Do plants roots really need air?
ceth_k
10 years ago
Featured Answer
Sort by:Oldest
Comments (33)
seysonn
10 years agoNatures_Nature
10 years agoRelated Discussions
Rooted cuttings from pepper plant by air layering
Comments (1)It's great how the photos show what you did. They explain your method well. What kind of pepper plant is that? Have you thought of posting a link to this on the chili forum? I bet some people there would like to see these....See MoreDo Sans Severias Really Clean Up the Air?
Comments (1)check the data on NASA experiment. I believe you have to plant lots of pots to purify a big area. There is a requirement of how many plants/area to make it work. Any houseplant uses carbon dioxide for photosynthesis, meaning plant uses your fart, and excess aerosol to make their food. So the effect, less carbon dioxide in your home since plant use it, and replace it with oxygen for you to breath. good question :) Angie...See MoreFiddle leaf fig - do I really have to air layer to propagate?
Comments (16)@Cassie (8b Southern AZ, high desert) Hi Al, do you normally use the ring or the tourniquet method when you air layer your ficus plants? Or do you do a combination of both (you mentioned using a tourniquet and blanching part of the stem/branch?)? It would depend on the Ficus species. For most Ficus, I propagate by cuttings, because I've found that under mist or in a humidity chamber, you can start some really thick cuttings of many ficus species (3"+). This image of F salicifolia was a cutting started from the top of a much larger tree. Same tree as above - first pruning after rooting ^^^. Ficus microcarpa cutting ^^^ in process of rooting - note new buds opening. Removing the tops of trees in training is sort of a way to create an almost instant bonsai. Once the tree is fully rooted. a little wiring to reposition branches will turn it into a 'believable' tree, resembling something one might see in nature. If we take the misting and high humidity out of the equation, I prefer ringing the plant; however, even when I use the ring method, I often use a tourniquet immediately below the top of the ring. While I'm thinking of it, the rule of thumb for the ht of the ring is, it should be at least 1/5x the diameter of the branch/ trunk being layered. Also, when you peal the bark back on many species of trees, a very thin layer of vascular cambium usually remains attached to the sapwood beneath it. It is crucial to remove that white/tan layer of tissue as part of the layering process. I'm guessing my reason for layering is probably going to differ from yours. Most plants I layer is because they are seedlings, and as such have a very ugly root system. Strong roots that radiate horizontally away from the trunk and a trunk flare at the base of the tree eventually become a critical consideration for almost every bonsai enthusiast who has practiced bonsai for more than a decade. Eventually, we develop the idea that everything we do should focus on bringing out the tree's best potential, even if we are not the owner who sees it realized. Often, that will result in trees in training for 20 years before they even see a bonsai pot. I couldn't even guess at the number of times I've been a part of brain-storming over a tree, my own or someone else's, and making radical changes that turn a tree which is an acceptable specimen in its own right, back into a bonsai in training for the sole reason a better way to bring out the tree's potential was discovered. The image below is a Trident maple which was air-layered off of it's original set of roots which were way to ugly for my purposes. I used only the ring method for this tree (wire still attached if you look closely). Notice how the roots are almost perfectly spaced (some incongruity adds to the appeal of living plants) and radiating away from the trunk. That is what I was after. The tree below is a Korean hornbeam, and 3-image sequence below shows first what a tree's seedling roots usually look like. Many growers work hard at trying to get these roots straightened around, but I have learned better results cam be had in far less time and with less effort, bu layering the plant off of its old roots. This is one way of using the tourniquet method (below), which takes much longer than ringing/ girdling or a combination of a tourniquet and ringing/ girdling. With a tourniquet, as the diameter of the trunk increases the vascular cambium is compressed as the tourniquet tightens. This 'chokes off' downward movement of photosynthate (the plant's food) and auxin, the hormone that stimulates root development and branching. With food and a surplus of the tree's natural rooting hormone accumulating immediately above the tourniquet, you can be quite certain of a plethora of roots emerging within a short vertical space. With an understanding of the tree's wounding response, I deduced that drilling holes with a 3/16 brad-point drill turned with my fingers and filled with a insoluble rooting gel should help coax the tree into producing an exceptional root base. The roots in the first image (of the trident maple) are the result of this method. Ring + tourniquet method ^^^ BTW - I no longer use zip ties as a tourniquet as they sometimes fail/ break - especially on thick layers on branches/ trunks larger than 1". I use 2-3 wraps of aluminum bonsai wire in size 2-3mm with the ends twisted tight with pliers. The wraps should touch each other, which forces all rooting to occur above the layer. What type of soil do you use when you air layer, since you don't use sphagnum moss? I'm assuming this is one of the few times you want something moisture retentive - do you use a regular potting soil? Peat moss? Seed starting mix? I usually use gritty mix for just about everything I use a pot to layer. Below, there are 2 things going on. I had just finished establishing an air layer on the hornbeam in the background and I was working on pruning 2 China dolls and 2 asparagus ferns. I was layering the hornbeam because the trunk was much too long/ tall given the thickness of the trunk, so the best way to shorten the trunk was to layer it off of it's old roots and start a new root system higher up. The top of the ring cut is at approximately the ht of the duct tape holding the pot together. Below, is a hackberry tree being layered. You can see the gritty mix in the pot This is the same hackberry, same summer, after being separated from the mother plant. In case you noticed, it's planted deep on purpose. I will let it grow wild (almost completely unpruned) and begin work on it in spring of '24. And last question (for now!), what time of year do you typically start your air layering? Spring. I like to have them separated by the end of July. Do you try to time it to plant the new plant in June, or is some other time preferable? If we're still talking about Ficus, spring will always be the best time. If I was layering, I would start the layer on Ficus just before or when I move them outdoors. They really start to want to grow then, so we might as well take advantage of the tree's natural inclinations. I'm wondering if it's better to start the process in June, since you're effectively pruning the parent plant, which would put separating the new plant sometime in August? Geography plays an important role in deciding what the best timing is. I bet you would be fine starting your layers in early May, especially if your plants are outdoors. Then, you should have no problem separating in July-August. Thanks in advance! (And I suppose apologies for resurrecting an old thread, but made more sense in my mind than starting a fresh one and linking back here). No worries. Things are slow on the forum and my wife is recovering from some recent surgery, so I have to be home and indoors for a few more days, it looks like. I'm glad for the opportunity to kill some of the time it always seems so important to save. ;-) Al...See MoreDo plant roots really spend more time trying to do this verses that?
