Microwave range exhaust hood effectiveness?

13 years ago

The microwave has been installed for a few years now so it's not under warranty any more.

It has never been effective in exhausting cooking odors even when brand new. All it seems to do is make more noise when it's at the highest speed. The exhaust suction isn't even enough to support a full sheet of a paper towel. Opening doors and windows works better to air out smells and smoke, but then that lets out the heated or air conditioned air in the house.

Is this normal for fans to do so little to exhaust cooking fumes?

Are there any ratings that tell you how much air a microwave exhaust fan moves? I have only seen ratings like that for bathroom fans.

If I replace this microwave, I want to make sure the next one has a much more effective exhaust fan.

Sort by:Oldest

Comments (4)

Buehl
13 years ago
From what I've read on this and the Appliances Forums and experienced at my sister's first-hand...it's about par for the course for the majority of Over-the-Range MW/Hoods...one of the several reasons they are not recommended here (or on the Appliances Forum).

However, this is NOT normal for dedicated range hoods like Vent-A-Hood, Modern Aire, etc. Dedicated range hoods do a great job of removing smoke, steam, odors, grease, heat, etc. as long as they're sized properly, are strong enough (cfms) for their accompanying range/cooktop and cooking styles, and installed properly.

(It is generally recommended that a range hood be 6" wider than the cooking surface and that it cover the entire cooking surface front-to-back with a couple of inches overhang in the front...usually 24" deep. Recommended cfms are a minimum of 600 cfms and up.)

I've included the link to the Appliances Forum's FAQ on range hoods.

Here is a link that might be useful: Overview of vent hoods
pudgybaby
13 years ago
I agree w/ Buehl - they aren't effective. That said, we are getting another over-the-range MW for our remodel. Our kitchen is small and we didn't want to take up valuable real estate with the MW.

There are CFM (cubic feet per minute) ratings for OTR MWs. If I recall correctly, they max out at 300 CFMs, although I think there might have been one at 400. It's been a while, but I think Panasonic was the only brand where I couldn't find that info.

Another thing that can make it slightly more effective is to vent it to the outside. It won't make it move more air, but should help with smells. They all have options to either vent it out or recirculate the air. Our old one was recirculating and we hated it - not only was it not effective in capturing grease, steam, etc, it dumped the smells right back in the kitchen (after filtering though an ineffective carbon filter).

And, yes, they are really loud. Venting outside should help that a little as well, but we are not too hopeful. Try to find a store with the MWs wired up so you can try the fan out.

There is lots of info in the appliance forum about the OTR MWs - just be ready for lots of negativity towards them! I have given up on the search provided by this website - use google. You can specify the site to google if you want by using this:

over range microwave site:www.thathomesite.com

Also try site:ths.gardenweb.com I don't know why there are two websites to search, but I always get some different results with the two different site searches.

