Hi! I attached a link to the free seeds page at winter sown,the address to send your SASE is located here!:) Here is a link that might be useful: winter sown free seeds page

Your sketch isn't what I initially had in mind, but it might work. It's obvious disadvantage is that it places the bulk of one leg of your house directly adjacent to the lot-line house of your neighbor. The result would be 5' "tunnel" between the two houses. If you don't care about that or your neighbor's reactions, this idea might be worth pursuing. What I had in mind was to reverse the "L" shape of your sketch, such that one leg would be along the property line easement (as you have shown) and the other leg would be along the property line at the bottom property line. The garage would be located at the end of the "L" closest to your neighbor's property line. Garage entry might be on the side of the garage closest to you neighbor (a side loading garage) or on the side facing the street (a front loading garage), depending on choice, space available and plan arrangement. If you could get a side property line variance for the 20' setback, you likely could make enough room for a side entry garage closest to your neighbor. I don't understand the typography of your lot, so the slope may make my suggestion impractical and your idea the only feasible concept. Good luck with your project.

I use OE on my desktop and Windows Mail on my laptop and often get that message, I got it last night on my desktop. Unless I made a change in something related to OE, I just ignore it for awhile. It is usually a server problem.

In case anyone has this problem in the future, after several videos, including manufacturer videos, which all pretty much skipped through the part of inserting the hinges into the oven, and several articles, I finally found 2: https://www.justanswer.com/appliance/4g13q-re-attach-whirlpool-oven-door-removing-wasn-t.html https://www.bobvila.com/posts/29301-can-t-put-oven-door-back-on?page=1 What happens is that when you open the door, the hinges are in the extended position, but when you have it partially closed to lift off, the hinges snap back into the closed position. Note that these hinges can take your fingers off! What we did was pull the hinges into a partly extended position, not sure if it was 120-degree as above, and then slipped a 1 x 2 wood block between each hinge and the door to hold them open and save your fingers. So there is an almost-1-inch space between the hinge and the door (and the wood block is soft and not damaging anything). At that point you should be able to hold the door at approximately 45 degrees and slide it in like magic, the way they do in the videos without any helpful comment. If that angle doesn't work, start at 90-degrees (open position) and tilt up until the hinges slide in. The real issue is the way you take it off. They assume that the hinges will be locked open when you remove the door; this is why they are singularly unhelpful about putting the door back. Our oven is a Whirlpool model with the double-hook hinge, fyi.