital cameras have capabilities beyond our imagination! Unfortunately, the operator's manuals are written by the brilliant young engineers who have grown up with the technology and the language that surrounds it. They fail to understand that many buyers of cameras received their education somewhere around the middle of the last century...many (most?) of the terms in the manual did not even exist at that time. The language discourages these readers so the manual gets lightly scanned, or ignored. When this happens, the camera is used poorly and often with the wrong settings. This mini-tutorial is my attempt at simplifying the language while suggesting the "tweaks" that I use to customize my camera. My goal is to be able to walk outside, observe the weather conditions, make one setting adjustment to compensate for the existing weather and then to "point-and-shoot" all day with reasonable expectations of high quality photos. The camera manufacturer has to produce a camera that is set up to take average pictures in almost any area but it is NOT set up to take OUTSTANDING pictures of anything. Whether the customer will be using it for architecture, landscapes, sports, portraits, or for butterflies, the many settings will have to be set for that purpose. When all the settings are correctly tweaked, the digital camera becomes capable of coping with the special requirements in a simple and straight-forward manner. There are two settings that are paramount in achieving quality, regardless of the subject matter. The first of these, and the most critical, is usually referred to as the IMAGE RECORDING QUALITY. In my opinion, it is a setting of the past that has outlived it's time. When digital cameras first came out, storage capacity (same as number of shots on a roll of film)was quite low. For example, the memory space within your camera might allow only twenty-five high quality pictures before running out. To boost that, they added software that would allow you to increase the number of shots that your camera could store up to a hundred shots. The trade-off was that in order to do so, they had to reduce the size of the file for each picture which, in turn, reduced the quality drastically. You ended up with 100 lousy pictures. The high quality that your camera (and you) had shot is gone forever...you can not get it back! Regardless of whether you shoot landscapes or butterflies...this one is a no-brainer, select the option for the HIGHEST QUALITY SETTING available. Set it now and never, ever change it, regardless of what you are shooting. The second setting actually occurs within your editing software. It is a setting that is also designed to allow for smaller picture files (read lousy quality pictures) to reduce memory space usage on your hard drive. This option is based on the same as above...smaller files require less storage space...smaller files equate to reduced quality. Most of us utilize some form of post-camera software to edit our photos before we SAVE them. After you have completed the editing and wish to close and save this file to a folder, it will query you to select the quality level at which you would like it SAVED. No-brainer time again...save at highest quality offered. I have all my photos, at the highest level of quality stored on the same hard drive that I have used for the last four years and that houses everything from my computer. According to my pie-chart of available space, I still have room for over 40,000 photos! Summarizing these two critical options, choose the highest quality for IMAGE RECORDING QUALITY...choose the highest quality when SAVING from your editing software. If you select less than that, you can never get it back! The below montage shows the quality difference that occurs as a result of the above two options. These two photos were shot with a camera on a tripod and with all but two settings identical. The photo on the left was shot with IMAGE RECORDING QUALITY at it's lowest quality option and it was SAVED in editing to it's lowest quality option. The photo on the right was shot with both options at the highest level. (coins image intended for here) Now for the settings that will customize your camera for shooting butterflies. We need to determine the characteristics of butterfly photography that are problematic. They are tiny creatures that rarely fill the frame of the camera...they are defensive in nature which causes them to "spook" as we approach...they can fly...and they are cold-blooded which means that most photos will be taken in full sunlight rather than in easier to handle lighting situations. In my opinion, the qualities that cause a photo to be less than good are poor focus (includes motion blur) and poor exposure. FOCUS:Most cameras have an option for operating in the AUTO focus mode or the MANUAL focus mode. I strongly urge you to opt for the AUTO focus...it is faster, refocuses for each shot and, try as I might, I can not better it's accuracy or consistency. When you select AUTO focus, there are usually about three options from which you must select one. The first is a setting based on shooting still subjects. The second option is for shooting moving subjects and the third is a combination of the two. I get my best results when the "still subjects" option is selected. The butterflies are usually perched when photographed. With my Canon, this option is called ONE SHOT AF. I set it here right after I bought it when I did the initial camera settings and have left it there. EXPOSURE:The amount of light that reaches the sensor of your camera is based on the size of the opening that lets in the light (the aperture) and the amount of time that the light is allowed to come in (the shutter speed). When operating in FULL MANUAL, the operator must select and