We just did our house in Benjamin Moore Amherst gray HC-167 and did the door in Caliente Red. Our painter convinced us and it is a fantastic grey-green. Love it.

We've converted two attic spaces (same house, opposite ends) to living space, with low ceilings. From my experience, the first thing to do, after determining whether you can safely/legally finish the attic, is to run the electrical wires. To avoid running duct from a furnace/AC, I'd run 220v for a couple of baseboard heaters, and use the portable AC units which sit on the floor and vent through a window. I can see some natural light, so it looks as if you have dormers, which might be fine for egress and the portable AC units. We used foam baffles between the roof and insulation, then sheetrock as usual. If you are not confident about finishing sheetrock, and don't want to pay to have it done, you can tape it, then cover with inexpensive sheet beadboard. I like your floors as they are, but you'd want to seal them, if not paint. Those are much nicer floors than I've ever seen in an unfinished attic. I'm impressed that there are floor boards at all--I've see a lot of attics with a few pieces of plywood laid across the joists to store boxes. Since the knee walls wouldn't be structural, I think you could frame them yourself, with some research, and basic tools. You might as well frame them in, since that space is too low to use as living space, and if you feel confident enough, you can turn the space into recessed storage--shelves or converted dresser/drawers--very convenient if the space will be used as an office or craft room. If you choose the portable AC option, you could even tailor a storage space to the unit(s), for the off-season. Following are pics of some of the kneewall storage in our half-story attic addition. I did most of the work myself, with limited construction experience. (Left the electrical work to the pro.) The white walls, and closet doors, are the sheet beadboard I mentioned above. I also had to work around closet space in adjacent bedrooms, and the old roof supports, which is why the recessed shelves in the first pic are so shallow. If you can find cabinets, drawers, and chests on craigslist, Goodwill, and the Restore, you can keep the cost down--but only if you have more time, than money, to invest in the project. It would be very difficult to estimate the cost. Our neighbor is a master electrician, and we traded him a strip of land that he'd been asking about, to wire the whole addition. We already had all the tools needed. A chop saw/miter saw, set up in the space as I was working, was invaluable. Circular saw for angled cuts on 2x4 framing. Reciprocating saw for cutting existing framing, and a jig saw for small cuts is also useful. Framing and finishing nail guns are convenient, but I don't like using them, so I did all the nailing with a hammer. I love hearing a nail 'sing' as it's being driven into the framing. :) If you have friends or relatives with construction experience, who will do favors or trade skills, then you can keep the cost down. Kneewall storage ideas/google Portable AC units on Amazon

I would imagine the reason for the lack of response is that a picture of your place has not been included. Please upload one.

I like the colors on this Cape Cod house shown below. Your roof is close already. Could put new siding on over the brick I would think? Might want to beef up the roof overhangs just a bit on the dormers, making them a little more substantial? Could install a new door and add sidelights to the front door; don't think there's room for a top light like in sample below. Could paint the bay windows the yellowish color as shown?? Cut back the grass from the house in the front and add some landscaping (bushes, perennials, etc.) Good luck!