Comments (2)Hey, buddy, I wanted to say Hi! I've been so busy with the Farm work in full swing, and a number of other side jobs, that I haven't had time to call and catch up. My sister also moved, and I haven't had my regular relaxing beer and phone call. Been thinkin' of ya, though! As for the question at hand....plants go through growth phases, below and above. And I think we all agree that the health/vitality of the plant is very important. I hear all the time that people don't want to disturb the plant, but that'll bite them in the ass in the end....when they're forced to do an emergency repot for a failing plant. I had to repot my Moro blood orange this Spring, even though it was covered in blooms and fruit. Yes, it dropped a lot of fruit as a result, but the tree itself is now healthier than ever...and there are still a few decent fruits left. Josh...See Morewayne_5 zone 6a Central Indiana
10 years agonc_crn
10 years agoceth_k
10 years agoshuffles_gw
10 years agoNatures_Nature
10 years agomckenziek
10 years agoceth_k
10 years agoseysonn
10 years agoNatures_Nature
10 years agosunnibel7 Md 7
10 years agomckenziek
10 years agodigdirt2
10 years agomckenziek
10 years agonc_crn
10 years agonc_crn
10 years agomckenziek
10 years agoceth_k
10 years agozeedman Zone 5 Wisconsin
10 years agoshuffles_gw
10 years agoseysonn
10 years agocharles0358
10 years agoZachS. z5 Platteville, Colorado
10 years agomckenziek
10 years agoZachS. z5 Platteville, Colorado
10 years agopls8xx
10 years agotapla (mid-Michigan, USDA z5b-6a)
10 years agoZachS. z5 Platteville, Colorado
10 years ago
Related Stories
CENTRAL PLAINS GARDENINGGreat Design Plant: Culver's Root
Spiky summer blooms beloved by butterflies and architectural interest in winter make this Midwest native plant worth featuring in the garden
Full StoryURBAN GARDENSDirt Optional: Amazing Air Plants for Wall or Tree
Succulents and air plants are stunning on winter walls — and the Christmas tree
Full StoryDECORATING GUIDESAir Plants Go Easy on Indoor Gardeners
If your best intentions leave stalks barely breathing, embrace blissfully easy air plants to bring a living garden to your home
Full StoryGARDENING GUIDESGot a Hot, Humid Landscape? Add Tropical Flair With Air Plants
Turn tree trunks and walls into lush canvases with plants adapted to the canopies of the rainforest
Full StoryHEALTHY HOMEA Guide to Indoor Air Purifiers
Get the lowdown on air filtration systems for your house and the important ratings to look out for
Full StoryMODERN ARCHITECTURERoots of Style: International Style Celebrates Pure Form
Using technology and materials of the time, International style is always current. See its expression in these 16 homes around the world
Full StoryARCHITECTURERoots of Style: Mission
Spanish colonial missions inspired a style of architecture still popular in the United States
Full StoryFEEL-GOOD HOMERejuvenate Your Home With Deep-Rooted Traditions
Give the subtle energies and spiritual side of your home some attention, and watch newfound calm and beauty blossom
Full StoryARCHITECTURERoots of Style: Midcentury Styles Respond to Modern Life
See how postwar lifestyles spawned a range of styles, including minimalist traditional, ranch, split level and modern shed. What's next?
Full StoryTRADITIONAL ARCHITECTURERoots of Style: Pueblo Revival Architecture Welcomes Modern Life
Centuries-old details of adobe construction still appeal in the desert Southwest, adapted to today's tastes
Full Story
daninthedirt (USDA 9a, HZ9, CentTX, Sunset z30, Cfa)