set both the aperture and the shutter speed. This requires lots of experience and/or a metering device if it is to be accurate. This is NOT my preferred operational mode! On some rare occasions, manual is the best but only rarely! Neither is FULL AUTO my preferred mode. There are two other modes that offer equally accurate exposure but allow for better control of other factors such as stopping movement and depth-of-field. These are called APERTURE PRIORITY or SHUTTER PRIORITY. They are based on the operator selecting either one of these controls and allowing the cameras software to select the other. Without getting into the technical aspects (they are tutorials of their own) the size of the aperture controls depth-of-field (the portion of the photo that is in sharp focus) while the speed of the shutter can "stop" the blurring effects of motion. Thusly, for me, when I go outside to shoot, if the breezes are blowing I select SHUTTER PRIORITY, set the shutter speed at 1/400 second (which is usually enough to eliminate the movement of the flowers that the butterflies are on) and make no further changes unless the wind goes away. If the wind is not a concern, I select APERTURE PRIORITY and select f/5.6 or higher so I get an acceptable depth-of-field. One of the toughest things to overcome in butterfly photography is the required meter readings for proper exposure. The difficulty arises due to the cameras desire to measure the full frame area while the area occupied by the butterfly is only a small fraction of that area. The skittishness of butterflies has taught us to shoot our first pictures when we get to about six feet away. We can ease in further and sometimes we will be allowed to get quite close but we are usually faced with a small bug in a big garden. This requires that we "tweak" the metering settings to conform with reality. With most cameras the metering settings consist of three or more options that serve as choices which control the parts of the image area that will be considered when setting exposures. The first is usually from nine to more than forty somewhat evenly spaced points that are "read" and averaged to arrive at the exposure. This is essentially useless for any small subjects. The second option is called "center weighted" and uses a circle around the center that comprises about 30% of the image area for the metering...better than the first option but still not the best. The final option is the best choice for butterflies...it is called SPOT. It is based on about 3%-4% of the area in a circle right around the middle of which our butterfly is a prominent part. This is how I keep my camera at all times regardless of what I am shooting. It is my belief that this setting is used to influence the auto focus function even though the manual does not specifically state this. One of the main settings for me is one called EXPOSURE VALUE or EV. The person(s) who wrote the software for your camera had to, at some point, make a decision as to what constituted the "correct" exposure. It will approximate the middle-of-the-road point that is not too dark and not too bright. It can vary slightly from camera maker to camera maker since it is a judgmental call. They have all set up an EV adjustment (usually as a slider)that is graduated in 1/3 f/stop increments from -2 full stops to +2 full stops. The camera comes out of the box set to shoot with the exposures that yield a photo that would come with shooting at 0 adjustment. When you adjust to the left or right of zero, you are altering the aim point to either an overall darker image or an overall lighter image. Your camera will still do it's superior job of metering and setting exposures...it's just that you have told it "I like what you are doing but I would like it a little better if your results were just a tad darker". My personal results fit my taste better with -2 increments (-2/3 f/stops).One of the reasons that I select a slightly darker image is that most of my shots are in full sun and the chance of overexposure is great with the vivid colors of the flowers that they nectar on. The second reason is that editing software can correct for considerable underexposure but a picture that is overexposed is mainly lost forever. Burned out highlights are irretrievable. I occasionally shoot a photo that appears a little "off" when I review it on the monitor. When I do, I usually shoot two more photos of the same subject...one that has one increment more than the original and another with one increment less. This is called "bracketing" the exposure. When I edit them, I keep one and trash the other two. A small group of settings that I consider personal taste modifiers include contrast, saturation and brightness. I keep these all at +1...your taste may differ from mine. I do not alter the sharpness setting. I leave it at the manufacturers settings and make any adjustments in my editing software. ISO:These settings serve to modify the sensor's sensitivity to light. Increasing the ISO number allows your camera to arrive at the proper exposure in low-light situations. The trade-off is that you lose quality in proportion to the increase in the ISO number. The reduced quality manifests itself with softer focus, color faults and the introduction of tiny specks of color that increases progressively with the increase in ISO number. Most cameras yield pretty good results up to ISO400...above that can be less than good. I keep my camera at it's lowest ISO setting-ISO 80. When you increase the ISO setting the camera must adjust the aperture or shutter speed. Shooting in full sunlight with high ISO settings can cause your camera to be unable to correct to a proper level of exposure. WHITE BALANCE: This refers to your camera's ability to correct from tainted