Most all steel and fiberglass door manufacturers use "commodity" inserts for full lite, half lite, 9 lite, 15 lite, etc glass inserts. They don't make that part (plastic frame with glass inside) but instead cut the hole in the door blank and insert the glass made by specialty manufacturers that service the door making industry. They are referred to as commodity inserts because usually inserts from different companies are interchangeable. They are sold with both inside/outside trim AND the glass as mulchmamma said, and you have to double-check the sizes. My company was just able to sell (10) 9 lite (same size as 1/2 lite)sets to a company on the other side of the country WITHOUT the glass. They loved this of course because it saved them a fortune on shipping (weight) and they got to re-use their perfectly good glass anyway. You didn't say what your window was. For example the units i spoke of were 23 3/4"W x 37 3/4"H, measured to the outside dimensions.

Hello. I’m curious how you handled this. I have a new wrought iron door that already needs a few touch ups. Would like to know how you made out with your door. Thank you.

My gosh. Why didn't you order factory-finished doors? They would have looked better -- and the paint job would have lasted longer -- than anything you can do yourself.

@Mark Bischak I tried to send you a message but it would not go through. Because of where I live, I have not been able to find doors for my entry. I have talked to two dealers in Wyoming and they said because of the wind (and red dirt) and winter winds here that I should not get double entry doors. The space is 96" h x 72" w. I wanted the 42" w or 48" w and thought about doing a window on one side. If I do a solid door and sidelight I want it to have a 1/3 lite but I can't find any. My covered porch is 11' wide x 6' deep. The space for the doors is a little over 7' wide. Sorry if I should have done my own post.