We have LivingStone counters in the "Volcanic Ash" color and an integrated Corian brand sink (LS doesn't offer a single bowl sink so we went w/Corian in order to have a single bowl sink). LS feels identical to Corian and I understand it to be an identical product with a good warranty and identical care but far fewer color options. Our counters/sink are only a little over a year old but I LOVE them--nothing has stained (at least nothing that a little bleach won't take care of) and they feel/look great. Integrated sink is the most wonderful design ever. LS counters are great, low maintenance counters with what we felt were the most pros (all counter options have pros and cons and you have to make a decision that will suit you and your lifestyle the best).

You do not need to stack two 2cm slabs on top of each other to make it look like you are using 4cm thick slabs. You only need a small amount of extra material (1-2â inches depending on edge type) to beef up just the outside edges of the counters. Laminated or mitered edges are very common here in So. Cal., where most stone and quartz is sold in 2cm size, rather than 3cm. The fabricator will put a 5/8â thick plywood subtop that is a little narrower than the finished counter size on top of the cabinet. Then the 2cm slab counter is put on top of the plywood. A narrow strip of the quartz is attached just at the edge of the counter to hide the edge of the plywood and make the whole counter look thicker. For standard 24â deep cabinets, the finished counter width with overhang is typically 25.5.â I donâÂÂt know what brand of quartz you plan to buy, but Caesarstone slabs are 56.5â wide, Hanstone is 55â wide, Silestone is 54âÂÂ, Cambria is 55.â (Some brands sell wider âÂÂjumboâ slabs if you have deeper counters.) Assuming a 55â wide slab, two 25.5â deep counters will use up 51â (plus a small amount of loss in the cutting process), leaving the few inches you need for the edge strips. You should need the same number of slabs whether you use 2cm or 3cm material. The thinner material will cost less, which should offset the increased labor cost for the laminated or mitered edge. I am going to try to attach pictures that show the different types of edges.

have finished the 4th remodel (wow 2 yrs since earlier post on this thread!). Used all white (no patterns speckles or veining) in MasterBath, Butlers Pantry Wet Bar, and as BACKSPLASH in Kitchen whose counters are Stainless Steel. (the rest of kitchen is all white cabinetry with brushed metal pulls). No qu that the white is stunning, crisp, pleasant. MasterBath is fine. Butlers Pantry: the white counter is unforgiving and shows everything. So on a second bathroom we chose white with a little gray veining and that has been excellent / easier. Kitchen all white backsplash with white cabs above below has been great and VERY easy clean (we cook a lot and use spices that stain too). But the all white in kitchen would have been intolerable as a counter for us. Stainless steel is not for everyone but 3 kitchen renos later, (2 remain actively in use) we love its cleanliness and the patina and very, very low maintenance. It looks surprisingly good with Cesarstone / Quartzite type stone products

Thanks everyone. I am going to order some samples. I priced out a remanat of my kitchen granite but it was just more than I want to spend. The laundry is currently unfinished so we have to do walls, floor, lights, outlets, etc as well as cabinets and counter so cost is important. Plus, it is a basement laundry room, it doesn’t need granite!