Do you have Ccleaner installed? If so start it then click the 'Registry' button on the left side. Do not alter any settings, click 'Scan for issues'. The scan may find a few or more likely a few hundred entries, do not fear these are all obsolete or left over entries. Once the scan is complete you should click 'Fix selected issues' or something similar. Back up the registry when prompted and click to remove the items show. Close program, hopefully the issue will be resolved Note to lurkers, do not play in here unless you fully understand the implications. A wrong move and you will possibly have monumental problems. Under normal circumstances any obsolete entry in the registry is simply ignored by the computer. In not2bright's case this is a move to stop the aggravation at startup.

Which Intuitive Eco model? There were three on the U.S. market -- IWL12, IWL15, and IWL16. You need to run some diagnostics to confirm what's working and what isn't (if anything). - With power off, press/hold Lifecycles, then press Power at the same time. Should get two beeps and the panel comes on. Release the buttons. - If the LCD backlight is on but a blank display (which it should be blank at this point), press Lifecycles again. An information screen should appear. If the screen is not blank then there's no need to press Lifecycles to get the display. - There are three diagnostic information screens. Press Option Up or Down to switch through the screens. Make note of any code numbers on Warning Status and Fault Status screens. Set the display to the Machine Status screen. - Notice it says Diverter:Off at the upper left below Machine Status. Continue to the next step. - Press How Dirty Up to run hot water. Press How Dirty Down to run cold water. Run each for a couple mins to confirm they keep running (must hold the button). A flaky valve solenoid may work at first when cool, then fail when it gets heated from use. Check that the hot water runs hot and cold runs cold (which will confirm you have the supply hoses connected correctly). Water will fill into the tub as you run it, which is OK, some water is needed for the next test. - Press the Home button. Diverter status should change to :Heating. Wait a minute or so, it should change to Diverter:On. Continue to the next step when that happens. - Press Fabric Care. The pump should turn on and water should shower out of the recirculation port at top right/rear under the tub cover. This is important - NO WATER should be flowing out of the drain hose. - Press Fabric Care (turns the pump off) and Home (turns the diverter off). The Diverter status will change to :Cooling, then to Diverter:Off in a couple mins or so. Go to the next step when that happens. - Press Fabric Care to turn the pump back on. Water should flow out of the drain hose ... and this is important - NONE from the recirculation port. Let the water drain completely. Press Power to exit diagnostics and report back here the results of your testing.

Just goes to show that the bigger the organization is the worse the customer care. I am very angry that the real problem was not addressed when I was talking with AT&T. I tried to find an email address to voice my opinion and there isn't one to be found at AT&T's website and the maze you have to go through on the phone is ridiculous. If I hadn't thought of Googling the problem by including the search term "Yahoo" I would still be in the dark about it. And not a word has been issued on the news about the problem and there had to be millions affected by it.

Thanks but using my iPhone (no computer) Never had a problem up until I reset my phone. Had the old gardenweb saved onto it and now can only get houzz :( I was just able to add a couple photos to a thread, just not able to make a new thread with photos myself. Strange...