Is it possible to finish an unfinished side in a desk?
vidyaram
13 years ago
Featured Answer
Sort by:Oldest
Comments (8)
tinam61
13 years agoYantler0
13 years agoRelated Discussions
Curb side finds: desk and flower table
Comments (6)Wow, nice find, that a nice table. It has that bottom metal piece that crosses that would hold an oblong shaped piece of wood. You can find a piece of wood like that at Michael's Craft Stores, check in the Unfinished Wood Section. Sal...See MoreHelp! Ugly Unfinished Underside of Cambria Quartz Countertop Solution?
Comments (74)I am a fabricator. A plywood underlayment for 2CM is typically complemented by a 4CM drop edge which masks the underlayment on the edge. the plywood is really just a spacer as it does not contribute significantly to the structural integrity of the overhang. For 3CM quartz a "fussy" fab shop will grind the underside of the overhang to remove the printed Logo's from the OEM. If requested the fabricator can polish the underside but the fab shop polish will not be of the same quality as the surface. However, it will be good enough to look finished on the underside. Polishing the underside is NOT an option typically offered by the fabricator. In my business we've learned to ask the question when the layout of the room, and particularly the stairway location, means the underside will be readily visible on a regular basis and not just when someone is on the floor looking up. Another option is to make the overhang "double thick" where 2 pieces of the engineered stone are mated back to back so a factory finish is on both sides. This is an easy option for 4CM assuming corbels are used or the double thickness is extended back over the cabinet. Finally, some natural stones that are crack prone have a fiberglass matting epoxied on to the back of the stone to help it hold together during transport, fabrication, and install. A competent fab shop will remove this backing as a matter of course. I am always annoyed at the poor quality evidenced by a job where the backing can be felt and seen on an island overhang and even on the narrow countertop overhangs. If you really want a great looking underside the best way is to double up the material back to back. It's an expensive way to do it for a variety of reasons....See MoreHow to finish an unfinished cabinet side. Need advice.
Comments (11)You could have a cover panel made and installed. A Cover Panel's purpose is to cover the lateral side of a cabinet. They are typically made the same way your cabinet doors are but are not hinged and can be easily attached to the side of a cabinet or multiple cabinets stacked. Measure the depth of your cabinets including the thickness of the doors and the height of the area needing to be covered. These are the dimensions you would use, normally the front edge will have a bullnose profile to match the cabinet door outside profile....See MoreFinishing unfinished kitchen cabinets
Comments (14)Stained cabinets with a proper water resistant/proof seal coat are much much less upkeep...but I too, get weary of encouraging folks to love the wood. Somehow laminate Ikea MDF board has taken over the youth who are building or flipping homes,and I am certain the paint factories are just loving it. Example: For 7 years, a good friend I have known. In 7 years, she has painted her cabinets 3 times! 'because they needed it'. For the First 30 years the house had stained cabinets...3 coats(more than that)3 painting events later, she just HIRED someone, to come in and replace the doors, and have them painted. In 7 years, 4 painting events in a kitchen. .. Would DRIVE ME CRAZY. Painting doors and drawers and hinges or removing hardware etc etc ....eliminate the kitchen totally and just have open stainless steel shelves(which you can dust weekly)with drawer under the stainless steel work surfaces. LOL. Red oak is very pretty and there is ALOT of it in this area, stained cabinets...WHite oak is nicer, BUT, harder to find for the export market gets most of it. Red Oak floors are very pretty. BUT you have to SAND IT SAND IT SAND IT. Oak is the most common wood in homes the past 40 years, with a sprinkling of ASH, Birch, and hickory, also, so that was news to me. And you do not want to finish it with a red tinged stain, likely... But, at least you did not have your cabinets built with 'stain grade' wood to 'save money'. THAT is a mess to paint. Voids and knotholes about, and if you are going to use 'paint grade' wood for your cabinets, than just plan on enjoying the rustic look in your home, which alot of people do enjoy. But few cabinet makers will reveal what those folks are really getting themselves into.....See Morevidyaram
13 years agoannzgw
13 years agoValerie Noronha
13 years agopatty_cakes
13 years agovidyaram
13 years ago
Related Stories
DECORATING GUIDESMission Possible: A Designer Decorates a Blank Apartment in 4 Days
Four days and $10,000 take an apartment from bare to all-there. Get the designer's daily play-by-play
Full StoryWOODDesign Workshop: Plywood as Finish
Trendproof your interior with this sensible guide to using this utilitarian material indoors
Full StoryHOME OFFICESHealthy Home: 8 Ways to Add a Standing Desk
Check out these options for doing less sitting during your screen, work and craft time
Full StoryPETS5 Finishes Pets and Kids Can’t Destroy — and 5 to Avoid
Save your sanity and your decorating budget by choosing materials and surfaces that can stand up to abuse
Full StoryDECORATING GUIDES7 Great Places for a Hammered Metal Finish
Amp up the character in your kitchen (or any room, really) with the gorgeous texture and artful look of hammered metal
Full StoryHOUZZ TOURSHouzz Tour: Natural Meets Industrial in a Canal-Side Washington Home
Wood and steel mix with copious glass in a contemporary new build that seamlessly transitions to the outdoors
Full StoryREMODELING GUIDES'Yakisugi-ita' Is Setting the Siding World on Fire
Exterior wood siding created by a Japanese burning technique is now alighting in the Western world
Full StoryHOME OFFICESMeet Your Desk: How to Create a Workspace That Works
Ask yourself: What should live on your desk and what can live elsewhere?
Full StoryWORKING WITH PROSHow to Commission Custom Wood Furnishings
Can't find just the right table, shelf, desk or what have you? It's woodworkers to the rescue
Full StoryFURNITUREColor Glams Up the Old-Fashioned Secretary
Before you write off a vintage secretary desk as ho-hum, give it a colorful new note
Full Story
Vivian Kaufman