Thanks.You understand- when the body betrays the spirit! I didn't think I would like that one looking on close-up, but as the finished panel, it has wonderful movement and energy. I guess I can start with a small thing... like a trivet? Want to do a table top. Want to do a mirror. Want to do just a wall piece. But, I can start with a small thing. I knew an artist who while working on a little cabin he bought decided to put the most extraordinary mosaic on the floor of the bathroom (see, we got back to the bathroom forum purpose). It was not his primary medium, however his creativity just came through in everything he did. I had always hoped that I would get to mosaics by the time I was ready to tile a bath, kitchen... but did not. Need to practice a bit, then perhaps when the basement bathroom plumbing needs to be redone (what did the prev homeowners do behind those walls??) I may be ready to get creative!

Can anyone advise me on my problem? I have Jandy filter, 2 Jandy pool lights and 1 Jandy spa light. After only 1.5 years both pool lights in the pool went out within days of each other. My pool guy is impossible to reach and difficult to deal with, but he finally said he’d replace them if we buy new ones. So we paid him for 2 new lights (Pentair Intellibright) for $1,700. I asked him why he didn’t get us the Jandy like we already had (that changes to 17 or so colors) and he said it doesn’t matter and there are better. Well..... long story short — his guys were here and cannot pull the wires out to install the new light. I don’t know why and neither to they. So they cut the light out with about 3” of wire and the other end is just a dangling wire in the pool. He says he’s done and they cannot Pull it — it’s stuck. We are trying to get someone else but don’t know if we should get the Jandy lights instead. It will be impossible getting our money back for these lights We use aqua link app to work pool lights, filter etc. are these Intellibright compatible with our app system and Jandy spa light. I am so disgusted and maddened bec we spent a fortune on our pool, patio etc. and we are stuck. P.S. another company first came when we saw the lights didn’t work and they also could not pull the wire through. The piping is underneath our new stone patio. And advice would be greatly appreciated. Thank you so much!

Deedles, I really like the placement of your prep sink. I think it gives you two great areas to prep next to it. I bet you'll end up prepping on the peninsula most of the time and the placement of the sink gives you a nice big area. I like it. I've gotta agree with the visual of the arch over the fridge not really working. I'd square it off so it fits with the rest of the cabinets. Your kitchen is going to be set up a lot like mine. I have a major traffic pattern through mine too. The fridge is in the traffic pattern, while my work area is on the other side of the kitchen. My prep sink makes a nice triangle between the fridge and the microwave and I love it. I find traffic tends to stay completely out of my way while I'm cooking and they stay in that zone between the prep sink, fridge and microwave. With what you've described, and from what I see of your space, I think you'll spend most of your time in the u of your kitchen while traffic stays outside. I really like that part of your plan. This is going to be a great kitchen to work in.