light sources. Pure sunlight produces shades of yellow, red and other colors at different times of day and based on many other factors. Incandescent and fluorescent lights vary greatly from daylight sources. The internal software of most digital cameras when set on AUTO does a superb job of this. A few years ago, the digital cameras had difficulty with vivid colors like dark red and purple but that is history. The recent cameras capture the toughest colors with ease. If spot-on color is called for, most digitals offer a CUSTOM setting which really works...it is cumbersome but will get the job done. In my experience, improper exposure is more often the cause of poor color than is tainted light sources or improper white balance settings. Recap of Settings: IMAGE RECORDING QUALITY:The highest level available. SAVE QUALITY:The highest level available FOCUS:AUTO with STILL OPTION OPERATING MODE:Aperture Priority if wind is not a problem Shutter Priority if wind is a factor DO NOT SELECT MANUAL EXPOSURE VALUE:(-2) increments=(-2/3) f/stops METERING:Spot WHITE BALANCE:Auto ISO:Lowest number available CONTRAST:(+1) SATURATION:(+1) BRIGHTNESS:(+1) SHARPNESS:Make no change Motion blur appears as a blurry, or improperly focused photo. It is a function of movement that usually is generated at the camera. The best solution that I have found is a good old-fashioned sturdy tripod. Many of today's cameras or lenses have image stabilization capabilities...if your's does, keep the switch ON! It can really help. I sincerely hope that your results give you as much pleasure as mine has given me. Bob

Sharon, I am trying to fathom quail eggs for a reasonable price. I am lucky to be able to get them for free, I have seen them for sale for more then $1 a piece. They are a convenient size when baking as well when you think a recipe would benefit form a little more egg. I am sure all of the topics will help me and be of interest. I struggle with both those topics. Especially the artificial lights in the winter as al our meals are after dark. I am using a DSLR that my DH recently got me and these still apply. -Robin

The Canon Rebel XTI is a digital single-lens-reflex camera. It can be left on Auto and used with the lens it comes with, but, frankly, if that's all you do with it, you're wasting your money. Canon, Nikon, Olympus, Pentax, and Sony all sell cameras worth considering. Some things to keep in mind: - Image stabilization will let you get a better picture in low light and maybe fix some "user errors". But it won't fix every motion problem. You still can end up with blurry pictures. - Don't buy just megapixels. The way the camera handles the picture after you take it ("image processing") is even more important than the number of pixels. For the size of pictures most people will put in their homes, 6-8 megapixels is enough. Worry more about your options in managing the picture. - Watch the zooms. It sounds really good to have a 10x or 15x zoom, but most zooms get really dark at the far end. In addition, image stabilization will work the same at the wide and tele ends of the zoom even though that, too, may result in some unwanted effects. - It really helps to get your hands on cameras you're thinking of buying. Any given camera may seem too small for one person; too clumsy to handle to someone else; too difficult to operate. Take pictures, but also try some scene modes, formatting a memory card, and try deleting a shot. - If you can, either get return privileges or see if the store will either print some of your pictures or display them on a large screen. The little LCD on the back of the camera is not adequate for judging color, sharpness, contrast, or focus. - If you can, shop at a camera shop. Though it may be hard to believe, camera shops will sell the same cameras at the same prices as discount stores or big-box electronics stores. And you usually get the benefit of a wider range of cameras and accessories and a salesperson who isn't just substituting from Small Appliances. I realize this is a lot to read, but it can help you from spending a lot of money on a camera that doesn't do what you want it to do.

LOL! I got my first little Brownie box camera when I was 11. I played with B/W film all during junior high. In high school, I worked on the yearbook and school newspaper--we did only B/W, but all our own processing and developing. Lots of experimenting and talking to other photographers...some workshops. Got the job as a photographer/darkroom tech at the college I went to...met my husband in the darkroom. GRIN (Yep, we've heard ALL the jokes.) By that time, my dad saw the potential of photography. He'd always wanted to own his own business, so he apprenticed with a local pro, then went into business. So...I was a photographer first, but he made it a business while I was in college. After college, and marrying my guy...someone from our church asked us to do some wedding photos...her maid of honor asked and so on...before long I was 24 and doing 50 weddings a summer. Whew. We joined local, regional, and national professional photographer organizations. LOTS of great educational opportunities there...I studied and learned and studied some more. Yes, I learned a lot about lighting. Photography IS lighting...then composition and feeling. It was a fun career. I closed my studio in my early 40's when we had an opportunity to move overseas for a while. By the time we came back, digital photography had swept in...I've learned just enough to do family photos for us. I keep my hand in doing portraits for a few select past clients from time to time. Remember...it isn't the camera, it's the person behind the camera who creates the art. Cameras can make it easier...but the artsy stuff comes from within you. Enjoy it!