Another Hansgrohe Raindance AIR handshower here. I like it very much. The "air assist" gives the flow plenty of power for hair rinsing. It only has three settings, though--fine for me, but you may be looking for more.

I am very happy with the showerhead that we put in our MBath remodel. It's the Hansgrohe 27447 Raindance Three Way. It has a broad pattern, but it is still strong enough to wash out my thick hair. I never use the other settings since we also have a handheld.... only the broad spray and I really like it. Will definitely be using in our new build.

Try the website hometodreamhome. I deal with these guys semi-regularly and have always been impressed with their knowledge. Ask them for the bargain products they have that are not posted. This is how I get all my deals. I would go for the Hansgrohe brand as this is top quality. There are also some cheaper modelsa by dreamline that maty be of interest. Again, email these guys.

it is a moen assembly sorry I don't know the actual valve models--no paperwork on that from the original owners and the plumber took the info I used to order the part--the part I ordered/replaced was 1423 Balancing spool Moentrol maybe something like this for the two-head control http://www.moen.com/products/T4111ORB ours is oil-rubbed bronze and it is installed with the lever at the top and the pull-out valve under it which looks the opposite of the Moen site photo the info on the Moen site says that it should turn from 'full cold to full hot' but there are stops the plumber came back out and said that when he put in the balancing spool he had opened the hot stop all the way and that if he closed the cool stop that it would not do any good because the balancing spool would basically just reduce the flow of water to make sure the balance of hot/cold stayed the same... he said that there is movement underway to basically take the choice out of amount of hot water coming through faucets and showers--that safety of not burning/scalding people is overriding someone's desire to have a 'HOT' shower... when I asked about replacing the valve/lever with one that would swing right/left to allow me to regulate the balance of hot/cold... he said it would be too expensive to actually change the control to that type of fixture because we would have to open up the shower wall--take out tile--replace it... so we are basically stuck with either setting the water heater to higher temp because that will bring hotter water to the mix and will be expensive choice or just learning to live with it like it is I plan to take a shower in the two upstairs showers and see if their water is hotter than the one downstairs--- he said that the master shower is probably farther from the water heaters--and it might be farther than the other downstairs shower by just a little...which would influence the water temp at the head... both water heaters are upstairs and closer to those showers... it is just very frustrating to find out that something we really did not consider all that much would become so frustrating... I don't take long showers--and I don't use the big tub at all--don't consider that I waste water compared to larger families or people who take a 15 min shower...so this irks me to no end-- our old house with its old shower had wonderful hot water and I am really going to miss it... Here is a link that might be useful: shower valve