Good luck! BTW, we are getting an Advantium 120, should be installed in 2 or 3 weeks.
Related Discussions
Changing out over range microwave for range hood
Q
Comments (5)
Nadine--I think those slide out hoods are going to require a lot of the space in the cabinet above so you're going to lose that space anyway. So you might want to consider a more conventional undercabinet hood, too. Depending on your situation, you may be able to vent directly out the back of hood into your existing vent and not lose any of the cabinet space. It won't be quite as accessible though as you realize. I'm assuming that your rectangular vent is 3.25 x 10" which is roughly equivalent to a six inch round duct. So you need to look at hoods with CFM's sized for that size of duct. Unless you know exactly how your vent is situated, you need to remove the microwave. A lot of hoods will be adaptable to horizontal rectangular, vertical rectangular vent and vertical round exhaust. I know that my Zephyr hood had all three options. Zephyr Typhoon I disagree that you will get 'tremendous' noise. Not going to be whisper quiet but will most likely be substantially less noisy than most micro hoods. Here is a link that might be useful: Slide out range hood
...See More
Quiet and effective Range Hood?
Q
Comments (5)
The Fantech duct silencer mentioned by kas does a great job of reducing noise from the remotely mounted (on roof, or in attic) motor/blower. You will not get away from the noise of air flow though the hood baffles/screen, but blower noise will be pretty much gone. If you are in a cold-weather area, or have gravity gas appliances (old fashioned water heater or furnace, for example) in the heated envelope or fireplaces, you need to understand the makeup air issue. The concern is that you don't want to back-draft your chimneys/exhaust ducts with a large fan in a well sealed house. Colder regions tend to have codes restricting the capacity of exhaust fans, above which you have to provide "make-up air" from outside. From a practical viewpoint, you can just open a window when using the fan at full blast, but regulations will not allow that. Here in San Jose, the two largest fans (hood, bathroom) combined cannot exceed 15CFM per 100 sq ft of house size without makeup air, if there are any gravity devices -- so I moved my water heater to a closet sealed from the house/vented to the outside, and my furnace to the vented attic.
...See More
Which style exhaust hood (insert, undercab, chimney is most effective?
Q
Comments (15)
What type of cooking do you do? Lots of grease? Lots of onions and garlic? Lots of deep frying? I've had downdrafts, custom hood with insert, regular over the stove microwave with direct vent to outdoors (outside wall) over a 30" gas stove. The Micro over stove directly vented to outdoors worked great (micro over stove not my favorite). The downdraft JennAir with grill and downdraft worked great. The custom hood with insert was my favorite aesthetically, and vented through the roof and worked fine. I don't fry a lot of foods (less as time goes on), virtually never deep fry, and use lids a lot because I don't think anything keeps the smell of frying onions contained (just my opinion). Downdrafts seems to get a lot of pushback but the one I had was terrific. I think you can have reasonable aesthetics, reasonable cost, and reasonable effectiveness :) though perhaps not great :) But though we cook a lot (if guessing, I'd say more than 85% of the population) and microwave very little, I have never felt the need for super-high power and I don't like lingering odors. If I were doing a new kitchen, I'd do a downdraft because I really lean towards clean lines and more modern interiors. So, the bottom line I think is to consider how you cook, and if you cook lots and lots of greasy and odiferous foods on a daily basis, super high power performance might outweigh anything else.
...See More
Kitchen range hood exhaust duct through second floor to attic?
Q
Comments (4)
Howdy, sorry for not responding sooner. I guess I'm not configured to forward the email notices. In regards to opaone's comments: Not sure what you might mean by a "real hood", but if it's a restaurant quality super duper hood - then no. The kitchen is tiny and unless I blow out an exterior wall it'll stay that way. The current hood is a standard 30" affair; it's only redeeming qualities are the nifty LEDs I installed and the 7" exhaust going out the top. The presence of so many 90° bends is exactly why I'd like to make a direct shot to the roof. What a horrid design! In regards to Austin Air's comments: The 5" space will easily fit the 11" x 3" oval (6" equivalent) duct I was planning on using. The furnace space is sealed and takes its make-up/combustion air from vents leading to the attic, which is ventilated through soffit vents and a large roof-mounted mushroom. Kitchen make-up air is currently not too much of an issue as the house is a "leaker" - I have yet to replace all the aluminium windows and sliders, but will surely install a vent/control/device to address make-up if/when I go with the through-the-roof range vent. What I'm leaning towards now, after posting this and asking around, is having my furnace replaced before doing the modification. I don't want to go through the work and then have Mr./Mrs./Ms. City Inspector Man/Woman/Person question the duct passing through the furnace closet. Another advantage would be the additional physical space gained by replacing the 1970s dinosaur-air-heater with a modern high-efficiency unit. They're so small now!! If I had me a moneytree, I'd plop a horizontal unit in the attic and solve all kinds of issues.
...See More
totallyconfused
13 years ago
We had to get a recirculating one because of the way the plumbing went through that wall. It's useless as a fan and the light isn't worth a darn either. I wish I had installed one more recessed light. On the other hand, the thing isn't taking up valuable counter space, so I guess it's all a trade-off. I just need to remember to open windows when I broil BEFORE the smoke alarm goes off.

Totally Confused
svwillow1
13 years ago
When it came time to remodel we faced the same dilemma. In our small kitchen, we did not want the microwave on the counter, but also wanted a real exhaust fan. Because we mostly use the microwave for reheating or defrosting, we hid a small one in a 16" deep upper cabinet, and then installed a 600 CFM exhaust hood, 3 speed, vented out side, and with good lighting over the stove. Works great for us.

Microwave range exhaust hood effectiveness?

Comments (4)

Buehl

pudgybaby

Related Discussions

totallyconfused

svwillow1

COMPANY

BUSINESS SERVICES

GET HELP

CONNECT WITH US