there is a plant propogation book i have wherein the author describes his own mist system. that author has a large black coil of hose in the roof of his greenhouse so that water can be heated before reaching the mist nozzles. that's at least one vote for using warm water and keeping the cuttings reasonably warm as they root. just thought i would toss that in! lol. -------------------------------------------------------------------------------- Posted by: mosaic z8 LA (My Page) on Sun, May 11, 03 at 11:59 With such a setup you could probably root roses under mist all winter here in Louisiana. And then as an added bonus, you could save on your power bills all summer by using it to steam your veggies :) -------------------------------------------------------------------------------- Posted by: tammyinwv z6/WV (My Page) on Sun, May 11, 03 at 16:05 i have been unable to find the mist heads even within an hr from my home.Someone mentioned here they found them for .50 each.would anyone be willing to get me a couple and mail them? -------------------------------------------------------------------------------- Posted by: wild_garden virginia z6b (My Page) on Sun, May 11, 03 at 16:32 at my lowes store the mist heads where in the indoor gardening area next to the register, i doubt the people at lowes would have even know what to look for. it was with the drip irrigation supplies, as i said in the indoor gardening area next to the big outdoor area where they sell trees and things. -------------------------------------------------------------------------------- Mist heads supply source Posted by: RoseHawke 7b AL (My Page) on Mon, May 12, 03 at 10:37 For you folks that haven't been able to find the heads locally, try going to this site: Dripworks or here's a direct link to one of the pages with some heads:Misters . I just a couple of weeks ago ordered some irrigation supplies from them and received them quite quickly. About 4 days if I remember correctly. Haven't had a chance to put it together yet, which is probably just as well as the flood we had last week would've probably washed everything down the creek ;-). I also have the Melnor timer, and it does seem a bit confusing about its ability to do a mist cycle, but what you're doing is programing it to do one cycle (on in the am; off in the pm) and punching in a choice of watering pattern, in this case the off for 10" on for 2" pattern. I believe the idea behind the pattern was/is actually to help prevent water run-off when doing overhead watering by allowing the water to soak in between the on phases. I bought this particular timer though because when I looked at it my mind said "Ah! Mist!" (heh), even though the reason I bought it at the time was to keep a new patch of zoysia sod watered until it rooted in. My batteries did last all season last year, but it was only opening that valve 4x a day for 3 weeks, and then 1x every 4 days for a couple of months. I can see where a misting pattern of opening and closing that valve many times during the day may eat batteries, but as ShamanSherpa pointed out, it's still cheaper than a $100+ misting timer! -------------------------------------------------------------------------------- Posted by: patclem z7 (or 6) TN (My Page) on Fri, May 23, 03 at 8:32 Regardless of how much water it wastes, etc, I decided to experiment with misting. I am TERRIBLE at rooting cuttings. I've tried baggies. I've tried jars. I've tried special cutting trays with plastic domes. I've had one rooted cutting out of probably 50. I had the same problem finding true super-fine mist systems in the south. None at Lowe's, none at HD. They're not popular here because they don't have the same evaporating effect they have in less humid areas of the country - they make you wet here. Here's where I found mist heads. They didn't charge me anything for shipping. They were super-good to deal with online. Web Page - Phone/Fax 888-693-0578 Local/Fax (719) 495-2266 Qty: 4; Sku: 6W401; Product: Monarch Misting Nozzles M-1; Amount: $7.40 Qty: 4; Sku: 6W519; Product: Reducing Tee for Monarch Misting Nozzles; Amount: $4.40 You have to go to Lowe's or local hardware store and get a hose adapter, timers, 1/2" PVC, PVC caps, etc. I have mine set up with 2 mist heads, and about a 6' diameter section of my grass is soaked! I don't have mine on a timer yet. Results? I don't have any yet, except none of my cuttings have turned black yet. PS - I AM NOT AFFILIATED WITH THIS BUSINESS IN ANY WAY! Here is a link that might be useful: Mist Heads -------------------------------------------------------------------------------- Posted by: fuselighter 7/WA (My Page) on Thu, May 29, 03 at 21:41 I am so excited about the misting bed. I went out and bought all the supplies today. Total cost was about $15 (my husband had PVC and elbows left over from installing the sprinkler system). I would like to go to an intermittent system eventually, but for now I am going with continuous. The water bill is not an issue because we have an irrigation system (there is an annual fee but it is not based on usage). I set the whole thing up in about an hour. -------------------------------------------------------------------------------- Posted by: debbinard Z4CO (My Page) on Sun, Jun 1, 03 at 10:54 Shamansherpa -- I could not open your picture! I live in Colorado, it gets very warm middle of June (up to upper 90's) and stays low humidity. We are on outsidewater restrictions 2xweek, so I'm not sure this method would fly. Am wondering how visible this is, or if inside is an option under lights. At any rate, I would like to propigate some rose cuttings now (is this a good time?) My daughter in law is moving and would love some plants from a rose with sentimental value. Is the rooting hormone used just the usual or special for roses? Thanks Deb -------------------------------------------------------------------------------- Posted by: mytrid Zone8b Florida (My Page) on Sun, Jun 1, 03 at 13:48 Deb, Maybe you could call your water extention office and see if you can get special permission, exsplain to them how little water it uses. Yes you use rooting hormone, there are many available. Dip and grow I here is supposed to be really good. I got some of the more exspensive stuff from a friend whom bought it threw rose imporium on line. But you can always use something like dip and grow. Deanna -------------------------------------------------------------------------------- Posted by: rose_enthusiast z7 TX. (My Page) on Sun, Jun 1, 03 at 15:47 Hi there Deanna! It seems to me you've managed to help a lot of people with your invaluable info. And I would like to thank you for inspiring me to start a misting bed to root my cuttings. I have one question to add to the many others you've been getting though... What rose company is it that you get your rooting hormone from? Is it Rose Emporium or the Antique Rose Emporium? I would like to purchase this product as well, since you and this company are using this to successfully root your cuttings. Thanks Again, Carlos -------------------------------------------------------------------------------- Posted by: mytrid Zone8b Florida (My Page) on Tue, Jun 3, 03 at 1:31 Carlos, Thank you but we should all thank AngieAnders, she is the one who did all the research and work to discover this method and then post it here for us last year! She truly diserves all the credit. I just wanted to keep any new people aware that have just started rooting this year. Best of luck all and don't forget to post your sucess! Deanna -------------------------------------------------------------------------------- Posted by: epiphany z5b PA (My Page) on Tue, Jun 3, 03 at 9:28 I found the Arizona Mist system which is by Orbit as mentioned at Wal-Mart. It has 12' of tubing, end cap, six misting heads and hose adapter for $14.95. Of course, it is once again cold and wet here,......all of a balmy 56°. -------------------------------------------------------------------------------- Posted by: auntnana 6 TN (My Page) on Thu, Jun 5, 03 at 13:06 I ordered the misting heads mentioned above from Dripworks last year and they don't put out a fine mist as much as they do a fine spray/droplets. And even though I had a pressure regulator on there, I kept having a problem with the heads blowing off! (Their drippers work perfectly by the way so it's nothing against the company) I ordered foggers from Misty Mate this year and they put out a super fine fog. Perfect for propagation. They are a litte more expensive than the ones from Dripworks but worth it. And if you ask they will ship the misting heads for $1.50. I went to HD and bought a 10-24 tap and drill set (3.00) and drilled holes in my 1/2" cvpvc and the heads just screwed right in! I bought a Melnor timer at HD for $39 and it has 1 minute spray options so I've got it set for 1 minute every 10 minutes. Can't remember the model number but it's not the one on the HD website. I hope to finish my new propagation box soon. I built one on a stand this year so I can move it around easily. Wouldn't you know, HD has plastic sheeting made just for greenhouses that I used! It's not the real thick heavy stuff either. It's only 4mil and is crystal clear see-thru! Hopefully I'll be finished this week!