Take samples to your local cooperative extension service and they will identify it for you. Take many samples, like a handful of grass (with roots), from several areas to be sure you are sampling the different types that might be in your mix.

Where in the world you are can be of tremendous assistance to some of us, although my soil is sand while my sisters soil (6 miles west of me) is clay. Usually sand atop a clay base indicates that someone dumped some sand there in an attempt to have a soil kind of easier to cultivate then the clay would be. The clay, under that sand, will keep that sand from draining properly, two different soil types with vastly different drainage capabilities. I would talk with the people at your local office of your state universities Cooperative Extension Service to find out what your soil type shoulld be.

Image is too small. However you can apply a per-emergent herbicide such as XL or Amaze mid-Feb., mid-May and mid- September to prevent them germinating in the first place. Here is a link that might be useful: XL

Thank you so much for these ideas and the technical terms ! I wasn't even sure what to google other than 'hinge' which returns a bazillion results, lol. Yes, inboard of the pivot point is the problem I was trying to explain. If I have to overlay the excess not centered to the opening, I will. But that takes my mirror further to the left than I wanted to be (hinge will be on the right). Ideally, the excess would be to the right, on the same side as the hinge, with just a little overlay on the left. When I googled 'overlay partial wrap hinge', I also found these hinges. I think the plate would have to be mounted on the face of the sheetrock, with longer screws that would go thru the sheetrock and screw into the studs, but would these work ??? It looks like they would allow the mirror to have a very large overlay on the right and also the hinge would be hidden. http://www.hardwaresource.com/hinges/cabinet-hinges/blum-european-hinges-grass-european-hinges/blum-compact-33-hinges-and-mounting-plates/blum-compact-33-face-mount-plate http://www.hardwaresource.com/hinges/cabinet-hinges/blum-european-hinges-grass-european-hinges/blum-compact-33-hinges-and-mounting-plates/compact-33-hinges I see the hinge is supposed to be inserted into a drilled out cup. Vice versa, could the face plate be mounted on the mirror, and the hinge cup be drilled into the sheetrock ? Would the hinge still open correctly ? The reason I ask, is because I am not sure what material the frame of the mirror is made from and also if it is deep enough to allow me to drill the cup. Lateral hinges I think would not work, for the same reason as the drawer glides mounted sideways - I don't *think* there would be enough room. We're down at the beach house right now (our last guest broke the side rail on one of the bunk beds and we're here fixing it, no idea what they were doing to break the rail lengthwise all the way from end to end!! kids jumping on the bed I would guess), but I can measure for that idea when we get home tomorrow.