P2709.2.3 Hot-mopping. Shower receptors lined by hot mopping shall be built-up with not less than three layers of standard grade Type 15 asphalt-impregnated roofing felt. The bottom layer shall be fitted to the formed subbase and each succeeding layer thoroughly hot-mopped to that below. All corners shall be carefully fitted and shall be made strong and water tight by folding or lapping, and each corner shall be reinforced with suitable webbing hot-mopped in place. All folds, laps and reinforcing webbing shall extend at least 4 inches (102 mm) in all directions from the corner and all webbing shall be of approved type and mesh, producing a tensile strength of not less than 50 pounds per inch (893 kg/m) in either direction.

chicagoans - thanks - that is a great idea if the under sink type does not work out - never thought of concealing it that way. I have an in-door water dispenser in my current house, but I really don't like it - not cold enough (hence the water cooler) and I don't like the look of it. ayerg73 - I have never had problems with my in-door water - I just don't like it. We will have a water softener for the whole house, but I really only want to filter drinking water - I think? We have never had to deal with whole house water softeners/filters before and I find them confusing and complicated - so may different opinions out there. I have seen the chillers mentioned in a number of kitchen reveals here - including taggie's beautiful kitchen just revealed, so I hope someone with one will weigh in.

@Greeny, I didn't post a link. Thanks @dadoes. @suberbanmd, I just looked up the module number, thanks. He says it works well for him. I'll have to talk to him about washing temps and products.

Nice, and really unique. You will just have to keep your eyes open for something that will work with that. Take the measurements down for what will work, you may get lucky and find something. The mirrors got separated on those vanities for hanging separately or just got broken. If you can find something maybe a simple round mirror with a black frame would work hanging on the wall above it. Before you try and strip and refinish check out re-amalgamation of varnish finishes. Google term or go to YouTube. Hint, if you can use this technique do it with a light hand if you want to retain patina. Also, don't remove patina from the drawer handles, just remove and give them a good scrub with soap and water. Here is one of many videos...I've used what is called mineral spirits, it's called whatever the guy uses in England, same stuff. Just check out YouTube videos. https://youtu.be/F9SsSF1Qv_Q Maybe not even use steel wool as this guy recommends. First try a gentle approach with a white cotton cloth dipped in mineral spirits. The process basically disolves the varnish, removes some, then the varnish re-hardens/drys. It happens rather quickly too. That is if it's natural varnish that was used, which is more likely than not. Doing a test spot will quickly tell you if it is varnish rather than polyurethane, basically nothing much will happen to finish if poly.